OOIR: Observatory of International Research

Papers

(The H4-Index of Process Safety and Environmental Protection is 73. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)

Article	Citations
Study on the influence of combined utilization of air-fog curtain on fully mechanized face	232
Fungal co-culture enabled co-fermentation of food waste for production of endoglucanase enzyme	227
Nonferrous metal flue gas purification based on high-temperature electrostatic precipitation	198
Performance of Bacillus subtilis D3d xylanase separated through optimized aqueous two-phase system in bio-bleaching of sugar beet pulp	197
Evaluation of the flammable region formed by liquid hydrogen spill using a new simplified pool model	185
Inside Front Cover	182
Inertization parameters for alcohols and ketones with nitrogen and carbon dioxide	161
Highly efficient Fe-Cu/CL catalysts based on low-cost clay minerals for NH3-SCR of NOx at low temperature	160
Metagenomic analysis of a top-down enriched straw biodegradation synthetic bacterial consortium (StrBsyn) facilitates anaerobic rice straw degradation	149
Quantum chemical calculation assisted efficient lithium extraction from lithium precipitation mother liquor via solvent extraction	141
High temperature co-processing of basic oxygen furnace slag and blast furnace slag: Self-pulverization and reduction mechanism	136
Design of heat recovery steam generator (HRSG) and selection of gas turbine based on energy, exergy, exergoeconomic, and exergo-environmental prospects	135
Experimental study on the effect of sloping substrate on the spill fire in a well-confined ship engine room	134
Experimental study on the channeling leakage properties of compact-size casing-cement sheath-stratum assembly in deep and ultra-deep wells	123
Effects of Cl-ion and temperature variations on steel corrosion in supercritical CO2 saturated aqueous environments	120
Change point detection of processes using graph neural differential convolutional network with contrastive loss	116
Effect of swirl number on structural and emission characteristics of moderate size burner flames	114
Stepwise extraction and utilization of silica and alumina from coal fly ash by mild hydrothermal process	113
A comparative study of the effect of cavity and obstacle on premixed methane–air flame evolution	112
Monitoring and detecting coal miners' fatigue status using MPA-LSSVM in the vision of smart mine	111
Preparation of activated carbon fibers rich in S/N/O adsorption sites for selective and efficient trace Pb(II) removal from drinking water	110
Optimal planning of inter-plant hydrogen integration (IPHI) in eco-industrial park with P-graph and game theory analyses	110
Removal of bisphenol A (BPA) by fermented sludge-derived granular biochar from template-like method: From batch experiment to continuous operation	108
Particle emissions from a marine diesel engine burning two kinds of sulphur diesel oils with an EGR & scrubber system: Size, number & mass	106
Experimental study on vertical spill fire characteristics of transformer oil under continuous spill condition	106

