OOIR: Observatory of International Research

Papers

(The H4-Index of Precision Engineering-Journal of the International Societies for Preci is 29. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-08-01 to 2025-08-01.)

Article	Citations
Determination of the reference point of a radio telescope using a multilateration-based coordinate measurement prototype	139
Identification of unknown object properties based on tactile motion sequence using 2-finger gripper robot	112
Overall improvement of macro electrochemical jet milling by utilizing a novel cathode tool with an ultra narrow inter-electrode gap	74
Investigations on electromagnetic wave scattering simulation from rough surface: Some instructions for surface roughness measurement based on machine vison	55
Multiaxis printing method for bent tubular structured gels in support bath for achieving high dimension and shape accuracy	55
Kinematic calibration of a 5-DOF hybrid machining robot using an extended Kalman filter method	54
Coupled hysteresis and resonance control of three-degree-of-freedom tip-tilt-piston piezoelectric stage	50
Modeling the dynamic interaction between machine tools and their foundations	49
Fast soft contact motion using force control with virtual viscosity field	46
A dynamic Timoshenko beam constraint model for use in compliant mechanisms with intermediate deformation ranges	46
Enhancing pointing accuracy in Risley prisms through error calibration and stochastic parallel gradient descent inverse solution method	46
The sub-nanometer finishing surface evolution of tungsten carbide in shear thickening polishing and the effect of the impurities	43
Investigation on the machining mechanism and surface integrity in ultrasonic elliptical vibration cutting of Al-Si alloys	42
Analysis of arc plasma characteristics and energy distribution in EDM based on two-temperature model	40
Self-sensing of cutting forces in diamond cutting by utilizing a voice coil motor-driven fast tool servo	39
Analysis of the influence of passive joints on kinematic calibration of parallel manipulators based on complete error model	38
Pose error compensation based on joint space division for 6-DOF robot manipulators	38
Evaluating the standard uncertainty due to the voxel size in dimensional computed tomography	37
A piezoelectric load-sharing-based platform for measuring dynamic six-dimensional forces/moments of large equipment in spacecraft	36
Theoretical and experimental characterization of an active ferrofluid pad bearing for nanopositioning	35
Development of an optimized smart tool holder using symmetrical structure for three-axis cutting force measurement in diamond cutting	33
Development of a novel nickel-based metal force microsensor using bottom-up approach	33
Dynamic performance analysis of ball bearings with multi-factor coupling excitation	32
A flexure-based and motion-decoupled XYZ nano-positioning stage with a quasi-symmetric structure	32
Review of ultrasonic vibration-assisted milling technology	32

Modeling of the removal mechanism of monocrystalline silicon-based on phase change-dislocation theory and its edge chipping damage during micro-grinding	32
Optimizing processing stability with ionized polymers in magnetorheological finishing fluid	31
Investigating elastic recovery of monocrystalline silicon during plunging experiments with chamfered diamond tools	31
Effect of stress relief and inherent strain-based pre-deformation on the geometric accuracy of stator vanes additively manufactured from inconel 718 using laser powder bed fusion	30
An efficient method for measuring and identifying geometric and dynamic errors in dual five-axis machine tools	29
Shape defect analysis from volumetric data - Application to lattice struts in additive manufacturing	29
A review on application of laser tracker in precision positioning metrology of particle accelerators	29
Comparative study on micro-milling machinability of titanium alloys prepared by different processes: Forging process, additive manufacturing process and heat-treatment process	29