International Journal of Chemical Engineering

Papers
(The median citation count of International Journal of Chemical Engineering is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)
ArticleCitations
Research on the Aerodynamic Noise Characteristics of Heat Exchanger Tube Bundles Based on a Hybrid URANS‐FWH Method35
Simulation of Multiphase Flow and Mixing in a Conveying Element of a Co-Rotating Twin-Screw Extruder by Using SPH23
Improving Coffee Bean Drying Performance Using Polydryer (Dryer Assisted with Superabsorbent Polymer)22
Nanosilica‐Coated 3D‐Printed Filters for Efficient Cu(II) Removal From Water: Adsorption Behavior and Reusability22
Effects of Pyrrhotite on the Combustion Behavior and the Kinetic Mechanism of Pyrite-Pyrrhotite Mixture Powders in the Air21
An Experimental Analysis of Lean Binary Mixture Segregation in a Continuous Liquid Fluidized Bed20
Polymer Property Prediction Model for an Industrial Two‐Stage Ethylene‐Propylene Copolymerization Reactor19
Evaluating the Effectiveness of Low‐Silica X and Copper‐Modified Low‐Silica X Zeolite Adsorbents for Cyanide Ions Removal From Aqueous Solutions19
Modified UiO‐66 for the Degradation of Tetracycline Antibiotic Under Solar Irradiations17
Numerical Integration of Some Arbitrary Functions over an Ellipsoid by Discretizing into Hexahedral Elements for Biomaterial Studies16
Sequential Geometric Programming Method for Parameter Estimation of a Nonlinear System in Microbial Continuous Fermentation14
Enhanced Photocatalytic Removal of Congo Red Dye From Water Environment Using Eggshells Infused With Graphitic Carbon Nitride Composites13
Study on the Effect of Cyclic Loading on the Geomechanics of Sandstone Reservoirs in Gas Storage13
The Potential of Lignocellulosic Biomass Hydrolysates for Microbial Oil Production Using Yeasts and Microalgae13
Biogas Production through Anaerobic Codigestion of Distillery Wastewater Sludge and Disposable Spent Yeast12
An Insight Into the Adsorption of Potentially Hazardous Drugs From Pharmaceutical Wastewater Using Polyaniline– Mucuna Composite (PMC): Multicriteria Ana12
Slow Pyrolysis of Waste Cow Bone for Biochar Production and Its Application in Copper Removal From Acidic Solutions11
Biogenic Silica Derived From Sugarcane Bagasse as a Precursor Material for Unmodified SBA‐15: Physicochemical Properties and Their Use in Biodiesel Production From Spent Oil11
Domestic Organic Waste: A Potential Source to Produce the Energy via a Single-Chamber Microbial Fuel Cell10
Municipal Solid Waste Challenges in Ethiopia and Valorizing the Potential of the Organic Waste Fraction for Composting and Bioenergy9
Correction to “Biodiesel Production from Waste Animal Fat by Transesterification Using H 2 SO 4 an9
Predicting Asphaltene Stability Using Machine Learning Models Based on SARA Analysis9
Geotechnical Investigation and Microanalysis of Black Cotton Soil Amended with Guar Gum and Polyethylene Terephlate Fibre9
Cobalt Catalyzed and UV Activated Peroxymonosulfate for Acetaminophen Degradation: Kinetics, Mechanism, and Toxicity9
Application of Monod Equation and First‐Order Rate Kinetics for the Calculation of Crude Oil Concentration Along Depths of Stagnant Freshwater and Saltwater Media8
Enhancing Graphene Oxide Production and Its Efficacy in Adsorbing Crystal Violet: An In‐Depth Study of Thermodynamics, Kinetics, and DFT Analysis8
Experimental Intensification and Modeling of Solid–Liquid Extraction of Polyphenols From Rice Husk Waste Using Organic Solvents8
Investigating the Adsorption of Humic Acid from Water Using CTS/PAM and CTS/PAM/EDTA Adsorbents8
ZSM-5/γ-Al2O3 Catalysts for Methanol Dehydration: Tuning Pore Structure by Carbon Nanotubes as a Pore-Forming Agent8
Sisko Hybrid Nanofluid Model for Blood Flow Over an Exponentially Stretched Cylinder Incorporating Homogeneous–Heterogeneous Reactions: A Framework of the Modified Buongiorno Model7
Economic and Environmental Comparison of the Monosodium Glutamate (MSG) Production Processes from A‐Molasses in an Integrated Sugarcane Biorefinery7
New Insight Into Odor Fading in Natural Gas Distribution Networks: Recent Breakthroughs and Challenges7
3D Hollow Mg-Ca-Al Hydrotalcite-Like Compounds Doped with KF for Catalytic Transesterification7
Optimization of Dye Removal of Cibacron Red Textile Dye From Wastewaters Using Kombucha Scoby With the Taguchi Method7
New Approaches to Using Ammonium Salts in Technological Processes of Metallurgy and Gas Purification6
Performance Optimisation of Low‐Damage Foam Fracturing Fluid System in Unconventional Reservoirs6
Evaluation of the Sorption Properties of Diatomite for Capture of Radioactive Barium, Cobalt, and Zinc6
Study on Osmotic Consolidation and Hydraulic Conductivity Behavior of an Expansive Soil Inundated with Sodium Chloride Solution6
Commercialization of Algae‐Based Biofuels: The Case of Ghana6
A Retrospective Analysis of Polymer Selection Using Solvent Casting: Formulation and DoE Optimization of the Amorphous Solid Dispersion of Amoxicillin Trihydrate by a Spray Drying Method6
