OOIR: Observatory of International Research

Papers

(The median citation count of Advances in Cement Research is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-03-01 to 2024-03-01.)

Article	Citations
Influence of cement replacement by limestone calcined clay pozzolan on the engineering properties of mortar and concrete	48
Behaviour changes of ground granulated blast furnace slag geopolymers at high temperature	31
Developing one-part alkali-activated metakaolin/natural pozzolan binders using lime waste	20
Carbon-dioxide-activated bonding material with low water demand	19
Long-term mechanical properties and micro mechanism of magnesium oxychloride cement concrete	18
Performance of limestone calcined clay blended cement-based concrete against carbonation	18
Effects of polycarboxylate superplasticisers with various functional groups on the pore structure of cement mortar	18
Durability of silica aerogel cementitious composites – freeze–thaw resistance, water resistance and drying shrinkage	17
Effects of packing density and water film thickness on fresh and hardened properties of ternary cement pastes	15
Understanding the aqueous phases of alkali-activated slag paste under water curing	13
Thermo-physical, mechanical and microstructural properties of cementless lightweight mortar	12
Mitigation of the potential alkali–silica reaction of FNS using ground FNS as a supplementary binder	12
Characterisation of water stability of magnesium phosphate cement blended with steel slag and fly ash	11
The method of repairing microcracks based on microbiologically induced calcium carbonate precipitation	11
A comparative study of the effects of two alkanolamines on cement hydration	11
Stabilisation of α′ dicalcium silicate in calcium sulfoaluminate clinker	10
Pozzolanic activity of central Anatolian volcanic tuff and its usability as admixture in mortar	10
Investigation on the properties of magnesium oxychloride cement prepared with seawater	10
Prediction of carbonation using reactivity test methods for pozzolanic materials	10
Effect of chemical structure on dispersity of polycarboxylate superplasticiser in cement paste	10
Thermal behaviour of ladle slag mortars containing ferrochrome slag aggregates	9
Pozzolanic performance resemblance of milled sugarcane biomass ash using different pozzolanicity test methods	9
Study of the reaction stages of alkali-activated cementitious materials using microcalorimetry	9
Strength and hydration attributes of cement pastes containing nano titania and cenosphere	9
Fresh and hardened properties of 3D printable polymer-fibre-reinforced high-performance cementitious composite	9

