Periodica Polytechnica-Civil Engineering

Papers
(The TQCC of Periodica Polytechnica-Civil Engineering is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
Evaluation of NSP and MPA Methods to Optimize Special Truss Moment Frames (STMF) Using Island Genetic Algorithm33
Influence of Size and Orientation of 3D Printed Fiber on Mechanical Properties under Bending Stress26
Mechanistic-empirical Design of Perpetual Road Pavement Using Strain-based Design Approach22
Influence of Steam Curing on the Performance of High-strength Concrete Incorporating Metakaolin21
Prediction of Restrained Shrinkage of New-to-old Concrete Interface15
Plate Buckling Assessment of Unstiffened and Uniaxial Compressed Plates through Overall Imperfection Method15
Utilization of Recyclable Concrete and Ceramic Waste as Filling Material in Hot Mix Asphalt10
Experimental and Numerical Assessment of the Seismic Behavior of Non-uniform Slit Dampers and Bar Dampers in Moment Resisting Reinforced Concrete Frames10
Reliability Assessment Methodology of Blast Protective Steel Moment Resisting Frame Using NiTi SMA-based Connection9
Experimental and Numerical Study on RC Beams Strengthened by NSM Using CFRP Reinforcements7
Investigating the Site Response Variability of Deep Sedimentary Column Induced by Varying Soil Friction Angles7
Investigation on Key Influencing Factors Affecting Temperature Distribution in Concrete7
Simple Equations for Predicting Maximum Displacement of Isolation Systems Using Lead Rubber Bearings6
Three-dimensional Discrete Element Simulation of Interaction between Aqueduct and Tunnel6
Mechanical Properties of Gas Storage Sandstone under Uniaxial Cyclic Loading and Unloading Condition6
Mechanically Stabilized Earth Wall Reliability Analysis Using Response Surface Methodology, ANN, ANFIS and Multi-objective Genetic Algorithm6
A New Approach to the Optimal Placement of the Viscous Damper Based on the Static Force Distribution Pattern6
LID Approach to Railway Track Drainage: Determination of Heavy Metal Content in the Embankment of Railway6
Optimizing of Discrete Time-cost Trade-off Problem in Construction Projects Using Advanced Jaya Algorithm6
The Effect of Mineral Composition on the Correlation between Point Load Index with the Uniaxial Compressive Strength of Sulfate Rocks and their Point Loading Deformation6
Influence of Sustainable Grout Material on the Moisture Damage of Semi-flexible Pavement5
The Effect of Irregular Seismic Loading and Soil Density on the Liquefaction Behavior of Saturated Sand5
Investigation of Cutting Rock by TBM Hob using a SPG Method5
Meso-scale Study of Bond Behavior between Ribbed Steel Rebar and Fiber-reinforced Cementitious Composite Considering Rebar Rib Geometry5
An Automated Method to Quickly Predict the Settlements of Embankments during Construction5
Simulation Model Based Response Management Related to Railway (Earthquake) Disaster5
Reliability Analysis of the Slope Stability of Homogeneous Earth Dam under Seismic Loading5
Research on the Rheological Properties of Asphalt Binder Modified by Fume Silica and Crumb Rubber Compound5
An Experimental Investigation into the Effect of Ceramic Fiber on the Fatigue Cracking of Stone Matrix Asphalt5
Generation and Evaluation of CPT Data Using Kriging Interpolation Technique5
Finite Element Analyses of Cast-in-situ RC Flat Slab with an Equivalent Frame for Horizontal Loads5
Evaluation of Static Nonlinear Behavior of Coupled Reinforced Concrete Shear Walls with Steel Beams5
Chaos-based Swarm Intelligence Algorithms for Optimal Design of Truss Structures5
A Framework for Optimization of Double Layer Grids with Supporting Cables4
Probabilistic Slope Stability Evaluation Using Hybrid Metaheuristic Approach4
Fuzzy-multi-mode Resource-constrained Discrete Time-cost-resource Optimization in Project Scheduling Using ENSCBO4
