Journal of Micromechanics and Microengineering

Papers
(The H4-Index of Journal of Micromechanics and Microengineering is 18. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
A long-stroke planar linear actuator equipped with magnetic guide88
Miniature and tunable high voltage-driven soft electroactive biconvex lenses for optical visual identification81
Design and fabrication of a low-cost microfluidic cartridge with integrated pressure-driven check valve for molecular diagnostics platforms54
PDMS-polyimide transcutaneous blood gas collector with self-folding out-of-plane heater elements42
Passive communication for low power distributed sensors using MEMS optical cavities34
The radial point interpolation method (RPIM) for analyzing a V-shaped electrothermal actuator29
Magnetically maneuverable micromixer using acoustically excited bubbles26
Recent advances in power supply strategies for untethered neural implants25
Bistable liquid shutter operated by DEW actuation for multifunctional miniature cameras25
Measurement and control of stiction force in in-plane electrostatically actuated Si nanoelectromechanical cantilever relays with Pt contacts24
Flexible capacitive pressure sensors with micro-patterned porous dielectric layer for wearable electronics21
RF MEMS capacitive shunt switch for low loss applications21
Wearable microfluidic sweat collection platform with a calorimetric flow rate sensor for realtime and long-term sweat rate measurements20
High density cleanroom-free microneedle arrays for pain-free drug delivery19
Fabrication of an X-shaped micro-copper structure containing a merging joint based on localized electrochemical deposition19
Deep silicon etching technology and applications: a review19
Regulating the electrical performance of contact-separation mode triboelectric nanogenerators based on double-sided groove textures19
An SOI-based post-fabrication process for compliant MEMS devices18
Enabling water-based EVA adhesives for solvent-free aerosol jet printing in microfabrication18
On the PZT/Si unimorph cantilever design for the signal-to-noise ratio enhancement of piezoelectric MEMS microphone18
Shape deviations of DLW microstructures in dependency of fabrication parameters18
Performance evaluation of a 3D split-and-recombination micromixer with asymmetric structures18
0.10172700881958