Recovery of high-purity rhenium resources from W-Mo-Re alloy scraps by two-stage low-temperature oxidation volatilization	105
Atmospheric water harvesting by osmotic distillation and direct contact membrane distillation using hydrophobic hollow fiber membranes	104
Implementing and maintaining an evergreen risk screening program in an exploration and production company	103
Natural gas leakage estimation in underground utility tunnels using Bayesian inference based on flow fields with gas jet disturbance	103
Process and mechanism of Zn and Co leaching from cobalt xanthate slag enhanced by oxidative roasting	102
Experimental study of the electrochemical hydrogen pump based on proton exchange membrane for the application in fusion fuel cycle	99
Preparation of PVDF composite membrane reinforced by conductive knitted fabric	99
Towards greener metal production: A life cycle assessment model for copper-gold-silver mining and mineral processing operations	99
An inherently safer design approach based on process safety time for batch chemical reaction processes	98
Industrial application of swirl regenerating micro-channel separation (SRMS) for fine catalysts removal from methanol-to-olefin quench water	97
Development and prospects of major accident indicators in the offshore petroleum sector	96
On trending technologies of aluminium dross recycling: A review	95
Biogas intake pressure and port air swirl optimization to enhance the diesel RCCI engine characteristics for low environmental emissions	93
Study on optimization of shelter locations and evacuation routes of gas leakage accidents in chemical industrial park	93
Innovative electrostatic spray technology for control of particulate matter emitted from electron beam flue gas treatment process	92
Effects of peroxide types on the removal performance and mechanism of sulfonamide antibiotics using graphene-based catalytic membranes	92
Cellular instabilities of outwardly propagating spherical hydrogen-oxygen flames using a soap bubble method	89
Influence of particle size on the separation performance and flotation kinetics of foundry dust	88
Influence of ballasted material properties in enhancing the separation of high concentration suspended solids in coal mining water	88
A multilayer analytical model for reactive contaminant transport through cutoff wall-aquifer systems: Addressing pre-installation contamination and source removal scenarios	87
Challenges and solutions for rural domestic sewage treatment at the grassroots level in developing countries	87
A comparative study of diesel engine fueled by Jatropha and Castor biodiesel: Performance, emissions, and sustainability assessment	86
Removal of selenite (Se(IV)) using ferrous sulfate, ferric sulfate, and ferrate: A comparative study of iron (Fe)-based coagulants	86
Valorization of Bambusa striata shavings into functional superparamagnetic material and its application in biodiesel production: Response surface optimization, kinetics, thermodynamics and economic as	84
Harvest of typical cold season submerged plant Potamogeton crispus regulating water purification capacity in wetland	83
Advancements in gas-liquid separation based on membrane contactors: Critical factors enhancing separation efficiency	83
Assessment and prediction of the impact of wastewater treatment plant effluent on the ecological health of urban rivers	83
Biohythane production techniques and recent advances for green environment – A comprehensive review	82
Identification of security scenarios in offshore Oil&Gas production facilities based on past incident analysis	82
Gated recurrent unit-enhanced deep convolutional neural network for real-time industrial process fault diagnosis	80
Investigating the adsorption behavior and mechanisms of swine manure-derived biochar in tetracycline removal	79
Wastewater remediation using multi-soil layering (MSL) eco-technology: A comprehensive and critical review	79
Environmental impacts and supply risks for LiFePO4 - LiCo Ni Mn O2 hybrid battery pack in China	79
An evolutionary deep learning model based on XGBoost feature selection and Gaussian data augmentation for AQI prediction	79
Experimental research on the influence of wall effect on the structure of cumulated semi-cokes	79
Fault detection and isolation using probabilistic wavelet neural operator auto-encoder with application to dynamic processes	78
Thermal reaction characteristics and microstructure evolution of aluminium nano-powder in various mixtures of oxygen and nitrogen atmosphere	78
Halloysite nanoclay doped ceramic membrane fabrication and evaluation of textile wastewater treatment performance	78
Post-tanning wastewater treatment using electrocoagulation: Optimization, kinetics, and settlement analysis	77
Feature transfer projection with low-rank and dual graph embedding for multimode process monitoring	77
Life cycle assessment of active pharmaceutical ingredient production: A case study of Citicoline	77
Untapping the coal reserves: Green desulfurization using phosphonium based ionic liquids	76
CFD-based flow simulation and optimization of horizontal tube sedimentation tanks (HTST)	76
Inside Front Cover	76
A green and facile pretreatment for flotation separation of electrode materials from spent lithium-ion batteries: Low-temperature roasting-induced deformation of PVDF	75
A new UV-grafted photocatalytic membrane for advanced treatment of biologically treated baker’s yeast (BTY) effluent: Fabrication, characterization and performance evaluation	75
Enhancement strategies for ZnSe based photocatalysts: Application to environmental remediation and energy conversion	75
Unraveling the potential of chemical recycling for poly(methyl methacrylate) through pyrolysis: Rigorous modeling, economic, and environmental evaluation	75
A framework for environmental production of textile dyeing process using novel exhaustion-rate meter and multi-layer perceptron-based prediction model	73
Characteristics of polychlorinated dibenzodioxins/dibenzofurans from a full-scale municipal solid waste (MSW) incinerator in China by MSW classification	73