OOIR: Observatory of International Research

Papers

(The H4-Index of Journal of Power Sources is 78. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-08-01 to 2025-08-01.)

Article	Citations
Understanding slurry formulations to guide solution-processing of solid electrolytes	355
Dendrite-free and long-standing aqueous zinc metal battery achieved by in-situ grown hydrophilic Coordination Supramolecular Networks	294
A light-weight sponge catalyst for hydrogen generation from liquid hydrogen carriers	249
Dynamic surface protective layer on a metallic lithium anode with electronic and ionic dual conductivity	240
Targeted stabilization of solid electrolyte interphase and cathode electrolyte interphase in high-voltage lithium-metal batteries by an asymmetric sustained-release strategy	214
Heterogeneous pore-scale model analysis of micro-patterned PEMFC cathodes	209
Ultrastable Na-TiS2 battery enabled by in situ construction of gel polymer electrolyte	201
Electronic structure and absorption characteristics of two-dimensional perovskites Csn+1PbnCl3n+1 (n = 1, 2, and 4): Co-regulation of the number of layers and Ge doping concentration	193
Corrigendum to “Cycle parameter dependent degradation analysis in automotive lithium-ion cells”. Journal of Power Sources, Volume 506, 15 September 2021, 230227	180
Fluoroethylene carbonate as co-solvent for Li(Ni0.8Mn0.1Co0.1)O2 lithium-ion cells with enhanced high-voltage and safety performance	177
Nanodiamonds assisted synthesis of porous hollow carbon microsphere as an efficient anode in lithium-ion battery over 13000 cycles at 20 C	175
Binder-free tin (IV) oxide coated vertically aligned carbon nanotubes as anode for lithium-ion batteries	165
Lithium exchange across a lithium-less coating for high energy cathodes	162
Engineering peripheral S-doped atomic Fe-N4 in defect-rich porous carbon nanoshells for durable oxygen reduction reaction and Zn-air batteries	161
Real-time capable transient model of liquid water dynamics in proton exchange membrane Fuel Cells	160
In-situ analysis of anode atmosphere in a flat-tube solid oxide fuel cell operated with dry reforming of methane	152
High-performance aqueous sodium-ion storage using scalable and surfactant-free flower-like manganese oxide/reduced graphene oxide electrodes	144
Halogen enabled aqueous flow cells for large-scale energy storage: Current status and perspectives	134
Determination of a sodium-ion cell entropy-variation	132
A glass fiber reinforced crosslinked polyurethane-based composite electrolyte with high mechanical strength and large ion conductivity	131
A novel nonlinearity-aware adaptive observer for estimating surface concentration and state of charge of lithium-ion batteries	126
Fabrication of visualized NO gas sensing system operable at near room temperature	123
Editorial Board	123
Identifiability study of lithium-ion battery capacity fade using degradation mode sensitivity for a minimally and intuitively parametrized electrode-specific cell open-circuit voltage model	122
Performance-optimized diatom-SiO	121

