Kagaku Kogaku Ronbunshu

Papers
(The median citation count of Kagaku Kogaku Ronbunshu is 0. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-01-01 to 2026-01-01.)
ArticleCitations
Editorial Board4
Effect of Baffle Plate on Minimum Impeller Speed for Liquid–Liquid Dispersion in Mechanically Agitated Vessels3
Development and Evaluation of Mixing Performance of New Type Large Paddle Impeller GD2203
Chromatograph Calculation Method Based on Multi-Stage Binary Phase Distribution Equilibria3
Editorial Board3
Structural Analysis of Pyrolysis Tar from a Mongolian Brown Coal using GC/MS3
Radiation Properties of Cement Clinker Fine Particles for Radiation Temperature Measurements3
Effect of polymer flocculants on lipid extraction from <i>Pleurochrysis carteraew</i> by using liquefied dimethyl ether2
Particle Size Control of Nanocapsules Immobilized with Organic Dyes2
Editorial Board2
Study of Application of Layered Double Hydroxide Derived from Zinc-Plating Wastewater to Boron Adsorbent2
Development and Analysis of Absorption Behavior of CO<sub>2</sub> Solid Sorbent Impregnated with Amine and Ionic Liquid2
Fabrication of Porous Capsules Encapsulating Lithium Adsorbent Using Polyethylene Glycol and Evaluation of Adsorption Performance2
A Discussion of Minimum Rotational Speed for Complete Suspension in Turbulent Solid–Liquid Mixing2
Preparation of Planar Lipid Bilayer Membrane by Utilizing Bicelles and Its Characterization2
Elucidation of the Cavitation in the High-Pressure Jet Device1
Stability Prediction of Oxidative Active Species in Electrolytic Sulfuric Acid1
Influence of Phase Segregation and Concentration Polarization on Heat Releasing Behavior of Latent Heat Storage Material Na<sub>2</sub>HPO<sub>4</sub>·12H<sub>2</sub&g1
Effects of Turbine Impeller Shapes and Aspect Ratio of Stirred Vessel on Exchange Rate in a Vertical Stirred Vessel with Three Multiple Impellers1
Catalyst Activity Profile Estimation and Dilution Rate Optimization on Fixed Bed Plug Flow Reactor1
Remediation of Cesium-Contaminated Natural Minerals using a Combination of Unit Operations1
Effect of Composted Exhaust Gas on Mass Change and Temperature Change during Composting1
Instrumental Analysis and Molecular Structure Analysis of Fouling Deposits Recovered from Distillation Column Reboilers in Ethylene Plants1
Quantitative Evaluation of Enzyme-Assisted Supercritical CO<sub>2</sub> Extraction of Natural Essential Oil from Yuzu Peel and Evaluation for the Functionality of the Extraction Residue1
Editorial Board1
Effects of Viscosity and Shear-thinning Properties on Interface Velocity and Deformation Behavior during Droplet Impact1
Utilization of Painting Liquid Waste Discharged from An Automobile Factory for Algal Cultivation as Phosphorus and Nitrogen Sources1
Adsorption Properties of Boron on Hydrogels Having Polyols in Side Chains1
Editorial Board1
Wall-to-Solids Heat Transfer in a Coil-Shaped Rotating Spiral Gas–Solid Contacting Device (2)1
Effect of Spray Temperature Conditions on Droplet Size Distribution by a Rotating Disk1
Thermal Transport Mechanism and Domain Discrimination of Temperature Fields Associated with Temperature Difference-Derived Density and Surface Tension Difference-Driven Convection1
Editorial Board1
Development of Selective Separation and Recovery Process of Au(III) Using Noria1
Evaluation of Potential of Starch Hydrogel Microcapsules as Artificial Feed for Bivalve1
Collecting Additional Learning Data of AI Control System for Industrial Plants0
Observation of Phase Segregation Phenomenon of Latent Heat Storage Material Na<sub>2</sub>HPO<sub>4</sub>·12H<sub>2</sub>O Melt and Supposition on Its Generation Me0
Editorial Board0
Assessment on the Strength Improvement of SOFC Anode-Supported Cells Using Y-TZP0
Performance Evaluation and Simulation of a Dehumidifying Module using Perfluorosulfonic Acid Capillary Membranes0
