OOIR: Observatory of International Research

Papers

(The H4-Index of Ceramics International is 80. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)

Article	Citations
Preparation of La2Zr2O7 nanopowders via a novel tartaric coprecipitation method	286
Layered rare-earth stabilized Bi2O3: Organic amines intercalation under ambient conditions and their role as a solid adsorbent for iodine	235
Effects of TiO2 nanobelts addition on microstructure and physical properties of vitrified bonds	182
Unleashing the potential of a new Y–BaTiO3/graphene oxide nanocomposites for boosting the dielectric stability at high temperature	169
La2(Zr0.7Ce0.3)2O7:Eu photoluminescence piezo-spectroscopy applied in thermal barrier coatings	165
Pseudocapacitive properties of cobalt molybdate hydrates with biomimetic shark tooth structures induced by cation doping	163
Sudden drop in friction coefficient of extruded Mg matrix composites	157
Enhanced linear and nonlinear optical characteristics of cerium (Ce) doped ZnO film	152
Near-infrared-emitting (Gd1-Nd )3(Ga1-Cr )5O12 glass ceramic phosphors for light-emitting diodes	147
Alteration in structural, spectral, magnetic and dielectric properties of cobalt ferrite NPs through manganese substitution	147
Size-controlled preparations of tungsten and molybdenum borides in calcium or aluminum melt	144
Capture of SiC/amorphous SiO2 core−shell nanowires from rice husk ash within 25 seconds by dynamic magnetic field	143
Crystal structure, chemical bonds and microwave dielectric properties of ultra-low loss Li2Mg2GaTi2O8F ceramics	143
Thick (AlTiCrNbTa)O2 high-entropy ceramic coating: Efficient fabrication and characterization	142
Improved photoelectrocatalytic degradation of methylene blue by Ti3C2Tx/Bi12TiO20 composite anodes	142
The effect of element type and sintering temperature of MFe2O4 sensing electrode on gadolinium doped cerium oxide-based mixed potential triethylamine sensor	138
SHS of copper Chevrel phase compounds	137
Phase transformation and grain growth in spray deposited wurtzite CuInS2 films	131
Effect of post-annealing on structural, tribological, and adhesion properties of TiW/TiWSi/TiWSiN graded composite films	129
Optimization of SiC–ZrC high emissivity composite flexible coating for thermal protection with high interfacial bond strength and temperature resistance	125
Exploring the ambient metastability of yttrium substituted Bi2O3 electrolyte materials	125
Preparation of UN microspheres by external gelation	116
Improved temperature stability of low-fired Li2Mg3SnO6 microwave dielectric ceramics by using (La0.5Na0.5)TiO3 additives	115
Effect of TiMoTa multi-component diffusion layer prepared by double glow plasma reverse sputtering process on diamond coating growth	115
Bicontinuous nickel/tin oxide films with enhanced photoelectrochemical hydrogen production efficiency	111

