OOIR: Observatory of International Research

Papers

(The median citation count of Latin American Journal of Solids and Structures is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-11-01 to 2024-11-01.)

Article	Citations
Tribological and Mechanical Properties of Epoxy Reinforced by Hybrid Nanoparticles	21
Effects of Non-Structural Walls on Mitigating the Risk of Progressive Collapse of RC Structures	15
A Novel Sliding Mode Control Algorithm for an Active Suspension System Considering with the Hydraulic Actuator	14
Advance the stability of the vehicle by using the pneumatic suspension system integrated with the hydraulic actuator	14
Damage indices evaluation for one-dimensional guided wave-based structural health monitoring	12
Finite Element Analysis of Reinforced Concrete Pile Cap using ATENA	11
On the oscillatory behaviours and rub-impact forces of a horizontally supported asymmetric rotor system under position-velocity feedback controller	11
Structural Behavior of Reinforced Hybrid Concrete Columns under Biaxial Loading	10
High-hardness polyurea coated steel plates subjected to combined loadings of shock wave and fragments	10
Bilateral Interference of Wind Loads Induced on Duplicate Building Models of Various Shapes	9
Application of MIMO Control Algorithm for Active Suspension System: A New Model with 5 State Variables	9
Peak Ground Acceleration Models Predictions Utilizing Two Metaheuristic Optimization Techniques	9
Nonlinear Dynamic Analysis of Plates Subjected to Explosive Loads	9
Advanced acoustic signal analysis used for wheel-flat detection	8
Design and optimization of equal gradient thin-walled tube: Bionic application of antler osteon	8
Epistemic Uncertainty Treatment Using Group Method of Data Handling Algorithm in Seismic Collapse Fragility	8
Experimental study on pulse shaping techniques of large diameter SHPB apparatus for concrete	8
An experimental investigation of new bent V-shaped shear connector	7
Detecting Damage in Carbon Fibre Composites using Numerical Analysis and Vibration Measurements	7
Behavior of Auxetic Steel Wire RC Columns Exposed to Elevated Temperature	7
Vibration Analysis of Axially Functionally Graded Timoshenko Beams with Non-uniform Cross-section	6
An efficient finite element model for dynamic analysis of gravity dam-reservoir-foundation interaction problems	6
Influence of Trapezoidal Shapes and Cutout Sizes on the Buckling Behaviour of Composite Laminates Under Thermally Induced Loads	6
Evaluation and fitting of a numerical model for reinforced concrete thin walls through experimental results of monotonic and cyclic loading tests	6
Constitutive framework of a new hyperelastic model for isotropic rubber-like materials for finite element implementation	5

