High Voltage

Papers
(The TQCC of High Voltage is 9. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-01-01 to 2026-01-01.)
ArticleCitations
Observation and verification of surface electrical explosion driven by radial‐distributed pulsed current in laboratory lightning strike test179
99
Detection of micro‐water in transformer oil based on ultrasonic pulse‐echo method and sparrow search algorithm‐random forest77
A new type of lipophilic hydrophobic self‐repairing cellulose insulating paper developed with ST‐110/FAS/PTFE ternary system as coating substrate68
Accelerated thermal ageing on performance of polypropylene‐based semiconducting screen for high voltage direct current cable applications—Effect of antioxidants67
Modelling and analysis of transformers considering ultra‐wide band frequency‐dependent parameters for high altitude electromagnetic pulse55
Improve the insulation performance of air‐insulated gaps: Application of polyurea materials on the ground potential side of transmission line54
Wetting characteristics of the hydrophobic material surface through condensation45
Time–frequency characteristics and influencing factors of the pressure wave caused by power–frequency arc inside a closed oil tank43
SF 6 catalytic degradation in a γ‐Al 2 O 3 pack41
Electromagnetic anisotropic homogeneous model for eddy‐current field in single‐phase wound core39
Broadband impedance spectrum detection of buffer layer defects in 110 kV crosslinked polyethylene cable with corrugated aluminium sheath39
Study on thermal cycling ageing resistance of performances of polypropylene/elastomer/boron nitride nanocomposites for high voltage direct current cable insulation38
Significantly enhanced flashover voltage of epoxy in vacuum by graded surface roughness modification37
The SYNTHIDIA Dataset: Synthetic Insulator Defect Imaging and Annotation37
Detection of Transient Decomposition Products of CF 3 SO 2 F and C 435
Optical Imaging‐Based 3D Reconstruction of Electrical Tree in Polypropylene Cable Insulation Under Mechanical Bending34
Experimental study on dynamic response characteristics of isolated‐span transmission lines after ice‐shedding33
Electrohydraulic effect of microsecond pulsed discharge in transformer oils31
Influence of thermal ageing on high‐field polarisation characteristics and conductivity behaviour of submarine polymeric cables insulation31
Ag‐doped Ti 3 C 2 T x sensor: A promising candi31
The relationship between power of arc discharge in transformer oil and peak value of the shock wave29
Acoustic carrier signal transmission technology and its potential for in‐site monitoring of sliding electrical contact used in gas‐insulated switchgear/gas‐insulated transmission line29
Decomposition mechanism of environmentally friendly insulating medium HFO1234zeE/N 2 gas mixture under partial discharge28
Polypropylene Insulation Failure Model Modification Based on Space Charge and Trap Parameters28
Study on the Aggregation Structure and DC Conductivity and Breakdown Characteristics of Polypropylene Insulation for HVDC Cables28
Improved demodulation method for fibre optic sensors applied in transformer partial discharge detection26
Active disturbance rejection distributed secondary control for DC microgrids26
High‐strength, electrically insulated industrial meta‐aramid paper reinforced with polyethylene terephthalate microfibre pulp in a sandwich structure26
A new approach to the design of surface subsystems of polymeric insulators for HV and MV apparatus under AC voltage26
Evaluation of Moisture Ageing Status of Cross‐Linked Polyethylene Insulation in Power Cables at Different Temperatures25
Design of a high‐frequency transformer based on amorphous cut cores for insulation breakdown testing25
Research of cycloaliphatic epoxy resin and silicone rubber composite insulator interface based on four‐electrode system and temperature rise model25
Influence of micro‐water on AC breakdown characteristics of C 4 F 7 N/CO 24
Inhibiting liquid permeation into silicone rubber by superhydrophobic coating for prolonged service life24
Significantly enhanced DC breakdown strength and high‐temperature resistivity of cross‐linked polyethylene through alloying polystyrene strategy23
Insulation degradation and fracture cracks of mechanical impacted thermal‐ageing oil‐impregnated papers23
Lightning‐Induced Overvoltage on Overhead Distribution Line via Hybrid MTL‐PEEC Method22
Charge transport mechanism of cross‐linked polyethylene/silicone rubber composite insulation by energy band theory22
Partial Discharge Detection Method of Fibre‐Composed HVDC Submarine Cable Based on φ ‐OTDR and Hilbert Demodulation22
Global model of plasma‐activated water over long time scale: Pulsed discharge and afterglow21
Dissolved gas analysis and dissipation factor measurement of mineral oil‐based nanofluids under thermal and electrical faults21
Study on the Impact of Contamination Containing High Proportions of Metals on the AC Flashover Characteristics of Insulators20
Transient electric field of the combined insulation structure under positive periodic square waveform voltage: Analytical analysis and application20
Guest Editorial: Understanding low temperature plasmas for device reliability, modulation and application to green energy strategy19
Interface Engineering for Synergistic Achievement of Enhanced Thermal Conductivity and Suppressed Dielectric Loss of Epoxy/Boron Nitride Composite19
Detection of trace CF 4 in C 4 F 7 N‐insulated 19