Oxidation behavior and cracking evolution of atmospheric plasma spraying Si and 60Si-40HfO2 bond coats at 1400 °C	111
Growth, microstructure and magnetic properties of bixbyite structure ScFeO3: A comparative study between bulk and thin film	110
Realization of high-quality Sr4Fe6O13 epitaxial film and its phase competition with SrFeO2.5	109
Fabrication of ceramic fibers with excellent eletromechanical properties	109
Low-threshold green and red random lasing emission in inorganic halide lead perovskite microcrystals with plasmonic and interferential enhancement	108
Synthesis, characterization, and 5-fluorouracil release behavior of superparamagnetic γ-Fe2O3/ZnO hetero-nanostructures for biomedical applications	107
Development, characterization and optimization of a new bone cement based on calcium–strontium aluminates and chitosan-glycerin solution	106
Post-mortem investigation of magnesia-chromium brick corrosion by speiss in a copper smelting furnace	106
Highly efficient latent fingerprint detection from NaYF4:Eu down-shifting microparticles	104
Synthesis of ZnO nanoparticles from the medicinal plant Salvia fruticosa Mill.: Green approach for potential biomedical application against Zn deficiency in humans	103
Heterojunction-enhanced H2S sensing mechanism in on-chip NiFe2O4–CuFe2O4 nanofiber sensors	101
Donor-acceptor co-doped Ba0.675Sr0.325TiO3 filled Poly(vinylidene fluoride) demonstrating significantly enhanced tunability for tunable device applications	100
Damage characteristics and material removal mechanisms of SSiC scratched by diamond grits: comparison with RB-SiC	99
Optimized Structural Design of High-Entropy Rare Earth Disilicate Coatings via Finite Element Method and Plasma Spraying	99
Investigations on the augmented physical, thermal and optical properties of tellurite glasses containing WO3 and TiO2	99
The mechanism of low-temperature formation and corrosion resistance of ceramic coatings on cast Al-Si alloy	98
Fabrications of metal-insulator nanocomposite TiOx thin films and their dielectric properties	98
Developing a face-shear lead-free piezoelectric transducer through anti-parallel co-poling and its application to an omnidirectional piezoelectric transducer	96
A high-entropy carbon-coated Na3V1.9(Mg, Cr, Al, Mo, Nb)0.1(PO4)2F3 cathode for superior performance sodium-ion batteries	96
Visible light-driven type II p-Bi3O4Cl/n-BiPO4 heterojunction for effective photocatalytic photodegradation	94
Phenomena and mechanism of local oxidation microlithography of 4H–SiC via electrochemical jet anodisation	94
Phase equilibrium of the CaO–SiO2–Al2O3–Ce2O3 system: A basis for recovering REEs from RE-Containing slag	94
Corrigendum to “In–Zn–Sn–O Ceramic targets: Preparation following the cold sintering process and properties of the materials” [Ceram. Int. 49 (2023) 17797–17805]	93
The effect of substrate thickness on the fluorescence of single-doped Cu+ glass prepared by ion exchange	93
Thermally enhanced near-infrared luminescence in CaSc2O4: Yb3+/Nd3+ nanorods for temperature sensing and photothermal conversion	93
Concentration dependence of physical properties of low temperature processed ZnO quantum dots thin films on polyethylene terephthalate as potential electron transport material for perovskite solar cel	93
Corrigendum to “Solid particle erosion studies of ceramic oxides reinforced water-based PU nanocomposite coatings for wind turbine blade protection” [Ceram. Int. 48 (2022) 35788–35798]	91
Corrigendum to “Micromorphology tunable Eu2O3 submicron spheres reinforced boron-containing HDPE composites for neutron and gamma-ray complex radiation shielding” [Ceram. Int. 51 (2025) 2360–2372]	90
Corrigendum to “Novel B4C supports for ceramic membrane filtration” [Ceram. Int. 50 (2024) 50436–50443]	90
Pd/P–CeO2–Al2O3 coatings supported on foam ceramic with controlled morphology for high-performance CO2 methanation	89
Corrigendum to “Low-temperature pressureless sintering B4C with Si aids: Is it feasible?” [Ceram. Int. 51 (2025) 18203–18211]	89
Functionalization of anatase nanoparticles with Glutaric acid and their photochemical and photocatalytic properties under visible light	88
Tailoring the pigment properties of spinel-type Zn1-xCoxFe2O4 (0 ≤ x ≤ 1) ferrites synthesized by a sustainable gelatin-based route	88
The occupation mechanism and service stability of Ca2.5Ce0.5Zr2Fe3O12 type garnet ceramics for the immobilization of tetravalent actinides	88
A novel methodology for evaluating high temperature gas corrosion of oxide-C refractories	87
Influence of dissolved oxygen concentration on the electrochemical and semiconductor characteristics of passive oxide films deposited on Fe-based metallic glass coatings	87
The high temperature dielectric properties and temperature rise behavior of lithium hydride in microwave field	87
Evaluation of the hot corrosion stability of perovskite and spinel oxide-based inert anode materials in CaCl2–NaCl–CaO molten salts	87
Corrosion behavior of Al2O3 modified Yb2Si2O7 ceramics during water–oxygen exposure	87
Suppressing the phase decomposition of MSZ at 1273 K by doping Al, Ca and Gd oxides	86
Flexible Bi(Er3+/Yb3+)2MoO6/PAN with sensitive temperature feedback and enhanced visible light photocatalysis	86
Using tetraethyl orthosilicate to tailor the magnetic properties of hexagonal SrFe12O19 ferrites: A comparative study of liquid and solid additives	85
Employing defect luminescence of LiGaO2 to realize dynamic readout and multiplexing of optical information	84
Enhanced photoresponse in Type-II MoSe2/WS2 layered heterostructures	84
Impact of mixed heavy metal cations (Ba and Bi) on the structure, optical and ionizing radiation shielding parameters of Bi2O3–BaO–Fe2O3–SrO–B2O3 glass matrix	84
Effect of Sm doping on structure and microwave absorption properties of brownmillerite oxide Ca2Fe2O5	83
Biomimetic synthesis of strontium-substituted mesoporous platelet-like hydroxyapatite composites using gelatin type B as a protein template for bone regeneration applications	83
Liquid phase sintering of alumina–silica co-doped cerium dioxide CeO2 ceramics	83
Sustainable synthesis of iron-based electrode materials using Melodorum fruticosum Lour. leaf extract for supercapacitors	83
Preparation and comprehensive performance of carbon fiber reinforced silica-based ceramic cores	83

Pulsed laser ablation synthesis of thiol-functionalized W/Fe nanoparticles in liquid for MRI and CT imaging	82
Effects of nitrate-free synthesis on the crystallization and morphology of gel-derived bioactive glass-ceramic with 45S5 composition	82
Construction of TiO2 nanointerfaces in Yb2Si2O7 ceramics with adjustable electromagnetic wave absorption and high-temperature stability	81
Curing temperature’s effect on argillite-metakaolin based geopolymer grouts	81
Effect of CCTO nanofillers on structural and electrical properties for bone regeneration applications in PVDF/HAP/CCTO composite films	80
Ultrafast joining of YAG transparent ceramics using glass filler within 50 seconds	80
In-situ structural degradation study of quadruple-cation perovskite solar cells with nanostructured charge transfer layer	80
Enhancing sintering activity and grain boundary conductivity of GDC electrolyte via fiber-like precursor morphology and CaO addition	80