OOIR: Observatory of International Research

Papers

(The H4-Index of Journal of Mechanical Science and Technology is 24. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)

Article	Citations
Assembly sequence planning based on improved pollination algorithm	70
Analysis of dual phase-lag heat conduction in the cornea subjected to laser irradiation	53
CNN-based fault classification using combination image of feature vectors in rotor systems	46
An alternative testing method to investigate creep-dominant creep-fatigue interaction and its application on modified 9Cr-1Mo steel	45
Simulation of in-situ preheating of ni-based multi-layer and multi-pass coatings on H13 steel	44
Experimental study on balance drum leakage according to the design parameters of centrifugal high-pressure multistage pumps	43
Improved weak texture multi-view 3D reconstruction algorithm based on deformable convolutions networks	42
LSTM-AE based condition monitoring for reciprocating air compressors considering on/off characteristics	40
A robust-based fatigue optimization method for systems subject to uncertainty	35
Novelty class detection in machine learning-based condition diagnosis	32
Closed-loop control dynamic obstacle avoidance algorithm based on a machine learning objective function	31
Temperature compensation for electromechanical impedance-based damage detection of steel beams using neural network	29
Development of advanced power reactor nuclear power plants containment pressure and temperature analysis methodology using CAP computer code	29
Adaptive sliding mode control of gap-like manipulators based on an improved hybrid algorithm-optimized neural network	28
Research on time-varying mesh stiffness analysis method of gears with local defective faults	27
Aeroelasticity design and evaluation methodologies for gas turbine axial compressor: focus on fluttering phenomena	26
Improved analytical solutions using optimized basis functions for the large deflection problem of rectangular membranes subjected to pressure load	26
Sub-critical vibration analysis of a synchronous condenser rotor system with considering the rotor asymmetry and slot wedge-groove depth effect	26
Adaptive slicing algorithm for optimizing section profiles based on cubic NURBS curve interpolation	25
Research on roller profile design scheme for the main bearing of shield machine based on dynamic working conditions	25
Pressure drop analysis of subsurface irrigation dripper system and its flow rate uniformity	25
Recoil reduction design of gas-controlled side-jet gun based on bifurcated two-phase flow model	25
Shear-type vibration suppression device for enhancing dynamic performance of steel spring floating slab tracks	24
Multi-orientation optimization of complex parts based on model segmentation in additive manufacturing	24
Erratum to “Development of low-cost non-powered prosthesis using multi-axis system of toe joint and ankle”	24

Computational analysis of warping height in rolled Cu/Al laminates using the symplectic elasticity method