OOIR: Observatory of International Research

Papers

(The median citation count of Journal of Thermal Science and Technology is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-11-01 to 2024-11-01.)

Article	Citations
Ni-GDC and Ni-YSZ electrodes operated in solid oxide electrolysis and fuel cell modes	40
Heat transfer enhancement and torque reduction by traveling wave-like blowing and suction in turbulent Taylor-Couette flow	9
Effects of pressure and heat loss on the unstable motion of cellular-flame fronts caused by intrinsic instability in hydrogen-air lean premixed flames	9
OH chemiluminescence of methane-hydrogen premixed flames	9
The effects of addition of carbon dioxide and water vapor on the dynamic behavior of spherically expanding hydrogen/air premixed flames	7
Temperature measurement around multiple boiling bubbles in a confined space using two-color laser-induced fluorescence	7
Explainable machine learning for the analysis of transport phenomena in top-seeded solution growth of SiC single crystal	7
Machine learning-based prediction of heat transport performance in oscillating heat pipe	6
Experimental analysis of the spreading of a liquid film on a bipropellant thruster chamber wall	6
A study on transition process to MEB by limiting boiling space	5
Multi-objective optimization of multi-stage heat sink of electric aircraft using three-dimensional thermal network analysis	5
Describing characteristic parameters of turbulence over two-dimensional porous roughness	5
Quantitative analysis of primary tar yields volatilized from biomass (Effect of heating rate and biomass type on tar components)	5
Effect of aluminum particle size on agglomeration size and burning rate of composite propellant	4
Effect of spatial development on convective heat transfer enhancement in a pipe with transverse vibration	4
Simultaneous in situ measurements and numerical analysis of mass transfer in polymer electrolyte fuel cell electrode slurries during drying	4
Hydrogen production by solar fluidized bed reactor using ceria: Euler-Lagrange modelling of gas-solid flow to optimize the internally circulating fluidized bed	4
Numerical simulation of methane-hydrogen premixed flames on a Bunsen burner	4
Enhancement of knocking detection accuracy by an ion-current sensor integrated in the ignition system	4
Conjugate radiation-convection-conduction simulation of cubic lattice solar receiver with high porosity for high-temperature heat absorption	4
Effect of the gap height between the vibration plate and heating surface on boiling heat transfer in a boiling bubble resonator	4
Analysis and control of vapor bubble growth inside solid-state nanopores	4
MILD combustion of ethanol-air with diluted hot oxidant by recirculation in opposite jet	3
Airside heat transfer and pressure drop of an aluminum heat exchanger having a new louver fin with leading edge extension	3
Thermal performance investigation of a plate fin heat sink equipped with twisted tape and perforated twisted tape	3

Modeling and simulation of the discharge process of isothermal chamber to determine the isothermal characteristic	3
Generalized heating value estimation of torrefied woody biomass based on pyrolysis kinetics of primary constituent polymers	3
Effect of fuel property on the ignition and combustion characteristics of prechamber ignition	3
Quantitative OH concentration measurement using OH(2,0) band bi-directional LIF method for high-pressure and high-temperature symmetrical flames	3
Effect of shear-thinning behavior on interface renewal in partially filled single rotor mixing	3
Optimal structure of a water cooled pin fin heat sink by Taguchi method depending on various requirements	3
Effects of dielectric-barrier-discharge plasma on soot and NOx in diffusion flame	3
Refractive index and mole fraction field of the vapor evaporated from ethanol-water mixture droplet	2
Tar generation and decomposition in downdraft packed bed reactor for woody biomass gasification	2
Experimental study on heat transfer enhancement in subcooled flow boiling under pressurized conditions	2
Reciprocating propagation of premixed flame using time-variable-angle swirl vanes	2
Experimental analysis on micro diffusion flames formed by oxygen combustion of H<sub>2</sub>-CO<sub>2</sub> mixture using counterflow burners	2
Correlation of OH fluorescence and OH chemiluminescence with burning velocity of methane-hydrogen premixed flames	2
Transient thermal performance of constant fill ratio vapor chamber with different coolants	2
Numerical investigation on performance improvement of CaSO<sub>4</sub> solar chemical heat pump	2
Mathematical study on the thickened interface model by viscosity solution of the level-set equation	2
Role of combustion derived magnesia nanoflakes on the combustion, emission and functional characteristics of diesel engine susceptible to palm oil biodiesel-diesel blend	2
Effect of change factors on evaporation loss based on cold end system in natural draft counter-flow wet cooling towers	2
Direct spray combustion in a tubular flame burner toward fine particle synthesis	2
Effects of ambient temperature on the combustion processes of single pulverized coal particle	2
Numerical simulation on the freezing of deposited or impinged water droplets on a cold surface	1
Fundamental study on thermoradiative energy conversion for space applications	1
Fluidization behavior of redox metal oxide and spinel particles to develop high-energy-density thermal energy storage system for concentrated solar power applications	1
The shape and fluctuation of hydrogen-propane-butane-air lean premixed flames formed on a flat flame burner	1
Effects of considering preferential diffusion and flame stretch in FGM method for numerical simulations of hydrogen/air flames	1
Experimental investigation of burning characteristics of porous combustible soaked in liquid oxidizer	1
A model to predict coil temperature evolution during the whole thermal cycle process of ladle with a novel steel teeming technology	1
Improvement of isothermal characteristic of isothermal chamber by filling with graded copper foam	1
Effects of hydrogen addition and turbulence on ignition and meso-scale flames of propane mixtures	1
Retraction: Process of liquid supply to heated surface by a honeycomb porous plate for critical heat flux enhancement	1
Performance improvement of a micro-structured gas separator utilizing the Soret effect	1
Design and experimental study of a steam ejector refrigeration system	1
Double-diffusive natural convection in a trapezoidal solar pond with discrete heat boundary conditions: Effects on non-convective zones	1
Effects of inert-gas addition on the dynamic behavior and propagation characteristics of spherically expanding hydrogen-air flames	1
Reduction and optimization of ammonia-hydrogen combustion reaction kinetic model for HCCI engines	1
Analysis of flame detection data from multiple-ion probes using feature extraction	1
Validation of Soave–Redlich–Kwong equation of state coupled with a classical mixing rule for sound speed of non-ideal gas mixture of oxygen-hydrogen as liquid rocket propellants	1
Experimental investigation of a thermally driven pumping system for a potential application with a microgrid system for rural communities	1