Multi‐objective optimal design for AC filters in high voltage direct current system based on improved multi‐objective evolutionary algorithm based on decomposition18
Mechanical vibration state and its defect severity development trend prediction for gas‐insulated switchgear equipment: Attention‐bidirectional gated recurrent unit model construction and experimental18
Stress analysis and structural optimisation of insulating rods under dynamic and static loads18
An analysis of parameters affecting ampacity in aircraft bipolar MVDC power cables via coupled electrical, thermal, and computational fluid dynamic modelling18
Intelligent model prediction of fluctuant increase of maximum electric field in XLPE insulation using long short‐term memory network algorithm17
Effect of gamma‐ray irradiation on electrical conductivity of polypropylene composite for nuclear cable insulation17
Insulating materials for realising carbon neutrality: Opportunities, remaining issues and challenges17
High voltage direct current transmission cables to help decarbonisation in Europe: Recent achievements and issues17
Adsorption properties of environmentally friendly insulating medium C 4 F 7 N and its common decom17
Fast evaluation on the fatigue level of copper contact wire based on laser induced breakdown spectroscopy and supervised machine learning for high speed railway17
Revealing phase transitions and instabilities in pseudospark discharges17
The Surface Potential Restoration Algorithm of Electrostatic Capacitance Probe During On‐Line Measurement17
An experimental proof of concept of time‐reversal single‐sensor acoustic source localisation: Application to partial discharges17
Design and 3D Printing of Ceramic Insulation for Surface Flashover Mitigation in Vacuum17
Additive Interaction Effect on High‐Temperature Stability of XLPE Insulation for High‐Voltage Cables17
Structural characteristics of electrohydrodynamic jets induced by a blade‐plane actuator subjected to highly non‐uniform electric fields: Parametric investigation through the particle image velocimetr17
Analysis of vibration evolution and propagation characteristics due to mechanical degradation in transformer iron cores17
Decay‐like fracture diagnosis of composite insulator based on small sample virtual expansion and radar graph mapping16
Mesh‐Based Charge Simulation Method and Its Applications to Electrostatic Electric Field Computation16
16
Technique for Order Preference by Similarity to an Ideal Solution‐based comprehensive health assessment of composite insulators for overhead transmission lines15
3D electromagnetic modelling for high‐temperature superconducting dynamo flux pumps using T‐A formulation15
A passive optical fibre sensor based on Fabry‐Perot interferometry for bipolar electrostatic monitoring of insulating dielectrics15
A novel current‐source management integrated circuit applied to high‐voltage integrated gate commutated thyristor gate driver15
Detection of characteristic component H 2 S in SF 6 and SF 6 15
Enhancing dielectric properties and energy storage performance of polyvinylidene fluoride composite by surface‐modified AgNbO 3 nanoparticles15
Effect of matrix resin components on properties of the semi‐conductive shielding material for high‐voltage cable15
15
Self‐adaptive electrostatic discharge performance of ZnO microvaristors doped silicone rubber composites15
Evaluation of lightning‐induced overvoltage on a 10 kV distribution line based on electromagnetic return‐stroke model using finite‐difference time‐domain15
Analyses on an electronic voltage transformer's failure by its resonance with very fast transient overvoltage and suppression14
Analysis and suppression of voltage oscillation at DC circuit breaker terminal in DC fault transient process14
13
13
Fast electrothermal coupling calculation method for supporting digital twin construction of electrical equipment13
Model moisture transport in oil‐paper insulation of transformer: Theory and experiment13
Residual charge effects on partial discharges' response to varying sub‐kHz voltage frequencies13
Dielectric response—A nondestructive approach to probing the micro‐interface of aluminium hydroxide filled silicone rubber composites for outdoor insulation13
Anomalous‐Energy Runaway Electrons Originating in Fast Ionisation Wave During Pulsed Gas Breakdown13
Model‐Aided State Parameter Inversion Identification of Electromagnetic Trip Device for High Voltage Circuit Breakers13
Analysis for magnetic field disturbance of modular multilevel converter based high voltage direct current (MMC‐HVDC) converter valve13
Microwave diagnostics of pulsed atmospheric discharge with electrolytic electrode and long‐lived luminous formation in its afterglow13
Temperature rise characteristics of C 5 F 10 O/CO 2 13
Experimental and numerical study on atmospheric‐pressure air dielectric barrier discharge via 50 Hz/5000 Hz dual‐frequency excitation13
Effects of Exposure to Radiation and Steam on Silicone Rubber Cables Removed From a Nuclear Power Plant13
Dynamics of an impurity ion transport in oil‐paper insulation under various electric fields13
Thermofluidic investigations of oil natural transformer: Closed‐loop modelling and experimental validation13
Development of a field‐programmable gate array‐based real‐time generic solver for power electronics circuits with arbitrary configurations13
The impact of diatomaceous earth on hydrophobicity transfer characteristics13
