Machining Science and Technology

Papers
(The H4-Index of Machining Science and Technology is 13. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-06-01 to 2026-06-01.)
ArticleCitations
Development of a new in-situ rotating magnetorheological honing technique for fine finishing the inner cylindric surfaces28
Development of smart manufacturing framework for micromilling of thin-walled Ti6Al4V26
Study on machining characteristics and parameter optimization of titanium alloy using green argon-assisted near-dry electrical discharge milling24
Review of wire breakage causes and mitigation strategies in wire electrical discharge machining23
The grindability performance and measurement of surface functional parameter capabilities of difficult-to-machine tool steel under tangential ultrasonic-vibration-assisted dry grinding21
Experimental investigation on mixed spray characteristic of cryogenic nano-minimum quantity lubrication in milling nickel base superalloy20
Drilling characteristics and damage analysis of carbon fiber reinforced aluminum laminate19
Tool center error identification extended by material properties in ultra-precision machining18
Prediction of the cutting forces in milling operation based on multi-objective optimization of the time series analysis parameters18
A review of cutting tools for ultra-precision machining16
Prediction of tool-chip contact length based on slip-line modeling of orthogonal cutting with rounded-edge cutting tools14
Novel insights into conventional machining of metal additive manufactured components: a comprehensive review14
Investigation of debris distribution across interelectrode gap and formed crater in vibration-assisted R-µEDM13
Finite element modeling and experimental validation of turning process using bio-mimicked structured tool for outcomes relevant to industry13
Wear mechanisms and cutting performance of coated carbides in milling LPBF IN718 alloy under hybrid cryogenic conditions13
0.95623517036438