OOIR: Observatory of International Research

Papers

(The median citation count of Circuit World is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-05-01 to 2025-05-01.)

Article	Citations
A fast and cost-effective short circuit protection scheme for low-power converters for small-scale photovoltaic application	21
Design and implementation of a single-phase buck-type inverter via an efficient hybrid control technique	19
Investigation of integrated converter circuit and enriched error tolerant fuzzy logic controller based control approach for solar powered EV system	17
A novel design of nano router with high-speed crossbar scheduler for digital systems in QCA paradigm	16
Circuit analysis and modeling of a soft-switching pulse power supply based on full-bridge inverter for DBD application	14
Voltage sag compensation at load side in armor fighting vehicles using ultra capacitor	13
Review and design of modular multilevel inverter with modified multicarrier PWM techniques for solar PV applications	7
A pulsed bipolar current-mode power supply with high power factor in a single stage for dielectric barrier discharge application	6
Canard-induced mixed mode oscillations as a mechanism for the Bonhoeffer-van der Pol circuit under parametric perturbation	6
A new approach to bypass wire crossing problem in QCA nano technology	6
Comparative analysis of two-level and three-level multilevel inverter for electric vehicle application using BLDC motor drive	6
A neoteric closed loop feedback controller based on correlative-elemental curvature algorithm	5
Design and fabrication of rotary magnetostrictvie energy harvester for knee-joint wearable applications	5
Radial basis function neural network MPPT controller-based microgrid for hybrid stand-alone energy system used for irrigation	5
Investigation on reliability of classical industrial motor drives using GoldSim Monte Carlo reliability workbench	4
Wire length optimization of VLSI circuits using IWO algorithm and its hybrid	4
Supply less sensitive ring voltage-controlled oscillator for microwave L-band frequencies	4
Performance enhancement of switched reluctance motor drive using front-end converter	4
Design of ternary subtractor using multiplexers	4
A 10-bit 200 MS/s pipelined ADC with parallel sampling and switched op-amp sharing technique	4
A low power high speed single phase clock level restoring 16T master-slave flip-flop	4
A new approach for task managing in the fog-based medical cyber-physical systems using a hybrid algorithm	4
Research on circuit analysis and optimization of wireless power transmission system with embedded coil	4
Design of a fractional-order chaotic secure communication circuit based on sliding mode theory and microcontroller	3
A compact broadband high power quasi-MMIC GaN power amplifier	3

Analysis, design and experimentation of high-pass negative group delay lumped circuit	3
Linearisation of flow sensors using evolutionary optimised function-based methods	3
Forty five nm CMOS low power multilevel active feedback transimpedance amplifier for optical receivers	3
Low-power and low-energy CNFET-based approximate full adder cell for image processing applications	3
Experimental verification of STATCOM based on quasi impedance source inverter for power quality enhancement in the hybrid distributed generation system	3
Light-load performance optimization for LLC resonant converter	3
Performance investigation of doubly salient outer rotor switched reluctance motor using finite element analysis	3
Performance analysis of FEC based SR motor drive using fuzzy tuned PI controller	3
Hidden multiwing chaotic attractors with multiple stable equilibrium points	3
Memristive combinational logic circuits and stochastic computing implementation scheme	3
Suitability of passive RC-network-based inductorless bridged-T as a bandpass NGD circuit	3
A compact high gain wideband millimeter wave 1 × 2 array antenna for 26/28 GHz 5G applications	3
An inductorless piezoelectric energy harvesting interface circuit using gyrator induced voltage flip technique	3
Effects of additives on via filling and pattern plating with simultaneous electroplating	2
A new hyperchaotic system from T chaotic system: dynamical analysis, circuit implementation, control and synchronization	2
Guest editorial	2
Optimized DA-reconfigurable FIR filters for software defined radio channelizer applications	2
An analytic method for parameter extraction of InP HBTs small-signal model	2
Design and implementation of artificial magnetic conductor surface as decoupling structure in microstrip antenna arrays	2
A self-powered ultra-low-power intermittent-control SSHI circuit for piezoelectric energy harvesting	2
Novel step-down topologies of star-connected autotransformer	2
An energy-aware approach for resources allocating in the internet of things using a forest optimization algorithm	2
A novel higher-order sliding mode control for DC-DC boost converter system in PMDC motor exploring mismatched disturbances	2
Fault diagnosis of wind turbine power converter using intrinsic mode functions with relative energy entropy	2
Hardware implementation of a novel hybrid MPPT technique for fast tracking of GMPP in solar PV system under PSCs	2
Cumulative degradation methodology to predict reliability of electronic systems	2
A high-power PCCM LED driver based on GaN eHEMT with hybrid dimming modes	2
Comparative study on minimization of conduction and switching losses in cascaded multilevel inverter via reduced switches and equal voltage source-sharing	2
Grid-connected solar photovoltaic-fed brushless DC motor drive for water pumping system using colliding body optimization technique	1
Research and optimization design of two-stage isolated inverter power supply based on series quasi-resonance	1
A new technique for right half plane zero elimination from dynamics of a boost converter using magnetic coupling concept	1
Optimization design of dead time in the four-switch buck-boost LLC resonant converter	1
A modified model of conductor roughness for manufacturing copper lines of printedcircuit board	1
Analysis of output characteristics of wireless power transfer system based on LCC/S-S hybrid compensation structure	1
TPTPC and BHC integrated grid connected energy storage system for power loss reduction	1
Comparative analysis of dual second-order generalized integrator-phase locked loop based series hybrid filter and static synchronous compensator for load voltage compensation and power quality improve	1
Analysis and circuit design of isolated forward SEPIC converter with minimum-phase stability	1
High speed data encryption technique with optimized memory based RSA algorithm for communications	1
Design and mathematical analysis of a 7T SRAM cell with enhanced read SNM using PMOS as an access transistor	1
Optoelectronic characterization of laser diodes with different electrode structures	1
A compact, broadband three-way substrate integrated waveguide power divider with improved isolation	1
The power control and efficiency optimization strategy of dynamic wireless charging system for multiple electric vehicles	1
An ultra-low noise pseudomorphic high electron mobility transistor (pHEMT)-based low noise amplifier using low temperature co-fire ceramic (LTCC) technique	1
Fabrication of vibration sensors using precursor molar concentration varied ZnO nanostructures grown by refresh hydrothermal method	1
Five-dimensional memristive Hopfield neural network dynamics analysis and its application in secure communication	1
Parameters optimization design method for LLC resonant converter based on impedance model	1
Intelligent series inducing switching scheme (ISISS) to enhance power delivery in shaded photovoltaic array	1
Dynamic warpage simulation of molded PCB under reflow process	1
Novel configurations for cascaded multilevel inverter with hybrid and asymmetric architecture	1
Extended hybrid cross-switched multilevel inverter circuit topology	1