Journal of Mining Science

Papers
(The TQCC of Journal of Mining Science is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-06-01 to 2026-06-01.)
ArticleCitations
Fractures as Stress Raisers in Rock Mass in Oil and Gas Production26
Modeling Effects of Gravity on Gas Drainage in Methane-Containing Coal Seams17
Crushed Rock Strength Testing at Iron Ridge Deposit11
Physical Modeling of Temperature Field Dynamics at Coal Waste Dumps in Donbas9
A Novel Rate of Penetration Prediction Model for Large Diameter Drilling: An Approach Based on TBM and RBM Applications9
Process Flow Charts and Recommendations for Processing of Bauxite with Increased Contents of Iron and Fine Particles of Valuable Components9
Estimating Energy Consumption of Mine Fans in Underground Mines in Case of Uncertainty of Fan Influence Zones8
Loss of Load-Bearing Capacity in Sand Base of Heavy Column and in Plate Buried in Granular Medium under Multiple Weak Impacts8
Influence of Strong Electromagnetic Pulses on Efficiency of Disintegration and Magnetic Separation of Ferruginous Quartzite7
High-Speed Railway Tunnel Bottom in Nearly Horizontally Soft and Hard Interlayered Strata: Deformation Mechanism and Countermeasures7
Some Practical Aspects of Automatic Regulation and Control of Quartz Sand Preparation Process to Obtain Quality Products7
Applicability of the Suspension Effect in Estimation of Influence Exerted by Ionic Composition of Flotation Pulp on Apatite Surface7
Bio-System Concept of Technological Innovation in Mining with Implementation of Ecological Imperative6
Support and Stabilization of Temporary Roadways in Extraction of Coal Measures in Kuzbass6
Axial–Torsional Vibrations of Drill Strings with Crush-and-Shear Hybrid Bits at Constant Tension of Suspension Cables6
Estimate of Energy Characteristics of Electromagnetic Vibration Exciter6
Impact of Increased Water Inflow on Main Drainage System Efficiency in Mine6
Stability Analysis of Pillars in Underground Limestone Mine Using Three-Dimensional Scanning Techniques6
Effect of Kaolin and Basalt Composition on Geopolymer Characteristics5
Wastewater Reuse in Open Pit Coal Mines5
Optimization Analysis of Medium- to Long-Term Ore Drawing Schedule Based on MIP in Block Cave Mining5
Rapid Testing of Rock Crushability Using Hardness Meter5
Reconstruction of Paleostresses in the West of Sakhalin from Tectonophysical Research Findings5
Determining Modes of Thiol Collector Attachment at Sulfide Minerals by Optical, Electron Scanning and Laser Microscopy5
The Networking Method as a Tool for Prediction of Failures of Open Pit Mine Trucks5
Selectivity of Calcium-Bearing Mineral Flotation with Oxyhydryl Collector5
Integrated Approach to Remote Monitoring of Waterworks Facilities in the Mining Industry Using Space and Digital Technologies5
Recovery Dynamics of Mining-Altered Natural Ecosystems by Satellite Data4
Ground Surface Movements and Deformations at Almaz-Zhemchuzhina Deposit from Surveying Techniques4
Investigating the Usability of Pyrotechnic Rock Breaker Materials in Natural Stone Quarrying4
Assessment of Kinetic Characteristics for Coalbed Gas from Thermodynamic Measurements in Sealed Canister with Coal Chippings4
The Low-Temperature Plasma Effect of Dielectric Barrier Discharge on Physicochemical and Process Properties of Natural Iron Sulfides4
Swelling Behavior of Sand–Bentonite Mixtures4
Properties of Gold-Bearing Humic Acids4
Stimulation of Separation of Difficult Diamond-Bearing Raw Materials from Primary, Placer and Manmade Deposits4
Ilyushin’s Trace of Delay in Complex Loading of Granular Media with Continuous Rotation of Principal Axes of Strains4
Modeling Destructive Effect of Blastholes in Perimeter Control Blasting4
Investigation of the Effective Parameters of Travertine Stones Healing Using Bio-Grouting4
Trigger Effect in Impact Fracture of Granite Sample under Uniaxial Compression4
Design of High Speed Rotors for Axial Mine Fans4
