Journal of Engineering Thermophysics

Papers
(The TQCC of Journal of Engineering Thermophysics is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-05-01 to 2025-05-01.)
ArticleCitations
Spontaneous Pulsations of a Swirling Jet of Boiling Water19
Development of Method of Low-Perturbation Multichannel Temperature Diagnostics in Vortex Tube19
Energy Recovery Based on Exhaust Gas Recirculation and Heat Regeneration Processes Applied in a Firewood Boiler17
Significance of Thermal Boundary Layer Analysis of MHD Chemically Radiative Dissipative Casson Nanofluid Flow over a Stretching Sheet with Heat Source15
Optical Diagnostics of Hydrogen-Air Diffusion Jet Flame14
Optimal Design and Analysis of Airfoil Radiator Fins Based on Weakly Compressible Turbulence12
Using CO2 Hydrate and Air Flow to Extinguish Flame from Wood Materials11
Experimental Study of Influence of Initial Air Temperature on Characteristics of Combustion of Diesel Fuel Atomized by Jet of Superheated Steam11
Experimental Study on the Performance of a Solar Heat Pump System11
Experimental Study of Interphase Mass Transfer for Gas-Liquid Flow in Microchannel with Successive Contractions and Expansions10
On Temperature of Working Fluid Supply to Combustion Chamber in CO2 Power Cycles with Oxy-Combustion of Methane10
Heat Conduction of Superheated Mixtures: Relationship with Excess Volume10
A Numerical Investigation of Heat Transfer from Heated Surfaces of Different Shapes9
Heat Transfer Enhancement on Multilayer Wire Mesh Coatings and Wire Mesh Coatings Combined with Other Surface Modifications—A Review8
Promising Cathode Materials for Solid Oxide Fuel Cells8
Laser Doppler Anemometry of Cavitating Hydrofoil in a Slit8
Numerical Investigation of Hybrid TiO2-Water Nano-Fluid with Heat Source and Induced Magnetic Field7
Model of the Hydraulic Resistance for the Flow in a Spiral Wounded Column7
Experimental Determination of Amount of Liquid Held by Surface of Structured Packing in Distillation Column7
Designing Thermal Shield with Choice of Structure Parameters of Composite Based on Carbon Aerogel7
On Mathematical Modeling of Convection in the Upper Mantle of Earth7
Geometric Optimization of T-shaped Fin and Inverted Fin Based on Minimum Entropy Generation Objective7
Calculation of Heat Transfer Coefficients in LNG Column7
Effect of MHD and Mass Transpiration on a Viscous Liquid Flow past Porous Stretching Sheet with Heat Transfer7
Influence of Liquid Properties on Gas-Liquid Flow Regimes and Pressure Drop in a Flat Microchannel6
Thermophysical Properties of Magnesium in Solid and Liquid States6
Hysteresis Phenomena at Boiling in Liquid Film Flowing down the Tubes with Microarc Oxidation Coating6
Dynamic Characteristics of Thermopiles6
An Experimental and Numerical Study on the Optimum Flow Rate of a Photovoltaic Thermal System Integrated with Phase Change Materials6
Using LED Interferometry Technique to Study Pressure Reduction Effect on Microlayer Thickness during Pool Boiling6
Thermoelectric Properties of BeO and MgO Monolayers from First-Principles Calculations6
Heat Transfer Enhancement on Surface Modified via Additive Manufacturing during Pool Boiling of Freon6
Theoretical Study of Formation of Hydrates from High-Concentration Metastable Solution of Carbon Dioxide in Water at Various Gas Concentrations6
Evaporation of Water Droplets and Corrosion on Various Graphene Coatings5
Numerical Implementation of Boundary Conditions on Bubbles in a Microchannel with Stationary Laminar Flow5
Mathematical Modeling of Reverse Processes with Consideration of the Water–Ice Phase Transition5
Microchannel Surface Structures for Drag Reduction5
Simulation of Heat Transfer during Injection of Annular Gas-Droplet Jet into Turbulent Cross-Flow5
Prediction of Void Fraction in Sub-Cooled Flow Boiling at High Pressure Using Distribution Parameter Correlations5
Exact Transient Heat Conduction of Functionally Graded Thick Structures4
Dissociation and Combustion of Gas Hydrates4
Heat Transfer and Pressure Drop during Circulation of Non-Azeotropic Mixture in Heated Channel with Spiral Intensifiers4
Heat Transfer in a Falling Liquid Film of Freon R21 on an Array of Horizontal Tubes with Modified MAO Coatings4
