European Physical Journal-Applied Physics

Papers
(The median citation count of European Physical Journal-Applied Physics is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
Tuning the optoelectronic properties of AZO thin films for silicon thin film solar cell applications23
Research on a permanent magnet assisted synchronous reluctance machine with hybrid excitation17
The effects of the electric-magnetic barrier on the spin transmission in the multibarrier semiconductor heterostructures15
Growth of size-matched nanoalloys – a comparison of AuAg and PtPd15
The adsorption of methylene blue from wastewater by Moringaoleifera pods and kernels wastes using the response surface methodology13
Transition from laminar to chaotic natural convection of air saturating a porous square enclosure12
In situ TEM study of crystals growth in amorphous Ti-Zr-Ni films at electron beam irradiation11
Calculation of structural, electronic, magnetic and optical properties of C3N monolayer substituted with magnesium10
Study of the corrosion inhibition of C38 steel in a 1M HCl medium by the ethanolic extract ofRumex Nervosus Vahl leaves8
Study of spatially confined copper plasma by probe beam deflection technique8
Comparison of structural heterogeneity in Zr- and Pd-based metallic glasses7
Evaluation of electrical conductivity of Fe-doped forsterite ceramics synthetized by sol–gel method7
Central vacancy creation in icosahedral nanoparticles induced by the displacement of large impurities7
Transition metal doping and co-doping effect on electronic and magnetic properties of zb-ScN7
Barium cerate and its composite perovskites – synthesis techniques: a comprehensive review7
Tailoring Li2SO4‒MgO‒P2O5 glasses for electrodes and electrolytes in solid ‒ state batteries with CoO doping by means of dielectric studies6
Nanoporous structures with Fe0/FeII/FeIII co-existed as catalysts for phenol degradation5
Comparative study of solar tracking and fixed-tilt photovoltaic modules in Morocco5
Retraction Notice: Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line5
Effect of annealing on photo-physical properties of BiI3 thin films via vacuum thermal evaporation deposition for photovoltaic applications5
Effect of the physical aging on the secondary β relaxation process in a La-based metallic glass5
Photosensing properties of zinc nitride thin-film transistors fabricated on recyclable plastic substrates5
First-principles computation of hydrides-perovskites XZrH3 (X = Ba, Ca, and Sr): evaluation of structural, electronic, optical and mechanical properties for hydrogen storage5
Combustion synthesis of KZnPO4: RE (RE = Dy3+and Sm3+) Phosphors for n-UV based w-LEDs5
Editorial for the Special Issue on amorphous alloys and multiscale materials: fundamental aspects and energy applications5
Transformation of mineral matter during pyrolysis, gasification and combustion of biosolid chars5
Complex-frequency approaches for parallel computations of the eddy-current transient response4
Out-of-equilibrium supported Pt-Co core-shell nanoparticles stabilized by kinetic trapping at room temperature4
Edge-Detected 4DSTEM - effective low-dose diffraction data acquisition method for nanopowder samples in an SEM instrument4
Effects of monolayer and bilayer silica films on Fe-Phthalocyanine adsorption properties4
Electrothermal behavior of a finite cylindrical conductor4
Research on ac copper losses in permanent magnet electrical machines with hairpin windings for automotive applications4
Morphology of metallic foams synthetized by plasma electrolysis deposition4
Modelling the statics and the dynamics of fluctuations in the ordering alloy AuAgZn24
The effects of Pt doping on the optical properties of Au203
Bright sources under the projection microscope: using an insulating crystal on a conductor as electron source3
Interpretation of temperature measurements by the Boltzmann plot method on spatially integrated plasma oxygen spectral lines3
Review of EELS over the last 50 years by Christian Colliex3
Regulation of electrical properties of ZrOxNy by oxygen doping and zirconium vacancies3
Effect of vacuum annealing on the properties of one step thermally evaporated Sb2S3thin films for photovoltaic applications3
Effect of Cu doping on the electronic structure, magnetic and optical properties of GaN/ZnS heterojunctions: a first-principles study3
Structural and Optical characterization of gamma irradiated PVA-PEG/Cr2O3nanocomposite films3
