OOIR: Observatory of International Research

Papers

(The H4-Index of Materials Research Letters is 30. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-04-01 to 2025-04-01.)

Article	Citations
Achieving superior wear resistance on titanium alloy via large-span heterostructured coatings	362
Rapid precipitation of L1 ₂ phase in Al _0.5 CoCrFeNi high-entropy alloy under electropulsing	104
Enhancing shape recoverable ratio in (Ni _50.1 Ti _34.9 Hf ₁₅ ) ₈₅	94
Enhancing dynamic property in additive manufactured IN738LC alloy through cell orientation control	69
Hardening mechanism and plastic deformation behavior in super-hard AlCrNbSiTiN high-entropy nitride nanocomposite coatings	65
Polycrystalline Fe ₈₁ Ga ₁₉ alloy with magnetostriction comparable single-crystals prepared via laser powder bed fusion in-situ re	65
Ultra-strong and strain-hardenable ultrafine-grained medium-entropy alloy via enhanced grain-boundary strengthening	62
Simultaneously improving mechanical and magnetic properties through heterogeneous lamella structures in a superalloy-like, soft magnetic complex concentrated alloy	54
Arc-based directed energy deposited Inconel 718: role of heat treatments on high-temperature tensile behavior	53
Thermal conductivity reduction in (Zr_0.25Ta_0.25Nb_0.25Ti_0.25)C high entropy carbide from extrinsic lattice defects	51
Telltale diamagnetism at 50 K of a coordination polymer system	50
Thermal stability studies of alternating current poled Pb(Mg_1/3Nb_2/3)O₃-PbTiO₃ single crystals grown by solid-state crystal growth	48
Electropulses induced direct aging and ultrafast precipitation in additive manufactured 15-5 PH stainless steel	43
A transforming interpenetrating-phase cermet with high strength and energy dissipation capacity	42
Observation of dynamical transformation plasticity in metallic nanocomposites through a precompiled machine-learning algorithm	42
Designing hard, low-refractive-index lossy materials for super wear-resistant absorbers	41
Formation of p-n⁺diamond homojunctions by shallow doping of phosphorus through liquid emersion excimer laser irradiation	40
Improved creep properties of Inconel 718 fabricated by selective laser melting from boron-phosphorus interaction	37
High entropy oxide (Co,Cu,Mg,Ni,Zn)O exhibits grain size dependent room temperature deformation	37
Ultrahigh strength triggered by BCC and B2 eutectic-phase interfaces in a novel FeCrVNiAl high-entropy alloy	35
Eliminate the contradiction between temperature and toughness by grain-boundary delamination in heterogeneous ultrafine-grained lamellar steels	35
Cocoon-shaped hollow mesoporous silica ellipsoids controlled by interfacial destabilization growth kinetics	34
Rapid dislocation-mediated solute repartitioning towards strain-aging hardening in a fine-grained dilute magnesium alloy	34
Probing the effect of intragranular premature κ-carbide on incipient plasticity behavior in austenite-based Fe-Mn-Al-(Cr)-C steels	33
High-temperature creep-induced site occupation evolution in the γ′ lattice in a Ru-bearing Ni-based superalloy	33

Nanostructural and piezoelectric characterization of electro-formed δ-phase poly(vinylidene fluoride) thin films	32
Spintronic materials and devices towards an artificial neural network: accomplishments and the last mile	32
Improvement of soft-magnetic properties for Fe-based amorphous alloys with high saturation polarization by stress annealing	32
Fe₂C- and Mn₂(W/Mo)B₄-based rare-earth-free permanent magnets as a result of the high-throughput and data-mining search	31
Columnar grain width control for SS316L via hatch spacing manipulation in laser powder bed fusion	31
Decoupling atomic diffusion degeneracy in L1 ₂ intermetallics	30