Acidithiobacillus ferrooxidans Leaching of Silica‐Sulfide Gold Ores from May‐Hibey Deposits, Tigray, Ethiopia6
Catalytic Performance of HZSM‐5–Al 2 O 3 Nanocomposites in Glycerol Conversion6
Research on Rapid Evaluation Methods for Hydrogen Consumption and Driving Range of Fuel Cell Vehicles5
Analysis Study of Available Alternatives for Mitigation of Aromatic Hydrocarbon Emissions from a Glycol Dehydration Unit5
Life Cycle Assessment of Valorizing Waste Polyethylene and Coconut Shells Into Activated Carbon Polymer Flakes5
Effect of inside Surface Baffle Conditions on Just Drawdown Impeller Rotational Speed5
Removal of Natural Organic Matter (NOM) from Aqueous Solutions by Multi-Walled Carbon Nanotube Modification with Magnetic Fe3O4 Nanoparticles5
Synthesis of Furfural from Xylose Using Carbon‐Based Bifunctional Solid Acid Catalyst in the Biphasic System5
Estimation of Acetic Acid Concentration from Biogas Samples Using Machine Learning5
Influence of Gas from Long-Flame Coal Spontaneous Combustion on Gas Explosion Limit5
The Effect of Sweeping Media and Temperature on Aqueous CO2 Removal Using Hollow Fiber Membrane Contactor (HFMC): An Experimental Determination5
Numerical Simulation of a Novel Hydrocyclone Mixer Structurally Optimized for Mixing Performance and Energy Efficiency5
Optimization of Ultrasonic‐Assisted Extraction of Phenolics and Terpenoids from Sweet Basil Leaves Using Natural Deep Eutectic Solvents4
Performance Analysis of Pressurized Thermochemical Heat Storage System Using Thermal Vapor Ejector and Mechanical Compressor4
Effects of Thermodiffusion and Chemical Reaction on Magnetohydrodynamic-Radiated Unsteady Flow Past an Exponentially Accelerated Inclined Permeable Plate Embedded in a Porous Medium4
Development of Compound Dust Suppressants for Innovative Management of Construction‐Induced Dust Pollution4
Analysis of Bagasse Cellulose-Based Hydrogel for Methylene Blue Removal from Textile Industry Wastewater4
Corrosion of Stainless Steel in Deaerated NaCl Solutions3
Development and Assessment of Carboxymethyl Cellulose–Loaded Zinc Oxide Nanoparticles for Antibacterial Properties3
Synthesis and Study of Kinetics of CoFe 2 O 4 @SiO 2 3
Numerical Study on Heat Transfer and Release Characteristics of Key Components in Electrically Heated Tobacco Products3
Enhancement of Consolidated Bioprocessing for Bioethanol Conversion From Water Hyacinth Using the Wild and Mutant Bacterial Strains3
Optimization of Podocarpus falcatus Seed Oil Epoxidation Using a Sulfonated Carbon Catalyst Derived From Rice Husk3
Mixing Performance of New Glass‐Lined Impeller HS603G3
Agrofood Waste and By-Product Valorization, Extraction, and Characterization of Pectin from the Waste Biomass Fruit Peel of Aframomum angustifolium Using Response Surface Methodology as Alternative So3
Synthesis of Micromesoporous Zeolite-Alumina Catalysts for Olefin Production from Heavy Crude Oil3
Advances in Membrane Technologies for Seawater Desalination: Carbon‐ and Metal‐Based Nanocomposites for Fouling Mitigation3
Research Hotspots and Evolution Trends of CCUS Policy in Industrial Field From the Perspective of Carbon Peaking and Carbon Neutrality Goals3
Methods for Predicting Speed of Sound in Fatty Acid Ethyl Esters and Ethylic Biodiesels Using Gibbs Energy Additivity3
Solvent Extraction of Copper From Sulfate Leach Liquor of Chalcopyrite Concentrate: Mitigation Strategies for Iron Coextraction3
Electron Beam‐Induced Surface Modification on Nanochitosan‐Grafted 3D‐Printed Monoliths for Enhanced Wastewater Color Removal3
Regeneration Analysis of Bone Char Used in Water Defluoridation: Chemical Desorption Route, Surface Chemistry Analysis and Modeling2
Comparison of Mixing Performance of HB Impeller as Large Paddle Impeller2
Thin‐Layer Drying Model, Drying Rate, and Effective Water Diffusion Coefficient of Pelleted Feed2
Peculiarities of Combined Mixing Caused by Instability of Mechanical Equilibrium of Isothermal Ternary Gas Mixture at Diffusion2
Reproduction of Unique Streak Line Patterns of Large Impellers by Numerical Analysis2
Application of Artificial Intelligent Approach to Predict the Normal Boiling Point of Refrigerants2
Dynamic Simulation of the CO 2 Cryogenic Separation Process2
Impact of Asphaltene on Water‐in‐Oil Emulsion Stability2
Effect of Double Stratification on MHD Williamson Boundary Layer Flow and Heat Transfer across a Shrinking/Stretching Sheet Immersed in a Porous Medium2
Numerical Study to Define Initial Thermal Integration Window for Methane Oxidative Coupling with Dehydroaromatization Reactors2
Effects of PMMA‐PEG Copolymer on the Structure and Performance of PVC Membranes for Oily Wastewater Treatment2
Optimization of Keratin Hydrolysate Extraction from Tannery Sheep Hair Waste2
Impact of Hydrocyclone Geometry on Glycerol Separation Efficiency in Biodiesel Purification2
0.5659191608429