Volume of Fluid Implementation of Water Inrush and Escape Route Optimization in Tunnel4
A Comprehensive Investigation of Performance Characteristics, Mechanical Properties and Durability Parameters of Self-compacting Concrete Containing Iron Slag as Coarse Aggregate4
The Effects of Heat on the Cyclic Behavior of Retrofitted Concrete Columns (by Steel Plates and CFRP)4
Optimization of H-type Anti-slide Pile Support Structure Based on RSM-NSGA-II4
Basalt Fibers in Modified Whisker Reinforced Cementitious Composites4
Effect of Polypropylene Fibers on the Behavior of Dune Sand Concrete Subjected to Elevated Temperatures4
Effects of Non-traditional Additives on the Early Strength of a Lean Clay Soil Stabilized by Compound Calcium-based Stabilizer4
Temperature-based Evapotranspiration in the WSVI Drought Index Implementation4
Prediction of Rock's Brittleness and Dynamic Properties Utilizing Effective Artificial Intelligence Approaches4
Investigation on NSM-CFRP Ropes Shear Strengthened RC Beams with an Inclusion of Steel-reinforced Geopolymer in the Compressive Zone4
Flexural Behavior of Reinforced Concrete Beams with FRP Bars Exposed to Elevated Temperature3
Effect of Maximum Aggregate Size and Powder Content on the Properties of Self-compacting Recycled Aggregate Concrete3
Shear Strength Evaluation of Concrete Beams with FRP Transverse Rebar3
Stabilization of Clayey Soil with Alkali-activated Hybrid Slag/Cement3
Frequencies of Near Regular Structures Using the Results of the Corresponding Regular Structures3
Optimizing Landfill Capacity: A Numerical Study of the Slope Inclination Variation Impact on Landfill Storage Capacity and Its influence on the Safety Factors under Different Models3
Estimation of Rheological Effects in Cantilever Concrete Bridges on the Basis of a Span's Deflection Line3
Sensitivity Analysis of Uncertain Material RC Structure and Soil Parameters on Seismic Response of Soil-Structure Interaction Systems3
Computational Wind Engineering of a Mast-supported Tensile Structure3
Role of Nonlinearity in the Soil in Earthquake-Resistant Design of Structures3
Dynamic and Residual Pore Water Pressure Response of Hybrid Foundation System Under Combined Action of Wind, Wave and Seismic Loading3
Development of Empirical Models to Predict Gap Acceptance Parameter Based on the Geometrical and Operational Parameters of Different Roundabouts3
In-situ Primary Stress Detection Based on Seismic Tomography Measurements and Numerical Back-analysis for an Underground Radwaste Repository3
Determinate Chloride Diffusion Coefficient and Corrosion Initiation on Self-consolidating Concrete3
Mechanical Response of Thin Composite Beams Made of Functionally Graded Material Using Finite Element Method3
Investigation and Prioritization of Railway Reconstruction Projects by Using Analytic Hierarchy Process Approach Case Study: Kerman and Southeastern Areas in Iranian Railways3
Probabilistic Evaluations of Prescribed Safety Margins in Eurocode 7 for Spread Foundations3
Experimental Analysis of Out-of-plane Behavior of Masonry Infill Walls Strengthened with Textile Reinforced Mortar and Wall Post in Autoclaved Aerated Concrete Frames3
Experimental Investigation on the Dynamic Characteristics of Representative Sand and Clay in the Beijing Region3
Estimation of Bond Strength based on Corroded Hinge Beam Specimens: Assessment of Design Guidelines and Analytical Models3
Influence of Brick Waste Powder on the Shear Behaviour of Cemented Sandy Soil3
Critical Buckling Investigation of Composite Beams Under Poisson's Effect Using Nonlocal and Higher-order Shear Deformation Theories2
Development of an Alternative Bitumen Rejuvenator Consisting of Waste Oils and Reacted and Activated Rubber (RAR)2
Processes Towards Sedimentation around a Reed Island in a Shallow Lake2
Overview of the Empirical Relations between Different Aggregate Degradation Values and Rock Strength Parameters2