Evaluation of Water Dispersibility and Cell Accumulation of β-Cryptoxanthin Formulations Prepared Using Membrane Emulsification Method0
Editorial Board0
Development of m-pDS Model for Predicting Solubility of Solid Solutes in Supercritical Carbon Dioxide with a Single Modifier Addition Systems0
Visualization Measurement of Diffusion Coefficient and Soret Coefficient by using Laser Holography0
Enhancement of Water Dispersion and Caco-2 Cell Membrane Permeability of β-Cryptoxanthin by Complexation with Digested Peptides0
Derivation of a New Dimensionless Number for Evaporation and Theoretical Prediction of Saturation Vapor Pressure for Pure Substances0
Multi-Stage Reactor for CO<sub>2</sub> Methanation Process0
Editorial Board0
Editorial Board0
Influence of the Weighing Tool Shape and the Vessel Shape in the Buoyancy Weighing–Bar Method on Size Distribution Measurement of Floating Particle0
Seawater Quality Control in Shellfish Storage Tank using Foam Separator0
Automatic Detection of Self-excited Oscillations and Re-Tuning of Poorly Tuned PID Controllers0
Extraction of Useful Components from Olive Pomace by Pressurized Hot Water Treatment0
Editorial Board0
Investigation of Surrogate Models for Combustion Simulation of Palm Oil Methyl Ester0
Classification Evaluation Method Considering the Effect of Specific Gravity Sorting in Air Classification—Case Study of Solar Panel Cell Sheets Classification—0
Reactivity and Polymerization Behavior of Imidazole-Initiated Polymerization of Epoxy Resin Containing 1,4-butanediol Type Side Group0
Effect of Additive Anion on Promoting Nucleation of Latent Heat Storage Material Na<sub>2</sub>HPO<sub>4</sub>·12H<sub>2</sub>O0
Flocculation, Sterilization, and Virus Inactivation by Combined Use of Chitosan Derived from Crab Shell and Calcined Shell Powder0
Effect of Viruses on Filtration of Polluted Water0
Editorial Board0
Editorial Board0
Development of Methods for Project Schedule Delay Risk Analysis0
Power Correlation of Several Kinds of Glass-Lined Impellers0
Studies on Flow of Latent/Sensible Heat Exchange Medium Composed of Erythritol and Silicone Oil for Improvement of Heat Transportation Efficiency0
Evaluation of Filling State and Residence Time Distribution inside Plastic Mixer using Mesh-Free Simulation0
Effect of Surface Roughness of Mixing Impeller on Power Consumption0
High-Level Dewatering of Activated Sludge Using Osmotic Pressure0
Cultivation of Blue–Green Algae, <i>Spirulina platensis</i>, in a Diluted SOT Medium with Adjusted Ion Concentration0
Production of Polyunsaturated Fatty Acids from Unused Resources Disposed in an Udon Restaurant0
Analysis of Phenomena in a Vertical Combustor™ Based on a Material/Heat Balance Model0
Editorial Board0
High Performance and Flow Visualization of Plate Heat Exchanger0
Synthesis of Silver Nanowires using <i>N</i>, <i>N</i>-Dimethylalkylamine0
Bayesian Optimization for Efficient Production of Microcapsules with Targeted Diameter Prepared through Coacervation0
Numerical Comparison between Phase Change Temperatures of Latent Heat Storage Material Na<sub>2</sub>HPO<sub>4</sub> Aqueous Solutions Measured by Thermal Cycling and Phase Dia0
Feasibility Study on Supply Chain of Hydrogen Produced from Photovoltaic Power Energy–Availability Assessment of Utilizing LNG Vaporization Cold Heat0
Editorial Board0
Advanced Production Management for Chemical Plants: Design and Evaluation of Efficiency and Decarbonization Balanced KPIs0
Effect of Proteins and Polysaccharides on the Adsorption of Cellulose Fibers in <i>Geotrichum</i> sp. M111-M30
Liquid-Liquid Extraction of Metals Using Environmentally Friendly Fluorinated Solvents0
Pb<sup>2+</sup> Adsorption of Spray-Dried Na-FAU Zeolite0
Effects of Operational Conditions on the Extraction of Rhodium by Liquid Surfactant Membranes Containing Imidazolium Cations as a Carrier0
Combined Infrared and Convective Drying of All-biomass Wet Extruded Products0