Converter station selection method of urban VSC‐DC intertie for grid resilience enhancement12
Analysis of conductance and interfacial polarisation behaviours of silicone rubber based on frequency domain spectroscopy12
Electric field control by permittivity functionally graded and superficially non‐linear conductivity materials for DC‐GIS spacer12
Curing kinetics and residual stress modelling of gas‐insulated transmission lines tri‐post insulators12
Effect of SiO 2 nano film deposited on copper and aluminium electrodes on the power frequency breakdown voltage of SF 612
Observation of an upward lightning flash with 21 upward positive leaders initiated from different wind turbines in wind farm12
Experimental and simulation study on luminous characteristics of Trichel discharge in air at picosecond time resolution12
Effect of solid particle type, concentration and size on DC breakdown voltage of short needle‐plate air gap: An experiment and simulation study12
Theoretical connection from the dielectric constant of films to the capacitance of capacitors under high temperature12
Revitalising high voltage cable: Exploring effective repair methods and influential factors for buffer layer defects using conductive silicone rubber12
Preparation and performance improvement of a dual‐component microcapsule self‐healing system for silicone rubber insulating material11
Influence analysis of calculated horizontally layered soil parameters on grounding parameters11
The Diverse Behaviours of Discharged Degradation at Varied Interfaces of Silicone Gel/Ceramic Substrates Under High‐Frequency Square Wave Voltage11
Research on digital twin modelling technique for ±800 kV converter transformers scene based on hybrid attention mechanism and multiresolution hash encoding11
Moisture dynamics during high‐load fluctuations in transformers: Localised accumulation and interfacial transfer within oil/pressboard insulation11
Improved high‐temperature electrical properties of polypropylene insulation material by grafting styrene11
Microcosmic mechanism and correction of moisture effect on furfural diffusion and equilibrium in oil‐paper insulation11
Fast Calculation of Transformer Hot Spot Temperature Based on Winding Equivalent Thermal Parameters11
Dynamic ageing research of cross‐linked polyethylene cable insulation based on temporal‐spatial dimension under combined electro‐thermal effect11
Non‐linear electrical conductivity of ethylene‐propylene‐diene monomer‐based composite dielectrics by tuning inorganic fillers11
11
Properties of diffuse and volume discharges that are important for their applications11
Investigation of impact of DC component on breakdown characteristics for different electric fields under composite AC & DC voltage10
Guest Editorial: Special issue on real‐time simulation and validation of modular multilevel converter‐based high‐voltage direct current systems10
10
Comparative studies of C 4 F 7 N‐based gas mixtures as the eco‐friendly alternative to SF 10
A novel thyristor‐based hybrid DC circuit breaker with short arcing capability10
DC allowable electric field strength for naphthenic‐based and paraffin‐based transformer oils10
Recent applications in dielectric barrier discharge and radio frequency plasmas‐engineered transition metal electrocatalysts for water splitting9
Flexible composite suppression method for ground arc in resonant grounding system9
BCM‐YOLO: An improved YOLOv8‐based lightweight porcelain insulator defect detection model9
Experimental qualification and sensitivity study of antipodal patch antenna structures for orientation independent detection of partial discharges9
Experiment of electrothermal stress for different types of end turn grading in the inverter‐fed form‐wound windings9
Cumulative degradation of electrical properties in polypropylene insulation for AC cables under repeated impulse voltage stress9
Difference analysis of dissolved gas in natural ester insulating fluids under typical electrical and thermal faults: An experimental study9
Effect of organophilic group of coupling agent on the electrical performance of Boron Nitride/meta‐aramid composite paper9
Analysis of SF 6 decomposed products by fibre‐enhanced Raman spectroscopy for gas‐insulated switchgear diagnosis9
Shape optimisation of basin insulator for DC gas insulated switchgear/gas insulated transmission lines based on artificial bee colony algorithm9
Gas production analysis for the buffer layer of high‐voltage cross‐linked polyethylene cables9
Thermal Conductive Network Construction and Enhanced Thermal Conductivity in Mica Tape Composites for Large Generators by Pre‐Placed h‐BN@PDA‐Modified Mica Paper9
Energy harvesting technology for AC overhead insulated transmission line based on electric field induction9
Electrical tree degradation of MgO/epoxy resin composites at different voltage frequencies9
Preparation of a novel cross‐linked polyetherimide with enhanced breakdown strength and high‐temperature energy storage performance9
Erratum: Octavinyl polyhedral oligomeric silsesquioxane on tailoring the DC electrical characteristics of polypropylene9
Accumulation characteristics of precipitation static on rotating wind turbine blades and its influence on the lightning attachment characteristics9
Guest Editorial: Research Progress and Technology Development of HVDC Cable: Part I9
The Partial Discharge Characteristics of Inner Air Gap Inside High‐Voltage Cable Termination for High‐Speed Trains9
0.080083131790161