OOIR: Observatory of International Research

Papers

(The TQCC of Ceramics-Silikaty is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-03-01 to 2025-03-01.)

Article	Citations
THE EFFECT OF WASTE GLASS SLUDGE USED AS CEMENT REPLACEMENT AND CRYSTALLISING ADMIXTURE ON THE PROPERTIES OF HARDENED CEMENT PASTE	9
EFFECT OF Y₂O₃ ON THE STRUCTURE, THERMAL STABILITY AND ELASTIC MODULUS OF MAGNESIUM ALUMINOSILICATE GLASSES	7
THE INFLUENCE OF Cu, Ca AND Zn ON THE PROPERTIES OF METAPHOSPHATE GLASSES	6
INTERACTION ANALYSIS AND MECHANICAL PREDICTION MODEL OF COAL GANGUE-BASED GEOPOLYMER	5
SYNTHESIS AND CHARACTERISATION OF Ni-DOPED ZnO THIN FILMS PREPARED BY CHEMICAL BATH DEPOSITION	4
THE EFFECT OF SILICON OXIDE ON THE PROPERTIES OF A HYDROXYAPATITE-MAGNESIUM OXIDE COMPOSITE	4
EXPERIMENTAL VERIFICATION OF THE NEW MODELS APPLIED TO GLASS FIBRE REINFORCED CONCRETE (GFRC) CONFINED WITH GLASS FIBRE REINFORCED POLYMER (GFRP) COMPOSITES	3
PROLIFERATIVE EFFECTS AND CELLULAR UPTAKE OF CERAMIC NANOPARTICLES IN CANCER AND NORMAL CELLS	3
Bending performance of recycled concrete one-way slabs after pre-soaking in a nano-SiO₂ solution and the subsequent carbonation	3
INFLUENCE OF ALKALI ACTIVATORS ON THE CARBONATION RESISTANCE OF SUPERSULFATED CEMENT	3
DENSIFICATION PROCESS AND PROPERTIES OF DIAMOND/SiC COMPOSITES BY PRESSURELESS VAPOUR INFILTRATION	3
THE EFFECT OF ULTRAFINE COMPOSITE MINERALS ON THE LONG-TERM PERFORMANCE OF CEMENT-BASED MATERIALS	3
SIGNIFICANCE OF THE PCL CONCENTRATION ON THE ELECTROCHEMICAL AND MECHANICAL PERFORMANCE OF A PCL/HA COATING ON SS 316L.	3
SYNTHESIS AND CHARACTERISATION OF SiC-ZrB₂ COMPOSITE POWDERS BY CARBOTHERMAL/BOROTHERMAL REDUCTION REACTION	3
THE EFFECT OF CRYSTALLIZING ADMIXTURE ON THE PROPERTIES AND SHRINKAGE OF CONCRETE	3
OPTIMAL DESIGN OF LOW-CARBON CONCRETE CONTAINING FLY ASH AND LIMESTONE POWDER	2
RESPONSE SURFACE METHOD TO OPTIMISE CONCRETE STEAMING PROCESS PARAMETERS	2
EFFECT OF MgO/MgSO₄ MOLAR RATIO ON THE HYDRATION AND MECHANICAL PROPERTIES OF BMS CONTAINING STEEL SLAG	2
FATIGUE PERFORMANCE OF EPOXY-BASED CONCRETE FOR BRIDGE EXPANSION JOINT RAPID REPAIR AND THE REPAIRED CONCRETE MEMBERS	2
PREPARATION AND MECHANICAL-ELECTRICAL PERFORMANCE OF CARBON FIBRE SENSING CONCRETE	2
PREPARATION OF SILVER DOPED RICE HUSK SILICA COMPOSITES USING SOL GEL METHOD	2
METAKAOLINITE: Si & Al PRECURSORS FOR KALSILITE SYNTHESIS	2
INFLUENCE OF THE CaO CONTENT IN GLASS ON THE SINTERABILITY AND PROPERTIES OF A GLASS/Al₂O₃ COMPOSITE FOR LTCC APPLICATIONS	2
EFFECT OF ULTRAFINE SLAG POWDER ON THE RHEOLOGICAL BEHAVIOUR, COMPRESSIVE STRENGTH, AND MICROSTRUCTURE OF ULTRA-HIGH PERFORMANCE CONCRETE	2
EFFECTS OF THERMAL AGEING ON THE MECHANICAL PROPERTIES OF CAD-CAM CERAMIC MATERIALS	2