Accurately control the micropore/mesopore ratio to construct a new hierarchical porous carbon with ultrahigh capacitance and rate performance	116
Experimental and simulation study on CO2 transport mechanism during CO2 electroreduction	113
A kinetic study on cobalt-free high-nickel layered oxide cathode materials for practical lithium-ion batteries	113
Features of cycling of lithium-sulfur cells with electrolytes based on sulfolane solutions of LiPF6 and LiBF4	112
Engineering strong electronegative nitrogen-rich porous organic polymer for practical durable lithium-sulfur battery	110
A surrogate-assisted uncertainty quantification and sensitivity analysis on a coupled electrochemical–thermal battery aging model	103
A PVB electrolyte film and its application in electrochromic laminated glass	103
Increase the efficiency of lead sulfide colloidal quantum dots solar cells by incorporating In2O3 and NiO interlayers	102
Investigating proton exchange membrane water electrolyzers (PEMWE) performance losses through the galvanostatic intermittent titration technique (GITT) for electrolyzers	101
A chemical-mechanical ex-situ aging of perfluorosulfonic-acid membranes for fuel cells: Impact on the structure and the functional properties	101
State of temperature detection of Li-ion batteries by intelligent gray box model	100
Multiple heteroatom-doped cobalt sulfoselenide@C yolk-shell microsphere as excellent anode materials for sodium-ion batteries and their conversion reaction mechanism with sodium ions	98
Toward high-performance sodium storage cathode: Construction and purification of carbon-coated Na3V2(PO4)2F3 materials	98
Heterostructured nickel/vanadium nitrides composites for efficient electrocatalytic hydrogen evolution in neutral medium	96
A hybrid system integrating solid oxide fuel cell and thermo-radiative-photovoltaic cells for energy cascade utilization	95
Graphene electrode functionalization for high performance hybrid energy storage with vanadyl sulfate redox electrolytes	94
Dopant-grading proposal for polysilicon passivating contact in crystalline silicon solar cells	94
A novel method of EIS application in online fault diagnosis of high-temperature PEMFC with CNN	94
MoS2–CoS2 heteronanosheet arrays coated on porous carbon microtube textile for overall water splitting	93
On the formation and properties of amorphous and crystalline Li3-yBay/2OCl electrolytes	92
A multi-site strategy for boosting Li-CO2 batteries performance	92
Editorial Board	89
Editorial Board	88
Editorial Board	87
Editorial Board	87
Understanding mechanisms of fast sodium storage kinetics for MXene/MoS2@C in ether electrolytes	86
Accelerated stress test study on CO-tolerant PtRu anode catalysts for reformate PEM fuel cells	86
Dual-modified Co-free Ni-rich LiNi0.94Mg0.01Al0.05O2 cathode materials for enhancing Li-ion battery performance	86
Impact of applied potential range on corrosion behavior of stainless steel oxygen evolution electrode under potential cycle loading	85
Molecular design of high-voltage electrolytes for supercapacitors via steric hindrance effects	85
Glyoxal-based electrolytes in potassium-ion capacitors	85
Rational design of hierarchical crystalline/amorphous hybrid copper tetracyanoquinodimethane and CuWO4 hetero-arrays as effective electrode materials for supercapacitors	85
Towards in-situ detection of nascent short circuits and accurate estimation of state of short in Lithium-Ion Batteries	84
Electrochemical-mechanical coupled interfacial degradation model of Ternary polymer composite cathodes in all-solid-state batteries	84
Thermal measurement of a unitized regenerative fuel cell during mode switching using thin film sensors	84
MnO2 quantum dots uniformly dotted on MOF-5 derived carbon nanowires as anode materials with superior lithium storage performance	83
Structural regulation of ferrocene-doping Cu-MOFs for enhancing thermoelectric properties of single-walled carbon nanotube-based composite films	83
Tailoring barium doped cobalt-free nanocomposite cathodes for high-performance solid oxide fuel cells	83
Influence of defects on enhancing lithium diffusivity in crystalline silicon anodes for fast charging lithium-ion batteries	82
A computational workflow for the simulation of solid state battery electrodes from manufacturing to electrochemical performance	82
The electrochemical oxidation of butanediol isomers in an alkaline direct liquid fuel cell	82
Impact of nickel electrode geometry on the electrochemical performance and bubble dynamics of a zero-gap alkaline electrolyzer	82
Temperature-dependence of calcination processes of Ni-rich layered oxides	80
Malonic-acid-functionalized fullerene enables the interfacial stabilization of Ni-rich cathodes in lithium-ion batteries	80
Dual-interface passivation to improve the efficiency and stability of inverted flexible perovskite solar cells by in-situ constructing 2D/3D/2D perovskite double heterojunctions	80
Nanoporous Pd cathode with outstanding methanol resistance for direct methanol fuel cell	80
Thermal plasma synthesis towards upscaling of multi-cation lithium nickel manganese cobalt oxide cathodes	80
A novel anode of gold nanoparticle coated Au nanorod arrays for nonenzymatic glucose fuel cells	80
Systematic and predictive trends to chromium poisoning in solid oxide fuel cell cathodes	80
“There is plenty of energy at the bottom”: A spectral conversion approach for upconversion-powered water-splitting PEC cell	80

Flexible high-capacity and long-cyclability hydrogel batteries enabled by polyvalent vanadium ion redox chemistry	79
Incorporation of nitrogen and oxygen in carbon: A highly tuned electrochemistry with facile synthesis and its influence on optical and electrode performance in supercapacitors	79
Effective approaches to produce high performance single-walled carbon nanotubes/platinum based hybrid films by inserting thermoelectric material with high seebeck coefficient	79
A novel MXene coated liquid crystal display anode derived from a futile computer monitor for microbial fuel cell application	78
An insulating material in a structured host enables sustainable formation of a granular Li metal for highly durable Li metal battery	78
Coaxial spiral structural polymer/reduced graphene oxide composite as a high-performance anode for potassium ion batteries	78
Visualization of oxide ion incorporation in CO2 electrolysis on LSCM-based cathodes of solid oxide electrolysis cell	78