Hematite based ultrafiltration membrane prepared from pyrrhotite ash waste for textile wastewater treatment3
Validation using the in vivo experiment of the 3D model of the human ear using the equivalent mechanical impedance of the Mass-Spring-Damper System3
Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line3
Synthesis and structural, morphological, and chimico-optical properties of Sr2FeO4 Ruddlesden-Popper oxide3
Estimation of the drying process in porous media using the parallel and series moitrue transfer model3
Synthesis, characterization, and optical properties of NiCr2O4 and CoCr2O4 spinel nanostructures for photocatalytic applications3
Shaping the topology of a single phase BLDC motor for reduced cogging torque and improved performance3
Review on recent advances in cold plasma technology3
Erratum to: Impact of damaging and recovery on the temperature dependence of the work function of oxide electrodes in fluorescent lamps3
From early to present and future achievements of EELS in the TEM3
Phase-shifting digital holography with an unknown reference beam3
Special issue on advances in renewable energies, materials and technology3
Na-doping approach for conductivity enhancement of natural phosphate derived fluorapatites3
A type-II GeSe/SnTe heterostructure with superior optical absorption and strain tunable photovoltaic properties3
A novel 5d-7f transition phosphor KAl1–xPO4Cl:Tbx3+ (0.1 ≤ x ≤ 1.0)3
Antibacterial activity of Nickel-doped ZnO/MWCNTs hybrid prepared by sol–gel technique3
Advances in atomic resolution secondary electron imaging2
Investigating the structural, electronic, and magnetic properties of Cd1–xVxTe: insights from first-principles calculations2
On the effect of concentration and wettability on polymer drops impact, dynamics and energy dissipation2
Erratum to: Cold starting of fluorescent lamps − part II: experiments on glow times and electrode damaging2
Optical, impedance, and relaxation response of Fe3+ doped double perovskite solid solution2
Influence of different terminations on the surface properties of rare earth sesquioxides: first-principle calculations2
Fuel ignition using remote generation of microwave plasma in air at atmospheric pressure2
Acoustophoresis separation of particles based on motion modes via tilted-angle standing surface acoustic wave driven by a unidirectional transducer2
Analysis of superconducting silicon epilayers by atom probe tomography: composition and evaporation field2
Perovskite solar cell with SnO2 mesoporous thin films as electron transport layer: facile fabrication, investigation of the effects of growth parameters2
Characterisation of the waveplate associated to layers in interferential mirrors2
Analysis of complex impedance spectroscopy, modulus and dielectric properties of the 0.65PbMg1/3Nb2/3O3–0.35PbTiO3 perovskite single crystals2
A simple method to calculate incident dose for the proximity effect correction2
Flower-like 3D MoS2/Cu2O hybrids with enhanced photoelectrochemical performance2
Angular distribution of particles sputtered from the vanadium target by 5 keV Kr ions: simulation study2
Identification of wood specimens utilizing fs-LIBS and machine learning techniques2
Improving dielectric properties of composites thin films with polylactic acid and PZT microparticles induced by interfacial polarization2
Vibration analysis of a composite elastic metamaterial plate based on a semi-analytical method2
Anatase TiO2 film with dominant (001) facets prepared by radio frequency atmospheric pressure plasma2
Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line2
Computational study of partial discharge events in electric drives with segmented power supply2
Significant effect of SDS on the optimum operating temperature of ZnO nanosheets gas-sensitive materials2
Microstructure and mechanical properties of particle reinforced high-temperature titanium composites2
Examples of SVD decomposition contributions to the non-destructive testing of cultural heritage mural paintings using stimulated infrared thermography1
Synthesis and assessment of the Mo/MoO3/CZTS/Ag diode fabricated by one-pot hydrothermal route: impact of temperature1
Simulation and optimization of a RO/EV pilot reverse osmosis desalination plant powered by PV solar energy: the application to brackish water at low concentration1
Enhanced photocatalytic performance of molybdenum disulfide-copper oxide nanoparticles photoanodes1
