OOIR: Observatory of International Research

Papers

(The median citation count of Thermophysics and Aeromechanics is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-11-01 to 2024-11-01.)

Article	Citations
Effect of gas temperature and nozzle traverse speed on the deposition efficiency in cold spraying	7
Angular momentum transfer across the interface of two immiscible liquids	7
Optimization of geometric parameters of cylindrical film cooling hole with contoured craters to enhance film-cooling effectiveness	6
On diffusion of single-walled carbon nanotubes	6
Deposition of oxide nanostructures by nanosecond laser ablation of silicon in an oxygen-containing background gas	5
Determination of the transition boundary between segmented and continuous flow patterns in microfluidic liquid-liquid flows using dimensional analysis	5
Two-phase lattice Boltzmann simulation of nanofluid conjugate heat transfer in a microchannel	5
Investigating waves on the surface of a thin liquid film entrained by a turbulent gas flow: modeling beyond the “quasi-laminar” approximation	5
Stability of a supersonic boundary layer with heat supply to a narrow band of the layer	5
Numerical study of flow control methods and splitting effects in a round submerged jet	4
Concerning the methods of thermocouple embedding in experimental studies of cooling the high-temperature bodies in subcooled and saturated liquids	4
Experimental study of the influence of external disturbances on the position of the laminar-turbulent transition on swept wings at M = 2	4
Computational and experimental study of the control efficiency of the flow around an airfoil by means of distributed mass transfer	4
The effect of artificial vaporization centers on heat exchange during boiling of the film irrigating a bundle of horizontal finned pipes	4
Numerical simulation of underexpanded supersonic jets impingement on an inclined flat plate	3
Influence of the choice of the spectral interval on the accuracy of temperature determination by multiwave thermometry methods	3
On numerical modeling of aerodynamics of urban developments on unstructured computational grids	3
Instabilities of blow-down type Venturi cavitation considering thermodynamic effect	3
Simulation study for injection of two-phase fuel mixture into a cylindrical afterburner with asymmetric air inlet	3
On the efficiency of using different excitation lines of (1−0) two-line OH fluorescence for planar thermometry	3
Experimental study of shear stress during liquid flow in the model of fuel assembly	3
Impact of the chimney geometry on the power output of solar chimney power plant	3
Processes of deformation and crystallization of a nano-modified alloy drop following its impact onto substrate: a modeling study	2
Computational and experimental study of the influence of the shape of nozzle supersonic part on the flow structure in the gas-dynamic flow path of a model high-altitude test facility	2
Toroidal skeleton model of a high-porosity cellular material for modeling a supersonic flow around a cylinder with a gas-permeable frontal insert at an angle of attack	2

Investigation of emission characteristics and temperature of furnace gases in BKZ-210-140F steam boiler: milled peat combustion and support flaming with natural gas	2
Measurement of temperature and composition of gases in a propane flame by Raman scattering with a focusing resonator system	2
POD-analysis of the near field of a turbulent circular jet when mixing gases of different densities	2
Investigation of transient regimes with steam absorption by water solution of lithium bromide	2
Erosion of thermionic cathodes in a plasma torch	2
The degree of blackness of a number of metals of group VIII of the periodic system	2
Propane multipoint ignition and combustion in an ICE cylinder simulator	2
3D simulation of heat and mass transfer for testing of “clean energy” production technologies	2
Vaporization in non-azeotropic and azeotropic alcohol-water mixtures at a flow in a heated circular channel	2
Thermal expansion of superconducting tapes at low temperatures	2
Effect of ice crystals on run-back ice evolution on a wing model	2
Determining the side force appearance and its magnitude over a slender body at high angle of attack	2
Linear stability analysis of Marangoni mixed convection flow for nanofluids in a horizontal open channel	2
Model of the boundary layer of a vibrationally excited dissociating gas	2
Studying the wetting of a surface with combined structure	2
Parametric performance analysis of multiple reheat cycle for hydrogen fueled scramjet with multi-staged fuel injection	2
Structure of the flow in the near-wall gas jet injected through circular holes in a transverse trench	2
Unsteady conductive heat transfer on the cylindrical surface of a plume conduit	2
The effect of barrier location on characteristics of gas pollutant transfer in the vicinity of highway	1
Modeling of heat transfer due to induction heating of laminated glass-metal materials	1
Analysis of the shape of a capillary liquid bridge in a gap between large diameter spheres	1
Intertube bridge and rivulet liquid flows	1
Comparative analysis of thermal-screen efficiency behind ring belts of fan-shaped and cylindrical holes in a wide range of blowing angles and injection parameters	1
Numerical studies of nonstationary conjugate convective heat transfer in vertical layers of liquid and gas separated by a thin metal partition	1
Numerical simulation of the dynamics of a non-stationary liquid jet	1
Influence of a Pt-Rh/Pt thermocouple on combustion of benzene, pyridine, and pyrrole in a high pressure steam	1
Investigation of sharp change in the lift of a thick teardrop airfoil at low Reynolds numbers	1
Experimental study of evolution for circular impinging micro- and macrojets	1
Evaluation of the optimum pressure of the intercooler and the regenerator in the Bryton cycle based on exergy and energy analysis	1
Evaporation front propagation over a non-isothermal surface	1
Solubility of potassium, rubidium, and cesium in liquid lithium at high temperatures	1
Impingement cooling system for a large surface: multi-jet pulse spray	1
Wall shear stress during slug motion in an annular channel	1
Ignition of a cold hydrogen jet in a coaxial hot vitiated air flow expanding into a still space	1
Formation of local separation zones on the wings with a rigid and varioform wavy surface	1
Numerical investigation on the effect of upstream ramps on film cooling performance with compound angles	1
Flows visualization for a supersonic mixing layer behind the blunt trailing edge under non-isobaric initial conditions	1
Study of regimes for methane - carbon dioxide replacement in natural gas hydrates by liquid carbon dioxide injection into a porous stratum	1
3D structure of the flow in a near wake behind a cylinder in the slot channel	1
Effect of intermittency on thickness and heat transfer of turbulent falling liquid film	1