OOIR: Observatory of International Research

Papers

(The H4-Index of Materials and Manufacturing Processes is 30. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-05-01 to 2025-05-01.)

Article	Citations
Continuous hot-compaction behavior of nanostructured FeCrCuMnTi-(V, Zn) high-entropy alloys	129
Effects of protective materials on the sintering properties of Zn₄Sb₃	80
Micro-electrical discharge machining of nitinol alloy using coated electrode and multi-energy field	75
Simulation and experimental studies on surface quality of vibration-assisted ECM	73
One-shot drilling process for thin CFRP/Aluminium alloys stacks	61
Investigation and optimization of parameters for bidirectional composite vibratory finishing of gears	59
Micro-feature fabrication on SS304 stainless steel using WEDM process	58
Effect of filler material on the microwave joining of SS-430 steel	57
Influence of Cu/Ni interlayers on rotary friction welded dissimilar SS321–Ti6Al4V joints	52
Effect of machining parameters on turning process of Inconel 718	51
Investigation into electrically-assisted rolling of superalloy array microgroove structure	50
Experimental investigations and optimization of non-electrical parameters during microelectrode fabrication	47
Experimental study on application of gas metal arc welding based regulated metal deposition technique for low alloy steel	46
Micromachining of Al7075 alloy using an in-situ ultrasonicated µ-ECDM system	43
EDM of titanium foam: electrode wear rate, oversize, and MRR	41
Optimizing the plastic injection molding process and reducing warpage through response surface methodology	40
Effect of EDMed rake face grooves on the chip breaking capability of twist drills during deep hole drilling of Al 6061 aluminum alloy	38
Mechanism of bonding during laser transmission welding using EIP absorber	37
Micro-machining of SDSS-2507 under comparative assessment of fiber laser scan techniques	36
Performance comparison of EDM oil and biodiesel flushing media while µED milling of Inconel 718	36
Scalable preparation of graphene from graphite ore via mechano-chemical ball milling	35
Arc characteristics and weld formation of aluminum alloy by AC/DC mixed GTAW	35
Optimization of process parameter in AI7075 turning using grey relational, desirability function and metaheuristics	33
Electrochemical machining of titanium alloy blades using optimized cathode with built-in insulators	33
A comprehensive parametric study on abrasive waterjet trepanning of Al-6061 alloy	33

Plasma synthesis of ammonia by asymmetric electrode arrangement	32
Experimental investigation on machining of multiple micro-square holes	31
Machining of Zircaloy-2 using progressive tool design in EDM	31
Multi-attribute optimization of AWJM parameters on hybrid kevlar/SS wire mesh epoxy composites	30
Recycling of spent lithium-iron phosphate batteries: toward closing the loop	30
Use of powder bath sintering for the fabrication of hard ceramic tools	30