Workability and microstructural properties of red-mud-based geopolymer with different particle sizes	9
Chemical properties of pore solution of hardened cement pastes with mineral additions	8
Effect of pre-introduced sodium chloride on cement hydration process	8
Short-term elemental release from Portland cement concrete in hypersaline leaching conditions	8
Incorporation of zinc in calcium sulfoaluminate cement clinker	7
Effects of calcium aluminate cement on the acid resistance of metakaolin-based geopolymer	6
Effect of pH value on the growth and properties of magnesium phosphate cement paste with a large water-to-solid fraction	6
Durability of photocatalytic cement subjected to nitrogen dioxide and wet–dry cycling	6
Erosion of aerial lime and sticky rice mortars by cyclic wetting–drying and dilute sulfate acid actions	6
Influence of nano-silica on early age and durability properties of cement mortars	6
Multifunctional cement composites with expanded graphite for temperature monitoring of buildings	6
Evaluation of elastic modulus of cement paste in sodium sulfate solution by an advanced X-CT–hydration–deterioration model with SC method	6
Effect of red mud addition on oil well cement at high temperatures	6
Physical properties and microstructure of nickel slag/metakaolin-based geopolymer with different contents of nickel slag	6
Effects of liquid accelerators on carbonation properties of C₃A and C₃S hydration products	5
Pozzolanic efficiency of calcined clays in blended cements with a focus on early hydration	5
Influence of Theed on strength development and hydration of blended cementitious systems containing titanium slag	5
Effect of synthesis conditions and post-synthetic treatments of LiAl-LDH on the performance of sulfoaluminate cement	5
Application of light-burnt dolomite as a mineral addition in concrete	5
Sand particle erosion of cement mortar under sulfate and chloride attack and exposure to freeze–thaw cycles	5
Effect of Ti on crystal transition and solid solution characteristics of white Portland cement clinker	4
Optimising the setting behaviour of accelerated cement paste containing poly(AANa-co-DMAA)	4
Effect of superplasticisers and their mechanisms of action on magnesium oxysulfate cement properties	4
Polymer/organic compound high-temperature retarder used for oil and gas exploration, and development	4
Analysing of nano-silica usage with fly ash for grouts with artificial neural network models	4
Synthesis, characterisation and application of self-healing material in oil well cement for healing microcracks	4
New approach for evaluating chloride ion penetration of mortar in cold environments	4
Effect of K₂O content on properties of sugar cane bagasse ash-cement-based systems	4
Characterisation of calcium aluminate cement hydration: comparison of low-field NMR and conventional methods	4
Effect of citric acid on calcium sulfoaluminate cements synthesised from industrial wastes at low temperature	4
Effect of low temperature and moisture on bond properties of PVA fibres and engineered cementitious composite matrix	4
Thermal activation mechanism and pozzolanic activity characteristics of coal flotation tailing	4
Effect of flotation phosphorus tailings on the microstructure and compressive strength of white Portland cement	3
Influence of sodium chloride on the hydration of calcium aluminate cement constantly cured at 5, 20 and 40°C	3
Degradation and life prediction model for piles due to crystallisation attack in sulfate saline area	3
Utilising under-burnt waste bricks from kilns as supplementary cementitious material	3
The electro-mechanical tensile properties of an engineered cementitious composite	3
Influence of mechanochemical activation on the rheological, fresh and mechanical properties of one-part geopolymer grout	3
Performance of cement asphalt mortar with nanomaterials	3
Research on the effectiveness of polycarboxylate superplasticisers with different side-chain lengths	3
Effect of mechanical activation on reaction mechanism of one-part preparation fly ash/slag-based geopolymer	3
Mechanical and self-sensing properties of concrete reinforced with carbon nanofibres	3
Early hydration of CSA cement modified with styrene–butadiene copolymer dispersion	3
Preparation and properties of alite-modified calcium sulfoaluminate cement	3
Early formation of belite in cement clinker raw materials with slag	3
Thermal behaviour of PPC and OPC-53 when exposed to extreme temperatures	3
Study of damage evolution in concrete with different initial defects under uniaxial compression by acoustic emission	3
Temperature and age effects on mechanical behaviour of phosphorus slag-based concrete	3
Early-age shrinkage of cement pastes with polypropylene and curaua fibres	3
Binary alkali-activated systems obtained by the valorisation of calcined kaolin sludge and bottom ash	3

