OOIR: Observatory of International Research

Papers

(The H4-Index of Micromachines is 65. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)

Article	Citations
A Novel Algorithm for Scenario Recognition Based on MEMS Sensors of Smartphone	240
Investigating a Detection Method for Viruses and Pathogens Using a Dual-Microcantilever Sensor	229
An Overview of Substrate Copper Trace Crack Through Experiments, Characterization, and Numerical Simulations	209
Impedance Iterative Learning Backstepping Control for Output-Constrained Multisection Continuum Arms Based on PMA	187
Range Expansion Technology for Ring MEMS Gyroscopes Based on Drive Voltage Modulation	167
Ultrafast Temporal-Spatial Dynamics of Phase Transition in N-Doped Ge2Sb2Te5 Film Induced by Femtosecond Laser Pulse Irradiation	165
An Assessment of Local Geometric Uncertainties in Polysilicon MEMS: A Genetic Algorithm and POD-Kriging Surrogate Modeling Approach	158
Scalable Additive Construction of Arrayed Microstructures with Encoded Properties for Bioimaging	158
Editorial for the Special Issue on Nanostructured Surfaces and Devices for Biomedical Applications	148
Wavefront Characteristics of a Digital Holographic Optical Element	148
A False Trigger-Strengthened and Area-Saving Power-Rail Clamp Circuit with High ESD Performance	141
Valveless On-Chip Aliquoting for Molecular Diagnosis	136
Simulation Studies on Single-Event Effects and the Mechanisms of SiC VDMOS from a Structural Perspective	133
Study on the Carrier Transport Process in Deep Ultraviolet Light-Emitting Diodes with Al-Content-Varied AlGaN Composite Last Quantum Barrier	132
Silicon-on-Insulator (SOI) Lateral Power-Reduced Surface Field FinFET with High-Power Figure of Merit of 239.3 MW/cm2	130
Numerical Simulation of Thermal Fields and Microstructure Evolution in SLM of Fe32Cr33Ni29Al3Ti3 Alloy	130
A X-Band Integrated Passive Device Structure Based on TMV-Embedded FOWLP	129
Novel Throat-Attached Piezoelectric Sensors Based on Adam-Optimized Deep Belief Networks	117
A Defect Detection Algorithm for Optoelectronic Detectors Utilizing GLV-YOLO	116
Glass Microbubble Encapsulation for Improving the Lifetime of a Ferrofluid-Based Magnetometer	115
Performing MHz-Level Repetition Rate Tuning for Coherent Dual-Microcomb Interferometry	113
A Review on Micro-Watts All-Digital Frequency Synthesizers	112
A Quad-Band Highly Selective Frequency Selective Surface with Ultra-Wideband Rejection	111
Backpropagation Neural Network-Based Prediction Model of Marble Surface Quality Cut by Diamond Wire Saw	111
Importance of Spatial Arrangement of Cardiomyocyte Network for Precise and Stable On-Chip Predictive Cardiotoxicity Measurement	107