SYNTHESIS OF HIGH BELITE SULFOALUMINATE CEMENT CONTAINING MAGNESIA-ALUMINA SPINEL WITH SOLID WASTE	2
FRACTURE TOUGHNESS OF DENTAL CAD/CAM RESIN-MATRIX CERAMICS EXPOSED TO AN ACIDIC ENVIRONMENT	2
EFFECTS OF CARBONATED RECYCLED CONCRETE AGGREGATE ON MECHANICAL PROPERTIES OF CONCRETE AND MICRO-PROPERTIES OF INTERFACIAL TRANSITION ZONE	2
EFFECT OF HIGH-TEMPERATURE INERT GAS ATMOSPHERE ON THE THERMAL STABILITY OF ADVANCED REFRACTORY MATERIALS	2
DIELECTRIC MEASUREMENTS AND IMPEDANCE SPECTROSCOPY OF Ba-MODIFIED (Na 0.5Bi0.5)TiO₃ PREPARED BY THE HYDROTHERMAL METHOD	2
THE INFLUENCE OF TREATMENT TEMPERATURE ON SURFACE PROPERTIES OF INORGANIC-ORGANIC FILMS	2
MECHANICAL PERFORMANCE OF TEXTILE REINFORCED CONCRETE CONTAINING STEEL FIBERS AND BASALT FIBERS SUBJECTED TO HIGH TEMPERATURES	2
ANTIOXIDANT AND ANTI-TUMOUR ACTIVITIES OF INULA VISCOSA L EXTRACT-LOADED NANOFIBROUS MATS FOR BIOMEDICAL APPLICATIONS	2
BOTTOM ASH FROM MUNICIPAL SOLID WASTE INCINERATION AS A SUBGRADE GROUTING MATERIAL	2
SYNTHESIS AND MECHANISM OF SiC-ZrC COMPOSITE POWDERS BY CARBOTHERMAL REDUCTION METHOD	2
EFFECTS OF THE SiO₂-B₂O₃ RATIO ON THE STRUCTURE AND PROPERTIES OF B₂O₃-ZnO-SiO₂-BaO-LiO₂-Al₂O₃-Na₂O-CaO PARENT GLASS AND GLASS-CERAMICS	2
NANOCRYSTALLINE HYDROXYAPATITE PREPARED AT DIFFERENT PRECURSOR CONCENTRATIONS: THERMAL STABILITY, MORPHOLOGY AND IN VITRO CELLULAR RESPONSE	2
VISUAL OBSERVATION OF FOAMING AT THE BATCH-MELT INTERFACE DURING MELTING OF SODA-LIME-SILICA GLASS	2
ADHESION BONDING OF HYDROXYAPATITE WITH ADDITION OF ZIRCONIUM OXIDE ON Ti -6Al-4V ELI FOR ORTHOPAEDIC IMPLANT	2
STRUCTURE AND PROPERTIES OF SILVER-SILICA COMPOSITE PREPARED FROM RICE HUSK SILICA AND SILVER NITRATE	2
PREPARATION AND THERMAL-MECHANICAL PROPERTIES OF ALUMINUM TITANATE BASED CERAMICS	2
IMPROVING THE STRUCTURAL, DIELECTRIC, AND ELECTRICAL CONDUCTIVITY PROPERTIES OF BISMUTH-DOPED STRONTIUM TITANATE VIA MICROWAVE SYNTHESIS TECHNOLOGY	1
PERFORMANCE ENHANCEMENT OF RECYCLED FINE AGGREGATES THROUGH CARBONATION	1
EFFECTS OF BORIC ACID DOSAGE AND REACTION TEMPERATURE ON THE PHASE COMPOSITION AND MICROSTRUCTURE OF Si C-B₄C COMPOSITE POWDERS SYNTHESISED BY THE CARBOTHERMAL REDUCTION METHOD	1
FFECTS OF DIFFERENT Li₂O/Al₂O₃ RATIOS ON THE STRUCTURE, PHASE COMPOSITION, AND PROPERTIES OF Li₂O-Al₂O₃-SiO₂ Glass-Ceramics	1
EFFECTS OF DIFFERENT AIRBORNE PARTICLE ABRASION PROTOCOLS ON THE SURFACE ROUGHNESS AND SHEAR BONDING STRENGTH OF HIGH/ULTRA-TRANSLUCENT ZIRCONIA TO RESIN CEMENT	1
PROPERTIES OF CEMENT COMPOSITES CONTAINING QUATERNISED POLY (4-VINYLPYRIDINE) GRAFTED GRAPHENE OXIDE	1
EFFECTS OF RAW MATERIAL RATIO, CURING TEMPERATURE AND MAGNESIUM OXIDE ACTIVITY ON THE HYDRATION OF BASIC MAGNESIUM SULFATE CEMENT	1
EXPERIMENTAL STUDY ON FACTORS INFLUENCING THE PERMEABLE CONCRETE PERFORMANCE ON THE ROAD SURFACE	1
MECHANICAL AND TRIBOLOGICAL CHARACTERISTICS OF ALUMINIUM HYBRID COMPOSITES REINFORCED WITH BORON CARBIDE AND TITANIUM DIBORIDE	1
CHLORIDE DIFFUSION IN CORAL AGGREGATE CONCRETE EXPOSED TO DIFFERENT MARINE CORROSION ENVIRONMENTS	1
