Journal of Asian Ceramic Societies

Papers
(The H4-Index of Journal of Asian Ceramic Societies is 19. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-04-01 to 2024-04-01.)
ArticleCitations
Sustainable ceramics derived from solid wastes: a review49
Hydroxyapatite for bone related applications derived from sea shell waste by simpleprecipitation method41
Effects of surfactants/stabilizing agents on the microstructure and properties of porous geopolymers by direct foaming32
Comparing electrochemical behavior of applied CrN/TiN nanoscale multilayer and TiN single-layer coatings deposited by CAE-PVD method29
Methods and synthesis parameters affecting the formation of FAU type zeolite membrane and its separation performance: a review28
Tailoring the magnetic properties of M-type strontium ferrite with synergistic effect of co-substitution and calcinations temperature27
Structural and Optical Coefficients Investigation of γ-Al2O3 Nanoparticles using Kramers-Kronig Relations and Z–scan Technique27
Flat-tubular solid oxide fuel cells and stacks: a review26
Structure and corrosion behavior of ZrN/CrN nano-multilayer coating deposited on AISI 304 stainless steel by CAE-PVD technique25
Low-cost ultra-sensitive SnO2-based ammonia sensor synthesized by hydrothermal method25
Enhanced photocatalytic hydrogen evolution by novel Nb-doped SnO2/V2O5 heteronanostructures under visible light with simultaneous basic red 46 dye degradation25
Pulsed electrodeposition of Ni-B/TiN composites: effect of current density on the structure, mechanical, tribological, and corrosion properties23
Dielectric spectroscopy of PVA-Ni0.5Zn0.5Fe2O4 polymer nanocomposite films23
Fabrication and evaluation of tribological properties of Al2O3 coated Ag reinforced copper matrix nanocomposite by mechanical alloying23
Effects of load on tribological properties of B4C and B4C-SiC ceramics sliding against SiC balls22
Porous carbonated hydroxyapatite-based scaffold using simple gas foaming method22
A review on porous ceramics with hierarchical pore structure by 3D printing-based combined route21
Effect of additive content on the mechanical and thermal properties of pressureless liquid-phase sintered SiC20
Effect of ZnO nanoparticles addition to PEO coatings on AZ31B Mg alloy: antibacterial effect and corrosion behavior of coatings in Ringer’s physiological solution20
A facile approach to synthesis of silica nanoparticles from silica sand and their application as superhydrophobic material19
Pulse electro co-deposition of submicron-sized TiC reinforced Ni–W coatings: tribological and corrosion properties19
0.11132001876831