OOIR: Observatory of International Research

Papers

(The TQCC of Chemical Industry & Chemical Engineering Quarterly is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-10-01 to 2024-10-01.)

Article	Citations
Production of bioplastic material from algal biomass	21
Dynamic optimization of low-density polyethylene production in tubular reactor under thermal safety constraint	12
Impact of air temperature on drying characteristics and some bioactive properties of kiwi fruit slices	11
Clean printing process of cotton with natural dyes: Effect of paste formulation components on printing performances	10
Circular economy in apple processing industry: Biodiesel production from waste apple seeds	8
Enhancing lipid extraction from green microalgae Chlorella sp. using a deep eutectic solvent pretreatment	8
Xanthomonas campestris biocontrol agent: Selection, medium formulation and bioprocess kinetic analysis	8
Biosorption of lead ions from aqueous solutions by beech sawdust and wheat straw	7
Electrochemical harvesting of microalgae꞉ Parametric and cost-effectivity comparative investigation	7
Comparison of corrosion behaviour of copper and copper alloys in aqueous chloride solution	5
Techno-economic analysis of catechin mix manufacture from Camellia sinensis leaves using green extraction technology	5
Drying kinetics and energy efficiency of microwave-dried lemon slices	5
Experimental heat transfer studies on copper nanofluids in a plate heat exchanger	5
The drying kinetics and characteristics of Shrimp dried by conventional methods	5
Preparation and characterization of PVA-SiO2 nanocomposite membranes for seawater desalination by pervaporation	4
Hot-air drying and degradation kinetics of bioactive compounds of gilaburu (Viburnum opulus L.) fruit	4
Pine cones powder for the adsorptive removal of copper ions from water	4
CMC of diverse Gemini surfactants modelling using a hybrid approach combining SVR-DA	4
Effect of storage process on nutritive properties of preterm human milk	4
A review on modeling of proton exchange membrane fuel cell	4
Improvement of the monochlorobenzene separation process through heat integration: A sustainability-based assessment	3
Novel allyl-ester-based polymers as flow improvers for waxy crude oil	3
Optimization of low-cost cow dung based activated carbon for the removal of carbofuran from aqueous solution	3
Combustion performance of bio-gasoline produced by waste fish oil pyrolysis	3
Cellulose acetate butyrate graphene oxide nanocomposite membrane: Fabrication, characterization, and performance	3

Artificial neural network modeling for drying kinetics of paddy using a cabinet tray dryer	3
Bioaccumulation and biosorption study of heavy metals removal by Cyanobacteria Nostoc sp.	3
The study of direct dye sorption on flax fibers during dyeing	3
The flow and mass transfer characteristics of concentric gas-liquid flow in an advanced static mixer	3
Drying characteristics of blue mussels by traditional methods	3
Modeling and simulation of the biosurfactant production by enzymatic route using xylose and oleic acid as reagents	3
Two phase leaching for metal recovery from waste printed circuit boards: Statistical optimization	3
Magnesium removal from phosphoric acid by precipitation: Optimization by experimental design	3
Multivariate statistical optimization of the ethanol fuel dehydration process using ionic liquids	3
Evaluation of combined radiation for the treatment of lamivudine and zidovudine via AOP	2
Study on heat exchangers and industrial absorption column for drying polyethylene terephthalate	2
Chemical route for synthesis of citric acid from orange and grape juices	2
Newly suggested shapes of impellers for stirring highly viscous fluids in vessels	2
Obtaining xylitol by hydrolysis-hydrogenation of liquors derived from sugarcane bagasse	2
Mango seed kernel oil extraction with ethanol: Optimization of oil yield and polyphenol	2
Effect of different electrolytes on electrochemical micro-machining of SS 316L	2
Heat transfer studies in a plate heat exchanger using Fe2O3-water-engine oil nanofluid	2
Studies on thermophysical property variations of graphene nanoparticle suspended ethylene glycol/water	2
Effects of soft water attack on Portland and natural zeolite blended cements	2
Process modeling and kinetic estimation for desulfurization of diesel fuel using nano - ZnO/Al2O3	2
Performance study of electrochemical micromachining using square composite electrode for copper	2
Dyeing of polyester fibers with sulfur- and nitrogen-containing anthraquinone derivatives	2
Chemical engineering methods in analyses of 3D cancer cell cultures: Hydrodinamic and mass transport considerations	2
pH control in sodium chlorate cell for energy efficiency using PSO-FOPID controller	2
The effect of metal-titania interaction on photodegradation in SBA-15-supported metal-titania photocatalysts	2
Preparation and physicochemical properties of naturally grown green Spirogyra algae biodiesel	2
Heat transfer studies of Al2O3/water-ethylene glycol nanofluid using factorial design analysis	2