Journal of Energy Engineering

Papers
(The TQCC of Journal of Energy Engineering is 6. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-11-01 to 2024-11-01.)
ArticleCitations
Influence of Wave Parallel Flow Field Design on the Performance of PEMFC38
A Review of Thermal Management System and Control Strategy for Automotive Engines32
Regenerative Fuel Cell-Battery-Supercapacitor Hybrid Power System Modeling and Improved Rule-Based Energy Management for Vehicle Application25
Experimental Investigations on Cell Performance of Proton Exchange Membrane Fuel Cells with Orientated-Type Flow Channels24
Effects of Gasoline Octane Number on Fuel Consumption and Emissions in Two Vehicles Equipped with GDI and PFI Spark-Ignition Engine24
Numerical and Experimental Study by Quasi-Dimensional Modeling of Combustion and Emissions in Variable Compression Ratio High-Speed Spark-Ignition Engine24
Geothermal Energy Exploitation and Power Generation via a Single Vertical Well Combined with Hydraulic Fracturing23
Sponge-Supported Triboelectric Nanogenerator for Energy Harvesting from Rail Vibration18
Experimental Study on the Two-Phase Seepage Law of Tight Sandstone Reservoirs in Ordos Basin16
Research Progress of Electrostatic Spray Technology over the Last Two Decades15
Experimental and Numerical Studies of Enhanced Interdigitated Flow Field for PEM Fuel Cells14
Numerical Investigation of the Aerodynamic Droplet Breakup at Mach Numbers Greater Than 114
Atomization Mechanism of Internally Mixing Twin-Fluid Y-Jet Atomizer14
Enhancement of the Energy Performance of an Existing Building Using a Parametric Approach13
Energy, Exergy, and Economic Investigation of the Effect of Nanoparticle Mixture Ratios on the Thermal Performance of Flat Plate Collectors Using Al2O3–ZnO Hybrid Nanofluid12
Cogasification of Coal and Biomass in an Integrated Gasification Combined Cycle Power Plant: Effects on Thermodynamic Performance and Gas Composition12
Characterization of Gas Saturation in Tight-Sandstone Reservoirs with Rock-Physics Templates Based on Seismic Q11
Two-Stage MILP Model for Optimal Skeleton-Network Reconfiguration of Power System for Grid-Resilience Enhancement10
Effects of Combustion Chamber Shapes on Combustion and Emission Characteristics for the N-Octanol Fueled Compression Ignition Engine10
Coordinated Optimization of Parameters of PSS and UPFC-PODCs to Improve Small-Signal Stability of a Power System with Renewable Energy Generation10
Cavitation Characteristics and Hydrodynamic Radial Forces of a Reversible Pump–Turbine at Pump Mode9
Rapidity Prediction of Power Infrastructure Forced Outages: Data-Driven Approach for Resilience Planning9
A Novel Approach to Obtain Fractal Dimension in Coals by LFNMR: Insights from the T2 Peak and T2 Geometric Mean9
Comparative Analysis of the Daylight and Building-Energy Performance of a Double-Skin Facade System with Multisectional Shading Devices of Different Control Strategies9
Optimization Design and Numerical Study of Liquid-Cooling Structure for Cylindrical Lithium-Ion Battery Pack9
Numerical Investigation of Effects of Turbulence Intensity on Aerodynamic Performance for Straight-Bladed Vertical-Axis Wind Turbines9
Optimal Hourly Scheduling for Wind–Hydropower Systems with Integrated Pumped-Storage Technology9
Infill Drilling Optimization for Enhanced Oil Recovery by Waterflooding: A Simulation Study9
Numerical Study of the Cold-Start Process of PEM Fuel Cells with Different Current Density Operating Modes9
Effects of Exhaust Gas Recirculation under Fueling Rate or Air/Fuel Ratio–Controlled Strategies on Diesel Engine Performance and Emissions by Two-Zone Combustion Modeling9
Electric Vehicle Charging via Machine-Learning Pattern Recognition8
Effects of Local Thermal Accumulation Conditions on the Thermal Characteristics of Lithium-Ion Batteries under High-Rate Charging8
Feasibility of Blockchain-Based Energy Trading within Islanded Microgrids in Alexandria, Egypt8
Energy Trading and Management Strategies in a Regional Integrated Energy System with Multiple Energy Carriers and Renewable-Energy Generation8
