Strength of Materials

Papers
(The H4-Index of Strength of Materials is 7. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-04-01 to 2024-04-01.)
ArticleCitations
Effect of Pulse Current on Residual Stresses in AMg6 Aluminum Alloy in Electrodynamic Treatment16
Development of Full-Strength Elastic Element Section with Open Shell15
Experimental and Numerical Study of Compressive Deformation Behavior of Closed-Cell Aluminum Foam12
Finite Element Analysis of Residual Welding Stresses and Deformation for a 5A06 Aluminum Alloy Plate10
Characterization of the Influence of Rotational and Traverse Speeds on the Mechanical and Microstructural Properties of Wires Produced By the FSBE Method10
Refined Mathematical Model of the Stress State of Adhesive Lap Joint: Experimental Determination of the Adhesive Layer Strength Criterion10
Experimental Evaluation of Tensile Properties of Epoxy Composites with Added Cellulose Nanofiber Slurry9
Experimental Study on Tensile Properties of Basalt Fiber Reactive Powder Concrete7
Effects of the Measured Noise on the Failure Mechanism of Pre-Cracked Concrete Specimens Under the Loading Modes I, II, III, and IV7
Procedure and Instruments for the Material Damage Assessment by the LM-Hardness Method on the In-Service Scratching of Structure Element Surfaces7
Investigating the Failure Behavior of Gypsum Specimens with Non-Persistent Vertical Notch Under Uniaxial Compression7
0.027888059616089