Effect of Roughness of Mixing Impeller Edge on Power Consumption0
AI and Simulation for Soft Sensors and Process Control0
A Method for Estimating Critical Molar Volume Based on the Thermal Pressure Coefficient at the Critical Point0
Numerical Analysis of the Effect of the Non-phase-change Gas on the Atmospheric CO<sub>2</sub> Decompression Capture Characteristics by Cryogenic Heat (Formulation Based on Unsteady Lumped0
Enhancement of Side-Wall Heat Transfer in Solid–Liquid Agitation Tank by Addition of Large Particles0
A Method for Estimating Initial Reaction Rate based on Akaike’s Information Criterion0
Mixing of Plastic Fluid with Large Paddle Impeller0
Evaluation Mixing Performance of New Type Axial Flow Impellers HR320 and HR320S0
Development of New Multipurpose Transformable Multiple Impeller (Advanced Mixing Impeller) for Highly Viscous Fluids0
Measurement the Solubility of Decanoic Acid-Modified Ceria Nanoparticle+Organic Solvent Systems and Correlate with Activity Coefficient Equations0
Anomaly Detection of Continuous Wet Granulation using Multivariate Statistical Process Control (MSPC)0
High-Pressure Vapor–Liquid Equilibria Measurement of Carbon Dioxide–Ethanol–Water Systems and Prediction with the Peng-Robinson Equation of State for Supercritical Fluid Extraction and Separation Proc0
Perfect Conversion of Methylcyclohexane Dehydrogenation under Superheated Liquid-Film Conditions0
Editorial Board0
Effective Use of Composted Exhaust Gas by a Two-Tank Continuous Composter0
Washing Effect of Ultra-Fine Ozone-Rich Bubble Mixtures on Fresh Vegetable in a Range of Low Temperatures0
Effect of Coexisting Bacteria on Growth of Blue-Green Algae, <i>Spirulina platensis</i>0
Dry Reforming of Methane using a Catalyst-Spouted Bed DBD Plasma Reactor0
Editorial Board0
Chemical Composition Analysis and Kinetic Analysis of Oxidation of Coke Deposits Recovered from Cracking Furnaces in Ethylene Plant0
Characteristics of Decalin Dehydrogenation under Superheated Liquid-Film Conditions0
Editorial Board0
Editorial Board0
Preparation of Mesoporous Silica Materials MCM-41 and SBA-15 Using a Template Extraction Method with Supercritical CO<sub>2</sub>0
A Case Study on the Practical Use of Simulation in Process Design for Continuous Carbon Fiber Recycling0
Application of HB Impeller from Test Tube to Pilot Scale Mixing Vessel0
Evaluation of Grinding Performance of Cutter-Type Disk Mill with Different Particulate Feeding Rates0
Methane/Ammonia Co-combustion Analysis by CFD Using a Simplified Reaction Mechanism Model Applicable to Industrial Furnaces0
Effect of Additive Cation on Promoting Nucleation of Latent Heat Storage Material Na<sub>2</sub>HPO<sub>4</sub>·12H<sub>2</sub>O0
Improvement of Silver Catalyst Performance in the Oxidation of Ethyl Acetate Gas0
Exchange Rate in a Vertical Stirred Vessel with Two Multiple Impellers0
Advanced Production Management for Chemical Plants: Design and Evaluation of Efficiency and Decarbonized Balanced KPIs for Operators0
Effectivity Assessment on Supply Chain of Hydrogen Derived from Wind Power Generation: In Case of Using LNG Cold Heat0
The Prediction of Self-Induced Oscillations in Horizontal Cylindrical Vessel using CFD and Elucidation of Their Generation Mechanism0
Editorial Board0
Numerical Analysis of the Effect of the Non-Phase-Change Gas on the Atmospheric CO<sub>2</sub> Decompression Capture Characteristics by Cryogenic Heat (Temporal Change of Various Quantitie0
Editorial Board0
Editorial Board0
Study on Restraining Effect of Frost Crystal Generation by using Micro-Machined Cooling Surface0
Editorial Board0
Investigation of a Static <i>k</i><sub>L</sub><i>a</i> Measurement Method Using an Optical Dissolved Oxygen Sensor with Fast Response Time0
Characteristics of Reaction and Temperature in Catalytic Reactors for CO<sub>2</sub> Methanation0
Optimization of Multiple-Fan Air-Cooler Control in a Distillation Column0
Editorial Board0
0.63621211051941