Justification of Extraction of Ore Reserves under Bottom and in Pitwall Rock Mass Using Cut-and-Fill Method in Transition from Open Pit to Underground Mining in the Artemevsky Mine4
Insulating Property of Loam to Prevent Spontaneous Combustion of Coal and Carbonaceous Rocks4
Time Series Forecasting of Indian Coal Mines Fatal Accidents4
Effect of Inter-Hole Delays on Seismic Safety with Regard to Firing Time Deviation4
Testing of Hydraulic Hammering Tool with Restrictive Control of Energy and Frequency of Blows3
A CNN–LSTM and PSO–GRNN Prediction of the Rockburst Risk Level Based on the Data from the Combination of Microseismic Monitoring Variables with Electromagnetic Radiation Signals3
In-Situ Stress Prediction Model for Tight Sandstone Based on XGBoost Algorithm3
Formation Mechanism of High-Cold and High-Altitude Landslide Disasters Caused by Complex Goaf Groups3
Experimental Research of Mudcake Formation on Low-Permeable Sandstone Samples3
Laser Scanning Monitoring of Deformations in Concrete Lining of Mine Shafts3
Implementation of the Blast Design and Pattern Adaptation Method at Structurally Complex Deposit3
Sublevel Stoping with Cemented Paste Backfill in Weak Rock Mass Zones3
Multi-Scale Mathematical Models of Geomedia3
Application of New Dithiazine-Class Complexing Agent in Galena and Sphalerite Separation in Flotation3
Ecological and Geochemical Assessment of Manmade Water Bodies at Transbaikal Mines3
Prevention and Control of Coalburst in Tunnels Using Gantry Energy-Absorbing Hydraulic Support3
Substitution of Low-Calcium Fly Ash for Partial Portland Cement in Underground Backfilling Mining3
Interface Structures and Strength Characteristics of Coal Freezing Adhesion on Transportation Equipment in Cold Regions3
Interpretation of Composite Seismic Signals in Deep Mines in the Donbas3
Subsidence Analysis for Old Abandoned Board and Pillar Coal Mines Using ANSYS and Monte Carlo Simulation3
Justification for the Use of Interaction Parameter in Selection of Combination of Flotation Reagents3
Modeling Percussion and Rotary Percussion Drilling in Strong Rocks3
Backfill Technologies and Designs for Deep-Level Sylvinite Mining3
Mining Conditions at Man-Made Gold Placers in Yakutia’s Arctic Zone3
Soft Rock Reinforcement by Bicomponent Organomineral Resin Injection3
Mass Transfer in Upward Percolation of Water Solutions in Tailings3
Change in Permeability in Fault Zones under Impact of Seismic Waves Induced by Massive Blasts3
The Use of Geospatial Data in the Industrially Disturbed Land Evaluation3
Modeling of Knelson Concentrator Operating Parameters by Using Application of Box–Behnken Experimental Design for Chromite Ore3
Information Technologies in Problems of Nonlinear Geomechanics. Part I: Earth Remote Sensing Data and Lineament Analysis of Deformation Wave Processes3
Geomechanical Behavior of Undermined Rock Mass in Blind Orebody Mining in Tashtagol Field3
Removal of Suspended Solids from Industrial Wastewater3
A Preliminary Investigation of the Operating Variables in a Laboratory Knelson Concentrator for Enrichment of Chromite Ore3
Preparability of Iron Ore from Yakovlevo Deposit, Kursk Magnetic Anomaly, Using Coarse Particle Separation Methods3
Numerical Modeling of Dust-and-Air Flow in Air Filtering System in Subway Tunnel Ventilation3
Evolution Mechanism and Monitoring Technology of Overburden Deformation in Underground Mining with Grout Injection3
Effect of Modified Polyvinyl Caprolactam on Gold Recovery from Fine Slime in Gold Ore Flotation2
Rock Mass Condition Assessment Using InSAR and Numerical Modeling2
Delimitation of Displacement Zones in Cut-and-Fill Mining of Kimberlite Deposits Using Cemented Paste Backfill2
Analysis of Reagent Regimes in Nepheline Concentrate Production from Loparite Ore Processing Tailings by Flotation2
Automated Planning of Underground Mining Operations with Regard to Geological and Geotechnical Constraints2
Modified FEM Algorithm with Introduced Elastic Blocks for Geomechanical Modeling of Undermined Rock Mass2
Selecting Organic Collectors for Luminophore-Bearing Modifying Agents to Extract Weakly Fluorescent Diamonds2