Intelligent Genetic Decoding System Based on Nucleic Acid Isothermal Amplification for Non-Small Cell Lung Cancer Diagnosis	107
Preconcentration of Fluorescent Dyes in Electromembrane Systems via Electrophoretic Migration	105
Editorial for the Special Issue on the Latest Advancements in Semiconductor Materials, Devices and Systems	105
Ferroelectric Domain Modulation with Tip-Poling Engineering in BiFeO3 Films	101
Novel Weft-Knitted Strain Sensors for Motion Capture	97
Editorial for the Special Issue on Nanomaterials for Micro/Nanodevices	97
Surface Modification of Heterojunction with Intrinsic Thin Layer Solar Cell Electrode with Organosilane	97
Developing a Real-Time Working Method That Improves Process Efficiency in High-Power Fiber Laser Systems	96
Novel Technique to Increase the Effective Workspace of a Soft Robot	96
An Improved Cubature Kalman Filter for GNSS-Denied and System-Noise-Varying INS/GNSS Navigation	86
Modular Flow Synthesis of Citric Acid-Coated Superparamagnetic Iron Oxide Nanoparticles: Preliminary Results	86
A 14-Bit, 12 V-to-100 V Voltage Compliance Electrical Stimulator with Redundant Digital Calibration	85
Student’s t-Distributed Extended Kalman Filter with Switch Factor for UWB Localization Under Colored Measurement Noise	85
Metasurfaces Assisted Twisted α-MoO3 for Spinning Thermal Radiation	84
Numerical Investigation of Non-Newtonian Fluid Rheology in a T-Shaped Microfluidics Channel Integrated with Complex Micropillar Structures Under Acoustic, Electric, and Magnetic Fields	83
An Exploratory Study of Laser Scribing Quality through Cross-Section Scribing Profiles	82
Hierarchical Micro/Nanostructures with Anti-Reflection and Superhydrophobicity on the Silicon Surface Fabricated by Femtosecond Laser	82
Internal Temperature Measurement of Optically Levitated Particles in Vacuum by Raman Thermometry	82
Mechanical Response of MEMS Suspended Inductors under Shock Using the Transfer Matrix Method	80
Investigation on Aluminum Alloy Reflector Mirror Processing Technology Combining Ultrasonic Rolling and Single-Point Diamond Turning	78
Cu-Cu Thermocompression Bonding with a Self-Assembled Monolayer as Oxidation Protection for 3D/2.5D System Integration	78
A Novel Method to Detect Partial Shadow Effects in Perovskite-Based Simulated Solar Cell System Faults	77
A Wire Bow Model of Diamond Wire Sawing with Asymmetric Arc Hypothesis	75
A Substructure Condensed Approach for Kinetostatic Modeling of Compliant Mechanisms with Complex Topology	74
Checkerboard Helmholtz Resonator Metasurface for Dual-Mode Decoupled Dual-Band Coherent Perfect Absorption with Independently Tunable Frequencies	74
Performance Analysis and Optimization of an InGaAs/GaAsSb Heterojunction Dopingless Tunnel FET with a Heterogate Dielectric	73
A Study on Regulating the Residual Stress of Electroplated Cu by Manipulating the Nanotwin Directions	73
Rao-Blackwellized Particle Filter Algorithm Integrated with Neural Network Sensor Model Using Laser Distance Sensor	72
The Development and Progress of the UWB Physical Layer	72
Study on Electrical Characteristics and ECG Signal Acquisition Performance of Fabric Electrodes Based on Organizational Structure and Wearing Pressure	72
Microgrooves with Small Taper Angle Processed by Nanosecond Laser in Closed Flowing Water	72
Design and Application of a Flexible Blood Oxygen Sensing Array for Wearable Devices	71
Investigation on Thermally Radiative Mixed Convective Flow of Carbon Nanotubes/Al2O3 Nanofluid in Water Past a Stretching Plate with Joule Heating and Viscous Dissipation	71
A Study on the Sub-5 nm Nano-Step Height Reference Materials Fabricated by Atomic Layer Deposition Combined with Wet Etching	71
High Spectrum Efficiency and High Security Radio-Over-Fiber Systems with Compressive-Sensing-Based Chaotic Encryption	69
Configuration Synthesis and Performance Analysis of 1T2R Decoupled Wheel-Legged Reconfigurable Mechanism	69
RETRACTED: Barbillon, G. Plasmonic Nanostructures Prepared by Soft UV Nanoimprint Lithography and Their Application in Biological Sensing. Micromachines 2012, 3, 21–27	69
Fabricating Air Pressure Sensors in Hollow-Core Fiber Using Femtosecond Laser Pulse	68
Surface Modification of 3D Printed Microfluidic Devices for Controlled Wetting in Two-Phase Flow	67
Investigation of the Combined Effect of Total Ionizing Dose and Time-Dependent Dielectric Breakdown on PDSOI Devices	65
Unconventional Rashba Spin-Orbit Coupling on the Charge Conductance and Spin Polarization of a Ferromagnetic/Insulator/Ferromagnetic Rashba Metal Junction	65
Electronic Structure and Transport Properties of Bi2Te3 and Bi2Se3 Single Crystals	65
Periodic Structural Defects in Graphene Sheets Engineered via Electron Irradiation	65