Dynamic and physio-mechanical effects of combined functionalised MWCNTs and nanosilica particles on cement composites	3
The microstructure evolution of cement paste modified by cationic asphalt emulsion	3
Partial replacement of OPC with CSA cements – effects on hydration, fresh and hardened properties	3
Effects of carbonation on carbon dioxide capture and the mechanical properties of concrete with amine sorbents	3
Effect of curing temperature on mechanical behaviour of green concrete containing glass powder as cement replacement	2
A geochemical assessment method for identification of natural pozzolans as supplementary cementitious material	2
Study of seawater corrosion resistance of ordinary Portland cement–aluminate cement–gypsum mortar containing slag	2
Effects of compound mineral admixtures on the properties of magnesium oxysulfate cement	2
Mechanism of bacterial control of mineralisation gradient at the surface layer of cement-based materials	2
Phase evolution and burnability of cement raw meal	2
Utilisation of low-reactivity fly ash for fabricating geopolymer materials	2
Hydration and improved properties of magnesium oxysulfate cement modified by phosphoric acid	2
Mechanical behaviour of hybrid fibre reinforced cementitious composites exposed to high temperatures	2
Chemical deformation and mass change of metakaolin-based geopolymer grouting material in sulfate environments	2
Effect of carbonic anhydrase bacteria on the carbonation process of γ-C₂S	2
Effects of inert silica powder on the properties of magnesium oxysulfate cement	2
Effect of grinding on the quantification of bound water in tricalcium silicate	2
Influence of high-volume limestone powder on hydration and microstructural development of cement	2
Early-age characterisation of Portland cement by impedance spectroscopy	2
Performance improvement of cement paste loaded with MWCNT–magnetite nanocomposite	2
Effect of hyperbranched polycarboxylic acid superplasticiser on the properties of cement paste	2
Contribution of turbidimetry on the characterisation of cement pastes bleeding	2
Use of natural pozzolans in high-performance concrete for the Mombasa–Nairobi railway	2
Assessment of the performances and reactions of quaternary LC²–slag cement	2
Effect of pore solution expression on solid composition of cement paste	2
From composition to the microstructure and durability of limestone ternary blended cements: A systematic review	2
Effects of polycarboxylate architecture on flow behaviour of cement paste	2
Laboratory investigation of the permeability properties of cement mortar with different sand–cement ratios	2
The sulfate degradation of cement incorporating carbonate by an electrical field at low temperature	2
Empirical correlation between mortars mechanical and durability tests with different cementitious materials replacements	2
Performance of low amorphous silica fly ashes in mortars	2
Novel one-part fly ash alkali-activated cements for ambient applications	2
Effect of curing temperature and clinker content on hydration and strength development of calcined clay blends	2
Cement with high-volume limestone powder: effect of powder fineness on packing density, strength and hydration behaviour	2
Comprehensive dielectric model of cement concrete including frequency and temperature	2
A quantitative study on the synergistic effect between limestone powder and supplementary cementitious materials	1
Molecular dynamics study on the adsorption of radioactive ions by geopolymers	1
Enhanced erosion resistance of cement-treated bricks using multiple biological surface treatments	1
Critical evaluation of rheological behaviour of low-calcium fly ash geopolymer pastes	1
Effect of recycled oyster shell powder on hydration and strength development of magnesium phosphate cement	1
Effect of nano C–A–S–H seeds on the early-stage hydration and pore structure of Portland cement pastes	1
Synthesis and performance of a series of novel low-molecular-weight superplasticisers with star-shaped phosphate frame	1
Features of immittance spectra as performance indicators for cement-based concretes	1
Sustainable sodium hydroxide concentration for the synthesis of alkali-activated clay–fly ash in road subgrades	1
Effect of temperature on carbon dioxide mineralisation in recycled cement paste	1
Advances in Cement Research: Referees 2020	1
Mitigating autogenous shrinkage using a combination of superabsorbent polymer and magnesia-based expansive additive	1
Cement–rock interaction in geothermal wells at high temperatures	1
Chemical–physical–mechanical stability of MKG mortars under sulfate attacks	1
Properties and microstructure of blended cement containing activated iron tailings powder	1
Effect of alkali sulfates in clinker on hydration and hardening properties of cement incorporating SCMs	1
Influence of wet storage on fly ash reactivity and processing for use in concrete	1
Molecular dynamics study on coupled ion transport in aluminium-doped cement-based materials: effect of concentration	1
Influence of carbonation on chloride penetration of pastes under cyclic wetting–drying conditions	1
Effects of different alumina carriers on the phase formation and mechanical properties of sulfoaluminate cement clinker	1
A new structure of phosphated superplasticiser with low sulfate sensitivity	1
Influence of steel fibre on bending behaviours of RPC based on X-ray CT and mesoscopic numerical simulation	1
Clinkering design of sulfobelite cements using clay overburden residue from bauxite mining	1
Sulfate resistance of ultrahigh-performance concrete with recycled fine aggregate	1
Modelling macroscopic shrinkage of hardened cement paste considering C-S-H densification	1
Effect of mineral admixtures on the properties of grouting materials made from a ternary complex system	1
Effects of calcination process of salt lake magnesium slag on the properties of magnesium oxysulfide cement	1
Life cycle assessment and shrinkage properties of high performance mortars incorporating synthetic wollastonite microfibers	1
Synthesis of modified polycarboxylate superplasticiser and its effect on cement properties	1
Analysis of the relationship between the L-box test and the yield stress of fresh concrete: an analytical approach	1
Study on early hydration and properties of basic magnesium sulfate cement using electrodeless resistivity measurements	1
Experimental study of a self-expanding filling material for mine-sealing walls	1