STRUCTURAL CHARACTERISATION OF ASPHALT-RICE HUSK SILICA COMPOSITES	1
SYNERGISTIC ACTIVATION OF MANUFACTURED SAND POWDER-SLAG-GYPSUM CEMENTITIOUS COMPOSITES USING RESPONSE SURFACE METHODOLOGY	1
ENHANCED PACKING DENSITY AND SOLID LOADING OF AQUEOUS NANO-Y₂O₃ SUSPENSIONS BY PRE-TREATING THE STARTING POWDERS WITH PHOSPHORIC ACID	1
ACHIEVING SUPERIOR ENERGY STORAGE PERFORMANCE IN BARIUM TITANATE CERAMICS VIA A RARE EARTH CO-DOPING STRATEGY	1
SILVER BASED COATED GLASS AND ITS EFFECT ON SAFETY AND ENVIRONMENT	1
THE EFFECT OF POZZOLANIC WASTE AS CEMENT SUBSTITUTE ON THE PROPERTIES OF CEMENT MORTAR AND RESISTANCE TO ALKALI-SILICA REACTION	1
ACR PROGRESS IN CONCRETES WITH DOLOMITE AGGREGATE AND BLAST FURNACE SLAG CEM III BINDER	1
THE IMPACT OF RUBBER ADDITIVE CONTENT ON THE PROPERTIES OF CEMENT COMPOSITE	1
INTERACTION OF HISTORICAL LEAD GLAZES WITH CORROSIVE MEDIA	1
NANO-TiO₂ MODIFIED ALKALI-ACTIVATED STEEL SLAG - SLAG MATERIALS: HYDRATION AND MICROSTRUCTURE	1
NANO-SILICA DERIVED FROM POWER GENERATION RICE HUSK ASH WASTE BY PRECIPITATION	1
EFFECTS OF A CaO ADDITIVE ON THE STRUCTURE AND PROPERTIES OF ALUMINIUM TITANATE CERAMICS	1
PEROVSKITES BOOSTED BY METAL OXIDES AS A CATALYST FOR THE PARTIAL OXIDATION OF METHANE	1
THE SINTERING BEHAVIOUR, MICROSTRUCTURE AND MICROWAVE DIELECTRIC PROPERTIES OF Li₂Zn₃Ti₄O12 CERAMICS DOPED BY LiF	1
STRUCTURE AND PROPERTIES OF GLASS-CERAMICS FROM BLAST FURNACE SLAG WITH DIFFERENT A l₂O₃/S iO₂ RATIO	1
A NOVEL METHOD TO SYNTHESIS OF CALCIUM SULPHATE ANHYDRITE SELF-DOPED WITH SiO₂ FROM RED MUD AS A BIOCERAMIC	1
OPTIMISATION OF THE HYDROXYAPATITE SURFACE AREA PREPARED USING A POROGEN RUBBER SUSPENSION	1
CRYSTALLIZATION AND EXFOLIATION OF METAKAOLIN UNDER MOLTEN SALT TREATMENT	1
EFFECT OF Al₂O₃-RO RATIO ON THE STRUCTURE AND PROPERTIES OF ALKALINE EARTH ALUMINOSILICATE GLASS BASED ON THE MOLECULAR DYNAMICS SIMULATION	1
EFFECTS OF DESERT SAND SUBSTITUTION ON CONCRETE PROPERTIES USING DESERT SAND-DOPED QUARTZ SAND AS THE FINE AGGREGATE	1
INFLUENCE OF ZEOLITE ON THE CONCENTRATION OF ALKALINE ACTIVATOR IN RICE HUSK ASH BASED GEOPOLYMER MORTAR	1
ORTHOGONAL EXPERIMENTAL STUDY OF BASALT-POLYVINYL ALCOHOL FIBER REINFORCED CONCRETE	1
CONTACTLESS THERMODILATOMETRY OF GLASS CULLET	1
THE EFFECT OF POZZOLANIC WASTE OF DIFFERENT NATURE ON THE HYDRATION PRODUCTS, STRUCTURE AND PROPERTIES OF HARDENED CEMENT PASTE	1

DAMAGE MONITORING OF 2D SiC-SiC COMPOSITES UNDER MONOTONIC AND CYCLIC LOADING/UNLOADING USING ACOUSTIC EMISSION AND NATURAL FREQUENCY	1
ZIRCONIA RESIN BONDED BRIDGES: AN INNOVATIVE APPROACH FOR MINIMALLY INVASIVE DENTAL PROSTHESES	1
TESTING OF ADHESION AND CYTOTOXICITY OF SOL-GEL COATINGS APPLIED BY DIP-COATING ON POROUS AND NON-POROUS TITANIUM	1
EXPERIMENTAL INVESTIGATION AND NON-LOCAL MODELLING OF THE THERMOMECHANICAL BEHAVIOUR OF REFRACTORY CONCRETE	1
EFFECT OF SULFATE ON THE CHLORIDE DIFFUSION BEHAVIOR OF CORAL AGGREGATE CONCRETE IN THE MARINE TIDE ZONE	1
FLY ASH-BASED GEOPOLYMER MORTARS USING SEAWATER AND SEA SAND	1