OOIR: Observatory of International Research

Papers

(The H4-Index of Materials Science in Semiconductor Processing is 44. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-02-01 to 2025-02-01.)

Article	Citations
Dual-functional TiO2/Ag/NF SERS substrate with 3D channel structures for organic pollutant trace detection and degradation	192
Improving perovskite solar cell efficiency and prolonging durability via interface modification with guanidinium iodide by post treatment method	112
Efficient manufacture of high-performance electroplated diamond wires utilizing Cr-coated diamond micro-powder	111
Boosting electron transfer by coupling Ag NPs and direct Z-scheme heterojunction in Fe3O4@SiO2@ZnO-PDA-Ag for enhanced photocatalysis	103
High performance of p-p heterojunction LaFeO3/YFeO3 planar electrode sensor for volatile organic compounds under multi-wavelength light illumination	99
Experimental insights toward carrier localization in in-rich InGaAs/InP as candidate for SWIR detection: Microstructural analysis combined with optical investigation	85
The first-principles prediction of two-dimensional indium-arsenide bilayers	84
In-situ growth of Ag/AgBr nanoparticles on a metal organic framework with enhanced visible light photocatalytic performance	76
Evolution of thermoelectric transport properties of Sb2Te3–Sb2Se3 solid-solution alloys depending on phase formation behavior	73
Synthesis of CdS and PbS nanoparticles by the thermal decomposition of ethyl xanthate complexes in castor oil using the heat-up technique	70
Sintering behavior and dielectric properties of A3(PO4)2 compounds (A = Ca, Sr, Ba, Mg, Zn, Ni, Cu)	69
Control of hole concentration in sputter-deposited BaSi2 films by B implantation and its application to p-BaSi2/n-Si solar cells	69
A novel Z-type BiOCl/Ni-MOF-74 heterojunction with coral reef-like structure for photodegradation of tetracycline and rhodamine B and degradation pathway analysis	68
Effect of interlayer thickness on electrochemical properties and corrosion resistance of sputtered TiNxnm/Tixnm multilayer thin films	67
Enhanced thermoelectric transport properties of Bi2Te3 polycrystalline alloys via carrier type change arising from slight Pb doping	66
Controlling the structural and optical properties of tungsten oxide films synthesized under environmentally friendly conditions	64
First-principles study of mechanical, electronic structure, and optical properties for cubic fluoroperovskite XMgF3 (X=Al, Ga, In, Tl) under high pressure*	63
Computational evaluation of sensing properties of a novel 2D diboron dinitride for detecting toxic gas molecules	62
An efficient sensor for SF6 decomposition products by TiO2 decorated α-AsP monolayer: Theoretically evaluating GIS device safety	62
Paving the way toward the world's first 200mm SiC pilot line	61
Properties of phosphoric acid doped crystalline silicon with different light-trapping schemes for solar cells	58
Fracture probability of PV mono-Si wafers in diamond wire slicing due to coupling of capillary adhesion bending stress and sawing stress	57
Vacancy defects on optoelectronic properties of double perovskite Cs2AgBiBr6	53
Machined quality prediction and optimization for micro-EDM drilling of semi-conductive SiC wafer	53
A low-dosage silver-loaded flower-like Bi2WO6 nanosheets toward efficiently photocatalytic degradation of sulfamethoxazole	52

High-performance PbS detectors sensitized from one-step sensitization	51
Temperature dependence of crystalline quality in MgGa2O4 films by oxygen radicals-assisted pulsed laser deposition	50
A rapid-sintering Cu-Cu joints with ultrahigh shear strength and super reliability for power electronics package	50
The synergistic effect of POM-π interaction and solid phase amidation on the visible light photocatalytic of g–C3N4–based photocatalyst	50
Breakdown voltage capability of vertical 4H–SiC power devices	49
Bismuth as efficient sintering aid for TiO2-based low temperature dye sensitized solar cell	48
Thickness and Mg doping of graded AlGaN layers: Influence on contact layer's structural and electrical properties for DUV emitters	48
Artificial intelligence model for efficient simulation of monatomic phase change material antimony	48
Tuning the electronic and piezoelectric properties of Janus Ga2XY (X/Y S, Se, Te) monolayers: A first-principles calculation	48
A facile co-precipitation synthesis of novel WO3/NiWO4 nanocomposite with improved photocatalytic activity	47
Dislocation evolution along the growth direction of 2-inch GaN crystal grown by Na-flux LPE	47
Shape modulation due to sub-surface damage difference on N-type 4H–SiC wafer during lapping and polishing	46
Influence of growth parameters and systematical analysis on 8-inch piezoelectric AlN thin films by magnetron sputtering	46
Review of titanium trisulfide (TiS3): A novel material for next generation electronic and optical devices	46
Oxygen-doping induced tunable optoelectronic properties of two-dimensional (2D) 1T-MgF2 monolayer: A first-principles study	45
Heavy metal-free MnInPSeS alloyed quantum dots-molecularly imprinted polymer as an electrochemical nanosensor for the detection of the synthetic cathinone, 3,4-methylenedioxypyrovalerone	44
Insights into 5-fluorouracil anti–cancer drug encapsulation within the pristine and palladium-doped carbon, silicon-carbide, and germanium-carbide nanotubes: A DFT investigation for advanced nanomedic	44
Low etching damage surface obtained by a mixed etching method and the influence of surface states on the C–V characteristics of AlGaN/GaN Schottky barrier diodes	44
The density function theory analysis of the inorganic perovskite materials Mg3AsX3 (X=I, Br, Cl, and F): Alteration of the physical properties by strain effect	44