Experimental study of the high-order exceptional points in a four-state non-Hermitian microwave meta-atoms system1
Mg-Ag-Sb thin films produced by solid-state reactive diffusion1
First-principles study of the surface and optical properties of Heusler alloys Ru2XAl (X=Mn, Zr, Ti, Hf)1
High efficiency microwave shielding films based on carbon fibre and ITO/Ag/Fe2O3hybrid polymer composites1
First steps of silicene growth on an insulating thin-film: effect of the substrate temperature1
Energy harvesting using a dynamic weighing system based on piezoelectric materials1
Density functional theory calculations applied to olivine-like NaMnPO4 with transition metal substitutions for energy storage applications1
Self-powered heterojunction ultraviolet photodetector based on NiO nanosheets/TiO2 nanorods1
A surface-potential-based electrical model for amorphous InGaZnO electric-double-layer transistors with electrolyte insulation1
Thickness dependent physical properties of evaporated permalloy/GaAs(100) thin films1
Diffusion models of grown-in and implanted p-type dopant in III-V semiconductor compounds1
Materials for energy harvesting, conversion, storage, environmental engineering and sustainability1
Nanostructured LaFeO3/Si thin films grown by pulsed laser deposition1
Micro- and nano-sized materials for solar evaporators: a review1
The reliability impact of N doping on the HfO2 charge-trapping layer: a first-principles study1
The electrode model of corona plasma discharge theory for current–voltage characteristics case in air1
Numerical study of hybrid quantum dot light-emitting diode with different concentration of quantum dots in the emissive layer1
Electron energy loss spectroscopy of K0.7Fe1.7Se2 superconductor1
Gaussian mixture model for the unsupervised classification of AgCu nanoalloys based on the common neighbor analysis1
Influences of surface state on thermal stability and magnetic properties of Fe-Si-B-C amorphous alloy1
Variations in composition and structure occurring in multicomponent alloy targets during their service term1
Study on the third-order nonlinear optical properties of Cd2+ ion doped ZnS/PVP nanocomposite films1
Low-cost thermo-chemical process of TiO2powder purification: study of iterative gettering effect1
Effect of Sn on formation and transformation of VO2 phase1
Erratum to: The temperature dependence of the work function of oxide electrodes in fluorescent lamps1
Magnetic field and cetyltrimethylammonium bromide assisted hydrothermal synthesis of cobalt ferrite nanorods for UHF applications1
Microstructure and electrical transport properties of nanoscale [(CO40Fe40B20)34(SiO2)66/(In2O3)/C]461
Hydrogenation shrinks the colossal permittivity of Sb/Co co-doped TiO2 nanoparticles-structural and optical investigations1
Review for metamaterial-based energy harvester and absorber1
Investigation of the electronic and thermoelectric properties of nitrogen chains doping SWCNT: ab initio study1
Eco-friendly synthesized few layered graphene: main physico-chemical nanocharacterizations for optical quenching applications1
Crossover from direct to trap assisted Fowler Nordheim (FN) tunneling in CoFeB/MgO/CoFeB magnetic tunnel junctions1
Conventional and high power impulse magnetron sputtering deposition of tantalum nitride films: a molecular dynamics approach1
Influence of Au0 metallic particles on NIR laser emission of Yb3+ ions in Li2O−HfO2−SiO2 glass ceramic1
Mg-doped NiCoP microflower grown on Ni foam for high-capacity supercapacitor electrode1
Unraveling protein repulsion forces with nanocelluloses: insights from force spectroscopy1
Characterization of earplugs based on porous polyurethane (PU) and polyvinyl-chloride (PVC) polymers for human ear protection1
Polarization sensitive multi-band and wideband ectromagnetically induced transparency-like on metamaterials1
Effect of the RF-power and annealing on the structural, optical, morphological and electrical properties of RF-sputtered V2O5 thin films1
Three mechanical relaxation modes associated with nanoscale structural heterogeneity in Pd42.5Ni7.5Cu30P20 fragile glass1
Zinc ferrite ZnxFe3–xO4 nanocomposites as efficient photo catalysts: a study of synthesis, properties and catalytic activity1
OLED application of π-conjugated phenylimino carboxylic acid organic semiconductor material1
One-step synthesis and characterisation of crystalline nano-calcite from phosphogysum by precipitation method1
Realizing ferromagnetic semiconductors in SrRu1−xZrxO3 alloys1
0.34459400177002