OOIR: Observatory of International Research

Papers

(The TQCC of Adsorption-Journal of the International Adsorption Society is 7. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-04-01 to 2024-04-01.)

Article	Citations
Connecting theory and simulation with experiment for the study of diffusion in nanoporous solids	71
Dynamic column breakthrough experiments for measurement of adsorption equilibrium and kinetics	57
A review of common practices in gravimetric and volumetric adsorption kinetic experiments	43
Analysis of direct capture of $${\hbox {CO}}_{2}$$ from ambient air via steam-assisted temperature–vacuum swing adsorption	40
Isosteric heat of adsorption from thermodynamic Langmuir isotherm	38
Pulsed field gradient NMR diffusion measurement in nanoporous materials	38
Kinetics of liquid phase batch adsorption experiments	36
Single-molecule observation of diffusion and catalysis in nanoporous solids	30
The zero length column technique to measure adsorption equilibrium and kinetics: lessons learnt from 30 years of experience	30
A reference high-pressure CH4 adsorption isotherm for zeolite Y: results of an interlaboratory study	27
Uncertainty analysis of adsorption measurements using commercial gravimetric sorption analyzers with simultaneous density measurement based on a magnetic-suspension balance	25
Adsorption for efficient low carbon hydrogen production: part 1—adsorption equilibrium and breakthrough studies for H2/CO2/CH4 on zeolite 13X	23
A novel blended amine functionalized porous silica adsorbent for carbon dioxide capture	21
Surface barriers and symmetry of adsorption and desorption processes	21
Effect of aluminum and sodium on the sorption of water and methanol in microporous MFI-type zeolites and mesoporous SBA-15 materials	20
MIL-160(Al) MOF’s potential in adsorptive water harvesting	18
Chemical modification of the polymer of intrinsic microporosity PIM-1 for enhanced hydrogen storage	17
Steam adsorption on molecular sieve 3A for sorption enhanced reaction processes	16
Effect of micropores on CO2 capture in ordered mesoporous CMK-3 carbon at atmospheric pressure	16
Sorption kinetics: measurement of surface resistance	15
NMR imaging and diffusion	14
Assessment of the potential use of zeolites synthesized from power plant fly ash to capture CO2 under post-combustion scenario	14
Diffusion in nanopores: inspecting the grounds	13
Effect of the surface hydration of clay minerals on the adsorption of cesium and strontium from dilute solutions	13
Model-based optimization strategies for chromatographic processes: a review	13

Experimental design of a “Snap-on” and standalone single-bed oxygen concentrator for medical applications	12
Measurement and interpretation of unary supercritical gas adsorption isotherms in micro-mesoporous solids	12
Adsorption for efficient low carbon hydrogen production: part 2—Cyclic experiments and model predictions	11
Investigations of mechanism of Ca2+ adsorption on silica and alumina based on Ca-ISE monitoring, potentiometric titration, electrokinetic measurements and surface complexation modeling	11
Process intensification of the high-purity nitrogen production in twin-bed Pressure Swing Adsorption plants	11
Experimental study of a rotary valve multi-bed rapid cycle pressure swing adsorption process based medical oxygen concentrator	11
Interaction of propylthiouracil, an anti-thyroid drug with boron nitride nanotube: a DFT study	11
Accurate blank corrections for zero length column experiments	10
Biomethane production by adsorption technology: new cycle development, adsorbent selection and process optimization	10
Dynamics studied by Quasielastic Neutron Scattering (QENS)	10
Quantitative imaging of gas adsorption equilibrium and dynamics by X-ray computed tomography	10
Insights of adsorption isotherms with different gases at 77 K and their use to assess the BET area of nanoporous silica materials	10
Identification of mass transfer resistances in microporous materials using frequency response methods	10
Characterization of mesoporous region by the scanning of the hysteresis loop in adsorption–desorption isotherms	10
Modelling binary non-linear chromatography using discrete equilibrium data	9
Thermodynamics of methane adsorption on carbon adsorbent prepared from mineral coal	9
Diffusion in nanopores: correlating experimental findings with “first-principles” predictions	9
Diffusion coefficients in nanoporous solids derived from membrane permeation measurements	9
Hydrogen purification by Mg alloy hydrogen adsorbent	9
Assessment of process configurations to combine enantioselective chromatography with enzymatic racemization	8
Modeling fluids confined in three-dimensionally ordered mesoporous carbons	8
Effects of operating temperature on the performance of small scale rapid cycle pressure swing adsorption air separation process	8
An evaluation on S-type adsorption isotherm in the model of crosslinked polyhydroxamates/oxazine dyes/water interactions	8
Hydrogen and deuterium separation on metal organic frameworks based on Cu- and Zn-BTC: an experimental and theoretical study	8
Structural similarity, synthesis, and adsorption properties of aluminum-based metal-organic frameworks	8
Application of the simple Bayesian classifier for the N2 (77 K) adsorption/desorption hysteresis loop recognition	8
Effect of intermittent purge on O2 production with rapid pressure swing adsorption technology	7