The Application of Shortwave Band GPR in Investigation of Surrounding Rock-and-Lining Interface2
Modification of Properties of High Luminous Diamonds with Luminophore-Bearing Compositions towards Enhanced Selectivity of X-Ray Luminescence Separation2
Effect of Discontinuities on Elastic Wave Velocities in High-Stress Rock Samples: Experimental Research Using Ultrasonic Interferometry2
Potential of Milky Quartz from the Larino Deposit in the Southern Urals in Production of High-Purity Quartz Concentrates2
Loading of Diamond Wire Saw of Stone Cutting Machine2
Erratum to: Kinetics of Experimental Adsorption of Nickel Metal by Activated Carbon2
Justification of Shrinkage Stoping Parameters for Thin Ore Bodies in Gravitational Stress Field2
Determination of Informative Frequency Range in Seismic Noise in the Method of Remote Appraisal of Hydrocarbon Reservoirs2
Influence of Spatial Orientation of Initiator-Notch on Roof Rock Deformation near Production Face in Directional Hydraulic Fracturing2
Prediction of Magnetic Hydrocyclonage Performance in Suspensions2
Thermal Stress State in the Vicinity of Underground Roadways2
Bench Testing of Borehole Electromagnetic Impulsive Source of Vibrations2
Geomechanical Assessment of Slope Stability in Open Pits in Transbaikalia2
Estimation Methods of Dynamic Strength of Rocks2
Mechanical Properties of Shotcrete Produced with Recycled Aggregates from Construction Wastes2
Influence of Flow Process Parameters on Physical and Mechanical Characteristics of Granular Materials Containing Coal2
Deformation of Strong Overburden Rocks in Dams and Overburden Dumps during Operation of Transport Machines2
Effect of Surfactants on Specific Fracture Energy of Carbonate Rocks at Different Temperatures2
Estimation of Specific Cutting Energy and Noise Level in Circular Saw Cutting Process by Leeb, Shore and Schmidt Hardness Values of Rocks2
Estimating Thickness of Defects at Rock-Concrete Lining Interface by Ground-Penetrating Radar2
Subsidence Analysis for Old Abandoned Board and Pillar Coal Mines Using ANSYS and Monte Carlo Simulation2
Modeling Arching of Rocks in Top Coal Caving in Thick and Gently Dipping Coal Seams2
Usability of Chloride Mine Water in Preparing Cemented Paste Backfill2
Transient Processes in Formation of Geotechnical Systems in Deep Open Pit Mines: Methodical Aspects2
Clustering in Granular Medium in Biaxial Compression2
Multilevel Model of Cleavage Fracture in Brittle Rocks in Compression2
Processibility of Fine-Grained Magnetite–Apatite Ore Mill Tailings at Kovdor Deposit2
Influence of Structural Features of Gold Placers on Mining Efficiency in the North2
Effect of Temperature on Physico-Mechanical Properties of Chunar Sandstone, Mirzapur, U.P., India2
Collectability and Selectivty of Frothers in Flotation2
Geomechanical Analysis of Mining System Parameters in Sublevel Caving of Close-Spaced Ore Bodies2
Prediction of Rock Fragmentation in Bench Blasting Operations Based on Multi Parameters—A Case Study2
Failure Mechanism and Acoustic Emission Characteristics of Coal–Rock Samples2
Seismic and Hydrogeological Monitoring of Large-Scale Blast Parameters: A Case-Study of Lebedinsky Open Pit Mine, Kursk Magnetic Anomaly2
Physical Simulation of Penetration of V-Shaped Indenter in Rocks in Static and Dynamic Tests2
Influence of Contact Time between Buttons of Roller Bits and Rock on Indicators of Rock Fracture2
Reliability Assessment of Cross-Sector Model Diagnostics in the Case of Mining and Energy Complex after the Emergency Situation2
EXPERIMENTAL DETERMINATION OF DISSIPATION FACTOR IN ROCK SAMPLES OF DIFFERENT TYPES AND GENESIS2
Topicality of the Framework and General Theory for Safe Deep-Level Mining of Hydrocarbon-Bearing Formations2
Application of Neural Networks in Rock Mass Stress Assessment by Photoelasticity2
Determination of Rock Mass Structure near Tunnel by Phase Velocities of Seismic Surface Waves2
High-Rate Mining Technology Simulation Modeling2
0.086177110671997