Effects of Ethanol, n-Butanol, and n-Pentanol Addition to Diesel Fuel on Combustion and Emission Characteristics in a Common-Rail Diesel Engine with Exhaust-Gas Recirculation8
Research on PEMFC Internal Temperature Predictions and Thermal Management Strategy Based on a Kalman Algorithm8
Effects of Lignite Predrying Degree on the Combustion and NO Generation in a 600-MW Lignite-Fired Boiler8
Early Prediction of Remaining Useful Life for Grid-Scale Battery Energy Storage System8
Combustion Characteristics of Biogas Fuel Using Particularly Simplified Reaction Mechanism for HCCI Engines8
An Investigation of Emulsified Heavy Fuel Oil with High Water Content Applied to a High-Speed Diesel Engine8
Experimental Investigation of the Effect of Direct Water Injection on Combustion, Knock, and Emissions for LPG-Diesel Dual-Fuel Engine8
Thermodynamic, Economic Analysis, and Multiobjective Optimization of a Novel Transcritical CO2 Rankine Cycle with a Vortex Tube8
Joint Planning of a Distribution System and a Charging Network for Electric Vehicles7
Effects of Combustion and Emissions of Turbulent Jet Ignition with a Small-Volume Prechamber for a Gasoline Engine7
Thermal Analysis of Lightweight Clay Bricks with Typha-Fiber Additives7
Identification of Catastrophic Cascading Failures in Protected Power Grids Using Optimal Control7
Integration of Direct-Contact Membrane Distillation with Flat-Plate Solar Collector versus Proton-Exchange Membrane Fuel Cell: Dynamic Simulations and Comparative Analysis7
Differences of the Pore Structure and Methane Adsorption/Desorption between Vitrain and Durain of Low-Rank Coals: Case Study in the Huanglong Coalfield, Southern Ordos Basin, China7
Energy Management Strategy Considering Fuel Economy and Life of Fuel Cell for Fuel Cell Electric Vehicles7
Potential of Di-n-Butyl Ether as an Alternative Fuel for Compression Ignition Engines with Different EGR Rates and Injection Pressure7
Reservoir Characteristics and Major Controlling Factors of the Cambrian Xixiangchi Formation, Central Sichuan Basin, Southwest China7
Dynamic Multiobjective Optimal Dispatch of Distribution Network Considering Time of Use–Based Demand Response7
Numerical Simulation of a Lab-Scale Molten-Salt External Solar Receiver and Its Experimental Validation7
Three-Dimensional Structure Research of Anode-Supported Planar Solid Oxide Fuel Cells7
Heat Dissipation Improvement of Lithium Battery Pack with Liquid Cooling System Based on Response-Surface Optimization7
Performance Optimization and Water Management of Polymer Electrolyte Membrane Fuel Cell with Two-Direction Graded Porosity Design of Cathode Gas Diffusion Layer7
Evaluation of Energy Saving of Residential Buildings in North China Using Back-Propagation Neural Network and Virtual Reality Modeling6
Investigation of Engine Performance and Combustion and Use of Oxidation Catalysts in an LPG-Diesel Dual-Fuel Engine6
Potential for Carbon-Neutral Advanced Biofuels in UK Road Transport6
Short-Term Capacity Estimation and Long-Term Remaining Useful Life Prediction of Lithium-Ion Batteries Based on a Data-Driven Method6
Effect of Battery Thermal Management System on Temperature Distribution and Uniformity6
Non-Fourier Heat Conduction and Thermal-Stress Analysis of a Spherical Ice Particle Subjected to Thermal Shock in PEM Fuel Cell at Quick Cold Start-Up6
Analysis of Solar Chimney Application for Building Heating and Cooling in Different Climates in China6
Evaluation and Optimization of Heat Extraction Strategies Based on Deep Neural Network in the Enhanced Geothermal System6
Orthogonal Optimization of a Liquid Cooling Structure with Straight Microtubes and Variable Heat Conduction Blocks for Battery Module6
Transport Model for Gas and Water in Nanopores of Shale Gas Reservoirs6
Enhanced Probabilistic Spatiotemporal Wind Speed Forecasting Based on Deep Learning, Quantile Regression, and Error Correction6
Vertical-Axis Wind Turbine Blade-Shape Optimization Using a Genetic Algorithm and Direct-Forcing Immersed Boundary Method6
A Laboratory-Scale DEM Simulation on Multiwell Simultaneous Fracturing to Improve the Understanding of Interfracture Interference6
0.033512115478516