Concrete-filled twin-layer steel-sheet CWs system: A systematic review of the literature	5
Ultimate Bending Strength Evaluation of MVFT Composite Girder by using Finite Element Method and Machine Learning Regressors	5
Research on mechanical properties and acoustic emission characteristics of rock beams with different lithologies and thicknesses	5
Comparison between a linear and cubic fiber angle variation on buckling response of variable angle tow composite panels	4
Effect of uncertainty of fastening systems properties on wheel/rail dynamic force	4
The effects of tether pretension within vertebral body tethering on the biomechanics of the spine: a Finite Element analysis	4
XFEM Modelling and Experimental Observations of Foam Concrete Beam Externally-Bonded with KFRP Sheet	4
Numerically study of SSSI effect on nuclear power plant on layered soil	4
Experimental research on dynamic mechanical characteristics of layered composite coal-rock	4
Topology Optimization – unconventional approaches using the Generalized Finite Element Method and the Stable Generalized Finite Element Method	4
Reinforcement design and buckling analysis of toroidal shell with openings	4
Effects of impact velocity on the dynamic fragmentation of rigid-brittle projectiles and ceramic composite armors	4
Structural Performance and Finite Element Modeling of Roller Compacted Concrete Dams: A Review	4
Stress Transferring Mechanism of a Pressure Tunnel Lining Strengthened with CFRP	3
Elastoplastic Analysis of Perforated Metal Sheets using Transformation Field Analysis and Finite Element Method	3
Seismic behavior of MSCSS based on story drift and failure path	3
A study of TLCD parameters for structural vibration mitigation	3
Mechanical and Energy-Absorption Properties of a 3D-Printed Star-Shaped Auxetic Honeycomb under Combined Compression-Shear Loading	3
Estimation of structural stiffness with the use of Particle Swarm Optimization	3
Seismic fragility assessment of typical bridges in Northeastern Brazil	3
Elastic-viscoplastic solution of a circular tunnel in Hoek-Brown rock mass	3
Numerical Modelling of Foamed Concrete Beam under Flexural Using Traction-Separation Relationship	3
Postbuckling analysis of nonlocal functionally graded beams	3
Comparison between recent implicit time integration methods with frequency dissipation for nonlinear structural applications	3
Comparative evaluation of design codes for buckling assessment of a steel spherical shell	3
Interference effects mapping on the static wind loading of a tall building	3
Fault Diagnosis of Motor Bearing Based on Current Bi-Spectrum and Convolutional Neural Network	3
Experimental research on tungsten alloy spherical fragments penetrating into carbon fiber target plate	3
Numerical Study on Dynamic Performance of End-anchored Rockbolt under Impact Loading	3
Preformed Fragment Velocity Distribution of Elliptical Cross-section Projectile	3
Experimental Study and In-depth Tensile Mechanism Analysis of Grouted Sleeve Lapping Conectors	3
Second–order models for the bending analysis of thin and moderately thick circular cylindrical shells	3
Estimation of wavy honeycombs’ compression performance via a machine learning algorithm	3
Experimental Study on Jet Formation and Penetration Characteristics of Square cross-section Shaped Charge	3
Accidental Injuries Caused by Automotive Frontal Collision	3
A numerical investigation on Contact Mechanics applications using eight-node hexahedral elements with underintegration techniques	3
Numerical and theoretical analysis of geosynthetic encased stone column composite foundation under cyclic loading	2
Nonlinear Numerical Evaluation of Dry Precast Beam Column Connection with Embedded Bolts	2
Natural frequency of a heavy flexible plate: power law evolution as a function of length	2
Theoretical and computational simulation of the effect of the number of intermediate diaphragms on the live load distribution factors and structural response of a precast girder bridge	2
Experimental Study of Earthquake Simulator for 3D Cold-Formed Steel Frame Structure	2
CFRP repair effectiveness on compressed steel tubular members with circular cutout	2
DYNAMIC ANALYSIS OF A COUPLED HIGH-SPEED TRAIN AND BRIDGE SYSTEM SUBJECTED TO SEA WAVE HYDRODYNAMIC LOAD	2
Soil-structure interaction with time-dependent behaviour of both concrete and soil	2
A Multiobjective Optimization Framework for Strength and Stress Concentration in Variable Axial Composite Shells: A metaheuristic approach	2
The technology and application of cable force monitoring for spatial cable structure	2
Numerical and experimental investigation of the ballistic performance of the armor structure with in-layer deflector against bullets	2
The Impact of the Cracks on the Harmonic Response of Stiffened Steel Plates	2
Dynamic structure-soil-structure interaction of piled high-rise buildings under earthquake excitations I: Influence on dynamic response	2
Optimizing stiffness and lightweight design of composite monocoque sandwich structure for electric heavy quadricycle	2