The Effect of Voids on Flexural Capacity of Reinforced Concrete Slabs2
Evaluation of Dynamic Properties of Sand Mixed with Expanded Glass Granules by Energy Concept Under Cyclic Torsional Loadings2
Combining Discrete Wavelet Transform and Strong Ground Motion Duration to Reduce Computational Costs in Dynamic Analysis of Structures2
Laser Scanning Ship Hulls to Support Hydrodynamic Simulations2
Laboratory Investigation and Field Performance Evaluation of Chemically Stabilized Cement Treated Subbase2
Fatigue Life and Crack Initiation of K and N Type Jacket Structure Using 3D Fatigue FE Analysis2
Evaluating the Cyclic Behavior of the Sloped Extended End-plate Beam-to-column Connections2
Simple Model of Soil-structure Interaction in Horizontal Motion Taking into Account the Nonlinearity of the Soil2
Effect of Oil Contamination on the Behavior of Collapsible Soil2
Developing Hybrid Algorithms with Fire Hawk Optimization on Concrete's Chloride Diffusion2
A Modified Reactive Powder Concrete Made with Fly Ash and River Sand: An Assessment on Engineering Properties and Microstructure2
Numerical Investigation of the Effects of Ground Motion Characteristics on the Seismic Behavior of Liquefiable Soil2
Creep Properties of Expansive Soils under Triaxial Drained Conditions and its Nonlinear Constitutive Model2
Comprehensive Review of Classes F and C Fly Ash Effects on Clayey Soils: Geotechnical Predictive Correlations2
Evaluation of Al-Thagher Wastewater Treatment Plant2
Shear Strength Prediction of FRP-reinforced Concrete Beams Using an Extreme Gradient Boosting Framework2
Deterioration Effect of Sandstone Tensile Strength and Its Mesoscopic Mechanism under Dry-wet Cycles2
Effect of Wrapping Thickness and Type on Reinforced Bridge Piers: A Numerical Study2
Thermomechanical Analysis of Glass Powder Based Eco-concrete Panels: Limitations and Performance Evaluation2
Mechanical Response and Failure Characteristics of Granite under Unloading Conditions and Its Engineering Application2
Optimization of Breakpoint Chlorination Technologies for Drinking Water Treatment: a Hungarian Case Study2
A Substructure-based Model Updating Method to Damage Detection for Large-scale Structures2
The Impact of Natural Fibers on Thermal Resistance and Spalling in High-performance Concrete2
Behavior and Strength Predictions for CFRP Confined Rubberized Concrete under Axial Compression2
Development Process of Workplace Mobility Planning in Three Pilot Locations2
Experimental Investigation of High-performance Fiber-reinforced Cementitious Composite and its Effect on RC Beams by Numerical Method2
Cycle Bases of Graphs for the Analysis of Frames Structures Using Force Method2
Cyclic Behavior of New Steel Plate Shear Walls Reinforced with Trapezoidal Corrugated Plates2
The Effect of Elevated Temperature on Ordinary Portland Cements2
Analysis of FGM Cantilever Beams under Bending-torsional Behavior Using a Refined 1D Beam Theory2
Optimization of the Engineering Properties of Cement Concrete Containing Gravel and Waste Rock Using Dense Packing and Response Surface Methodology2
Symmetry Measure of Truss Structures with Disturbed Higher-order Symmetries2
Investigation of New Energy Absorbing Mechanisms Used to Fix Rock Bolt Plates2
Effect of Coconut Fiber Content on the Properties of Unfired Building Bricks Incorporating Thermal Power Plant Ashes2
A Simplified Matrix Analysis Approach to Multi-story Buildings Involving a Friction Damper2
Effects of Local Soil Profiles on Seismic Site Response Analysis2
Simplified and Cost-Effective Method of Studying the Effect of Steel Fibers on Ultra-high Performance Concrete Specimens’ Properties/Members’ Performance2
Size Effect on Flexural and Fracture Properties of Polypropylene Fiber-reinforced Engineered Cementitious Composite2
0.072928905487061