A Novel Method Based on a Non-Stationary Discrete Markov Chain for Tracking Variations in the Quantity of Reserved Energy and the Number of Electric Vehicles4
Development of Multivariable Triangulation Method for Diagnostics of Icing of Wind Turbine Blades4
Heat Transfer during Evaporation/Boiling of Horizontal Layers of Liquid at Low Pressure4
Plasma Ignition System to Start Up Pulverized Coal Boilers: Experimental Simulation and Full-Scale Test4
Calculation of Heat Loads in Analysis of Superorbital Entry of Spacecraft into Atmosphere of the Earth3
Hydrodynamics of Instant Emptying of High-Pressure Liquid from Pipeline3
Features of Oxidation of Bismuth by High-Density Water-Oxygen Fluid3
Double Freon Hydrates: Composition and Thermodynamic Properties3
Heat Transfer in Circular Channel with Spiral Intensifiers during Circulation of Non-Azeotropic Alcohol-Water Mixture3
Effects of Header Configuration on Flow Maldistribution in Plate-Fin Heat Exchangers3
Correcting Spectral Density of Laser Doppler Anemometer Signals during Measuring of High-Speed Aerodynamic Flows. Part 13
Temperature Distribution in the Mantle under the Continental Limb of the Subduction Zone and in the Subducting Plate3
Vacuum Plasmatrons with Hollow Cathode: Gas-Dynamic Plasma Processes in the Hollow Cathode3
Dynamics of Gas Motion in Pipe with Permeable Wall3
Polymerization in Droplet of Aqueous Solution of PEGDA/Irgacure at Various Concentrations of Components3
Comparison of Two Numerical Models of Convection in the Earth’s Mantle2
Heat Transfer in Liquid Film Falling Down Vertical Cylinder with Single-Layer and Gradient Two-Layer Mesh Coatings2
A Study of Solids Mixing in a Bubbling Fluidized Bed Using the TFM Method. Part I. Particle Travel Time Distribution2
Incineration of Pulp and Paper Mill Waste in Supercritical Water Using Methane as a Co-Fuel2
Investigating the Influence of the Magnetic Field on the Flow of Colloidal Fluid in a Microchannel System2
Plasma Gasification of Organic Waste for Production of Motor Fuel2
Numerical Study of Heat Transfer in a Lattice Matrix with Varying the Crossing Angle2
Heat Transfer at Evaporation and Boiling of Refrigerant Mixture Film Falling Down a Vertical Heater with a 3D-Printed Dual-Scale Coating2
On Applicability of IQR Method for Filtering of Experimental Data2
Heat Transfer during Boiling in Horizontal Layers of HFE-7100 on Smooth and Modified Surfaces2
Interactive Influence of Conduction–Convection–Radiation on Heat Transfer from a Discretely and Non-Identically Heated Electronic Gadget2
Geometric Evaluation of Bluff Bodies Arrangement under Turbulent Flows with Mixed Convection Heat Transfer2
Gas Hydrodynamic Modeling of Operation of Intermittent Gas Lifts2
Influence of Incidence Angle on Compressor Cascade Performance at Low Reynolds Number2
Fundamentals of Hydrodynamics and Heat and Mass Transfer at Film Condensation of Stationary Vapor on Horizontal Tube Bundles: A Brief Review2
Unsteady MHD Viscous Nanofluid Flow Containing Gyrotactic Microorganisms through a Cylindrical Outer Region2
Effects of Slip, Porosity and Chemical Reaction over a Curved Stretching Surface with Mass Transfer2
Effect of Local Heat Supply into Supersonic Incoming Flow Ahead of Thin Body with Disk on Intensity of Weak Far-Field Shock Waves2
Exploring the Influence of Surfactants on Methane Hydrate Formation Kinetics Beyond Its Thermodynamic Stability Region from a Supersaturated Solution ’Water + Sodium Lauryl Sulfate + Methane’2
Experimental Study of Characteristics of Activated Carbon Produced from Pine Nut Shells by Pyrolysis Technology Followed by Steam-Gas Activation2
Effect of Inclination Angle on Wall Shear Stress in Upward Two-Phase Flow in a Pipe2
Aspects of Two-Phase Flow Boiling Heat Transfer inside Tube of Water Tube Boiler—A Numerical Study2
Experimental Study of Thermal Conductivity of Novec 7000 in Vapor Phase2
On Increasing the Efficiency of a Cement Clinker Kiln Using Machine Learning2
Thermal Behavior of Magnetite Nanofluid under Magnetic Field: An Experimental Study and Development of Predictive Model to Predict Thermal Conductivity2
Droplet Impacts on Cold Cylindrical Copper Surfaces2
0.060935974121094