Numerical evaluation of the seismic performance of thin reinforced concrete wall buildings representative of the industrialized building system	2
Analysis of Stress, Strain and Young's Modulus of Specimens under Propagation of the 1D Linear Elastic Stress Waves	2
Analysis and optimization of impact energy absorption performance of mine refuge chamber filled with concave triangular negative poisson's ratio material	2
Comparison of seismic performances of reinforced concrete frames strengthened by different techniques	2
Modeling Particles Elements in Damaged Reinforced Concrete Structures	2
Seismic performance assessment based on the interstory drift of steel buildings	2
Analysis of seismic parameters for the earthquake vulnerability assessment of Nusretiye (Tophane) Clock Tower	2
Experimental study on the energy dissipation of foam concrete plate fragmentation under explosion loading	2
Analysis of the Effective Dynamic Properties of Particulate Composites with Respect to Constituent Properties	2
A critical assessment of two-stage composite time integration schemes with a unified set of time approximations	2
Innovated shear deformable FE formulations for the analyses of steel beams strengthened with orthotropic GFRP laminates	2
Numerical Analysis of the Seismic Performance of Rigid Beam-To-Column Moment Connections Equipped with Steel Slit Damper (SSD)	2
Collapse Resistance Model and Deformation Mechanism of Shear Wall Replacement	1
Machine Learning-Based Prediction of Axial Load Bearing Capacity for CFRST Columns	1
Predicting compressive strength of concrete with fly ash, metakaolin and silica fume by using machine learning techniques	1
A thermodynamically consistent elastoviscoplastic phase-field framework for structural damage in PTFE	1
Optimization of plates reinforced with different initial slope and variable number of carbon fibers	1
Reliability-based design of reinforced concrete pipes to satisfy the TEBT	1
Influence of strongly-constrained liquid-filled composite armor on stability of incoming shaped charge jet during eccentric penetration	1
Stress-strain distribution and failure mechanisms in dual-phase steels investigated with microstructure-based modeling	1
Buckling of Axially Compressed Conical Shells with Multiple Imperfections	1
Mechanical Behaviour of Metallic Yielding Dampers with Different Aspect Ratios	1
Deformation Pattern and Energy Absorption Characteristics of A Four-Tube Nested System Under Lateral and Oblique Loadings	1
Behavior of Macro-Synthetic Fiber-Reinforced High-Strength Concrete Beams Incorporating Bacillus subtilis Bacteria	1
A conjugate modal force strategy for instability analysis of thin-walled structures: an unconstrained vector positional finite element approach	1
Nonlinear response of acid storage tank coupled with piping attachment under seismic load for optimal safe design	1
Double scalar elastic damage constitutive model considering shear damage	1
Novelty detection on a laboratory benchmark slender structure using an unsupervised deep learning algorithm	1
The Seismic Behavior of Block Type Deep Soil Mixing	1
Validation of the uncertainty bounds on modal parameters identified with the SSI-COV method	1
Numerical investigation into the effectiveness of steel i-beam strengthening techniques in steel-framed buildings	1
Numerical analysis of high-strength concrete columns interconnected by normal-strength concrete floor	1
Aspects of finite element modeling of strengthened RC walls with opening	1
Influence of stress triaxiality on the fracture behaviour of Ti6Al4V alloy manufactured by electron beam melting	1
Study on the penetration of elliptical cross-section projectiles into concrete targets: theory and experiment	1
Determination of vibration acceleration mechanism and vibration load application duration from a non-biological perspective: Orthodontic Acceleration	1
Reliability analysis of very slender columns subjected to creep	1
Penetration of ballistic gelatin by explosion-driven inert metal particles	1
Optimization of Vibration Band Gaps in Damped Lattice Metamaterials	1
An improved Artificial Rabbit Optimization for structural damage identification	1
Damage Evaluation of Reinforced Concrete structures at lap splices of tensional steel bars using Bonded Piezoelectric Transducers	1
Dynamic model of a logistic train with different steering systems and tire models	1
Numerical model for analysis of compact and slender hybrid steel beams subjected to bending	1
A Thermodynamically Consistent Phase Field Framework for Anisotropic Damage Propagation	1
An Extended Multiscale Finite Element Method (EMsFEM) Analysis of Periodic Truss Metamaterials (PTMM) Designed by Asymptotic Homogenization	1
Long-term deformation assessment of a long-span concrete bridge built by the cantilever erection method	1
Flexural Behavior Analysis and Design Approach for R.C. Beams by Hybrid Reinforcement of Steel Rebars and HDPE Uniaxial Geogrids	1
Response of a Double Hypar Fabric Structure Under Varying Wind Speed Using Fluid-Structure Interaction	1
Study on vibration isolation performance of composite multilayer wave impeding block based on wave impedance ratio under an underground dynamic load	1
Shear contribution on viscoelastic behavior of beams modeled using plane frame elements with Reissner kinematics	1
Comparison of Seismic Response Corner Beam-Column Joint with and without Fuse Bars Under In-Plane Lateral Cyclic Loading	1
A Gurson model in association with a cohesive zone model on the investigation of cleavage-ductile transition in metals	1
Design and evaluation of dual-resonant aggregates metaconcrete	1
Improved friction model applied to plane sliding connections by a large deformation FEM formulation	1
Automatic Form-finding of N-4 Type Tensegrity Structures	1
Two accelerated isogeometric boundary element method formulations: fast multipole method and hierarchical matrices method	1
Experimental study in wind tunnel of interference effects on the reduced model of the CAARC building	1
Innovative Approach for Enhancing GLULAM Performance with Reinforcing Steel Bars: A BESO-based Study	1