Rock Mechanics and Rock Engineering

Papers
(The H4-Index of Rock Mechanics and Rock Engineering is 45. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
Assessment of Microseismic Events via Moment Tensor Inversion and Stress Evolution to Understand the Rupture of a Hard–Thick Rock Stratum144
Experimental Investigation of Saturation Effect on the Mechanical Behaviour of Château-Landon Chalk120
Correction to: Experimental and Numerical Analysis of Axially Loaded Bored Piles Socketed in a Conglomerate Rock Mass118
On the Interpretability of Machine Learning Using Input Variable Selection: Forecasting Tunnel Liner Yield88
A 3D Subspring Network Breakable Voronoi Model for Rock84
Seismic Dynamic Response Analysis Method of Tunnel Considering Coseismic Dislocation83
Experimental Investigation on Strength and Failure Characteristics of Composite Rock in Contact Zone under Biaxial Compression82
Petrophysical and Mechanical Properties of Complex Structure Coalbed Methane Reservoir: A Laboratory Investigation79
Analysis of the Deformation Characteristics of the Surrounding Rock Mass of a Deep Tunnel During Excavation Through a Fracture Zone79
Experimental Investigation and Semi-Analytical Simulation of Instantaneous and Time-Dependent Damage Behaviors of Beishan Granite78
Mechanical and Fracture Behaviors of Brittle Material with a Circular Inclusion: Insight from Infilling Composition71
Rock Engineering Systems for Quantifying Risks and Controls for the Resilient Design and Optimisation of Long and Ultra-long Ore Passes69
Thermal Impact on the Excavation Damage Zone Around a Supported Drift Using the 2nd Gradient Model68
Bentonite Swelling into Voids: Different Modelling Approaches for Hydration with Technological Gaps66
A Simplified Approach to Estimate Anchoring Capacity of Blocky Rock Mass with Pressure Arch Theory66
Fracture propagation and permeability evolution mechanism of jointed rock mass in coastal mines66
Stability Analysis and Deformation Control of Tunnel with Extremely Weak Surrounding Rocks Caused by Strike-Slip Fault Activity66
Experimental Investigation of Incompatible Deformation Characteristics of Ultra-Deep Composite Rock Salt63
Heterogeneous Swelling of an Isotropically Compacted Bentonite-Based Material: Experimental Observations and Modelling62
Influence of Slot Width in Cartridge on Crack Propagation and Energy Concentration Under Explosion Load61
A Regularised Anisotropic Elastoplastic Damage and Viscoplastic Model and Its Hydromechanical Application to a Meuse/Haute-Marne URL Drift61
An Improved Discontinuous Deformation Analysis to Solve Numerical Creep Problem in Shear Direction61
Experimental and Theoretical Investigation of Initial Irreversible Critical Damage State of Red Mudstone60
Wear of Cutting Tools in Hard Rock Excavation Process: A Critical Review of Rock Abrasiveness Testing Methods60
Analysis of In-Situ Dynamic Ground Support Test Results with Insights Revealed by Time-Dependent Terms of Power and Strain Rate55
Research and Application of the Calculation Method for Vertical Stress of Interlayer Rock in Coal Mining Under Pillar Goaf55
Study on the Influence of Geological Fault Structure on the Energy Evolution of Rockbursts54
Influence of Initial Oil Saturation, Injection Velocity and Wettability on Microscopic Characteristics in CO2-Oil–Water Displacement System54
Effect of an Isolation Layer on the Seismic Vulnerability of a Shield Tunnel and Validation Through Shaking Table Tests53
Mechanical Properties of Shale After CO2 and CO2-Based Fluids Imbibition: Experimental and Modeling Study53
Surface Subsidence Observations and Strata Breaking Activity Inversion from Underground Coal Mining: A Case Study in Western China52
Loading/Unloading Response of Crystalline Rocks with Varied Thermal-Damaged Degrees to Cyclic Compression Using a Grain-Based Model52
Numerical Simulation and Experimental Study on Rock Fragmentation and Crack Propagation Characteristics with Hole Enlargement Under Impact Load51
Estimation of Cutting Forces Acting on Conical Cutters Based on Rock Properties and the Contact Area Between Cutter Tip and Rock51
Effects of Complex Triaxial Unloading Confining Stress Conditions on the Mechanical Behaviour and Fracture Mechanism of Sandstone50
Fracture Activation and Induced Seismicity During Long-Term Heat Production in Fractured Geothermal Reservoirs49
Numerical Investigation of Hydro-Mechanical (HM) Effect on Meso-Failure Properties of Granite Using Improved HM Grain-Based Model49
Dynamic Shear Fracture Behaviour of Granite Under Axial Static Pre-force by 3D High-Speed Digital Image Correlation49
A Displacement Discontinuity Approach to Simulate Pillar Stress in Multi-Reef Hard Rock Mining Layouts with a Small Middling48
A Numerical Analysis of Coal Burst Potential After the Release of the Fault-Slip Energy48
Investigation of Borehole Pressures and Rise Times for Coupled and Decoupled Blasting in Different Rock Types46
Large Deformation Characteristics and Mechanisms of Deep-Buried Foliated Basalt Tunnel: A Case Study of the Haba Snow Mountain Tunnel46
Research on Seismic Performance Evaluation Method of NPR Anchor Cables for Tunnel Crossing Fault Seismic Zones46
Influence of Mineral Veins on Hydraulic Fracture Propagation46
Role of Rock Sections in Intermittent Joints in Controlling Rock Mass Strength and Failure Modes46
Investigation into the Rock-Breaking Forces of TBM Disc Cutters with Diverse Edge Shapes45
Permeability Evolution in a Fracture in Granite During Isotropic Compression45
Comprehensive 3-D Modeling of Mining-Induced Fault Slip: Impact of Panel Length, Panel Orientation and Far-Field Stress Orientation45
Evaluating the Anisotropy of Drilling Mechanical Characteristics of Rock in the Process of Digital Drilling45
Numerical Simulation on Cross-Layer Propagation of Hydraulic Fracture in Sand–mud Interbedded Layers: Taking the Shahejie Formation in BZ 25–1 Offshore Oilfield as an Example45
0.066256999969482