Rheologica Acta

Papers
(The median citation count of Rheologica Acta is 3. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-04-01 to 2025-04-01.)
ArticleCitations
Data-driven selection of constitutive models via rheology-informed neural networks (RhINNs)36
Compatibility of the generalized BMP model and the two-fluid Langevin formulations31
Role of plasticity in the universal scaling of shear-thickening dense suspensions27
Numerical investigation of rheological behaviors of polystyrene melts in different contraction dies based on the Rolie-Poly model24
Instrument stiffness artifacts: avoiding bad data with operational limit lines of $$G_{\max }$$ and $$E_{\max }$$22
Two-tiered semi-empirical model for the viscosity of crystal-bearing magmas21
Effects of non-ionic surfactant on the formation of pellicles by Pseudomonas aeruginosa20
Non-linear dilational rheology of liquid-liquid interfaces stabilized by dipeptide hydrogels17
From Alveograph test to extensional behavior of wheat flour dough17
Bidisperse magnetorheological fluids utilizing composite polypyrrole nanotubes/magnetite nanoparticles and carbonyl iron microspheres16
Rheological and creep and recovery behavior of carbonyl iron water-based magnetorheological gel using laponite as an additive and oleic acid as a surfactant16
Coupling slip and thixotropy to model the transient rheological behaviour of kaolinite suspensions16
Influence of various pretreatments on molecular and rheological properties of a linear and a long-chain branched polypropylene15
Elastic and shear-thinning effects in contraction flows: a comparison15
Modelling elongational viscosity overshoot and brittle fracture of low-density polyethylene melts14
Analysis of startup shear flow data of linear polystyrene blends: is shear stress undershoot caused by transient shear banding?14
A small-volume microcapillary rheometer14
Experimental separation of the onset of slip and sharkskin melt instabilities during the extrusion of silica-filled, styrene–butadiene rubber compounds13
Large amplitude oscillatory shear of doughs, based on different flours, modeled using the fractional K-BKZ framework13
Modelling the effect of hydrogen bonding on elongational flow of supramolecular polymer melts12
Flow-induced phase phenomena in an entangled polyethylene/benzene solution under uniaxial elongational flow12
Rheology of non-Brownian suspensions: a rough contact story12
Nonlinear modification of the Rouse model constraining volume conservation of deforming chains12
Magnetorheological fluids: a comprehensive review of operational modes and performance under varied circumstances11
A web-based intelligent calculator for predicting viscosity of ethylene–glycol–based nanofluids using an artificial neural network model11
Analysis of post-condensation and thermo-oxidative degradation in cycloaliphatic polyamide through time-resolved rheology (TRR)11
Nonlinear mechanical behavior of elastomers under tension/tension fatigue deformation as determined by Fourier transform11
SLE3S-water system: a linear rheological characterisation11
Rheological behavior of SiO2 NP/CTAB/PPA wormlike micelles in alcohol/water mixture11
Quantification of shear viscosity and wall slip velocity of highly concentrated suspensions with non-Newtonian matrices in pressure driven flows11
Molecular dynamics of shear banding flow in associative polymers solutions: effect of sticker groups location10
Linear viscoelastic behavior of bimodal polyethylene10
Influence of carboxymethyl cellulose solutions on rheological properties of Laponite dispersions10
Machine learning methods for particle stress development in suspension Poiseuille flows9
Correction to: Molecular constitutive equation for unentangled branch copolymers9
Yield stresses of concentrated suspensions of rigid particles in the volume fraction range of 0.62 to 0.78 via steady torsional flow9
Effect of particle size distribution and shear rate on relative viscosity of concentrated suspensions9
Viscoelastoplastic classification of cementitious suspensions: transient and non-linear flow analysis in rotational and oscillatory shear flows9
Numerical modeling of fluid displacement in Hele-Shaw cells: a gap-averaged approach for power-law and Newtonian fluids8
Frequency response analysis of the Bautista-Manero-Puig model with normal stress: analytical and numerical solution for large amplitudes8
Numerical simulation of shear jamming in a shear thickening fluid under impact8
Probing the elongational rheological behaviour at interfaces of immiscible polymer melts using dilational tensiometry: effect of viscosity and temperature on the interfacial properties8
Welcoming Philippe Coussot as the next European editor8
Interactive Shear and Extensional Rheology—25 years of IRIS Software8
The upstream region radial flow and average molecular weight effect on the molten PDMS processibility8
Rheological characterization of viscoplastic fluid flow in a pipe with wall slip using in situ particle image velocimetry8
Can numerical methods compete with analytical solutions of linear constitutive models for large amplitude oscillatory shear flow?7
Yielding and rheopexy of aqueous xanthan gum solutions7
The yielding behavior of aqueous solutions of Carbopol and triethanolamine and its prediction considering the fractal nature of the formed aggregates7
Influence of dispersion liquid and silica concentration on rheological properties of shear thickening fluids (STFs)7
Stress relaxation of critically fractionated entangled polybutadiene ring melts7
Correction to: A metamodel for confined yield stress flows and parameters’ estimation7
Limits for safe viscosity measurement of non-colloidal suspensions in rotational rheometry—a numerical simulation-based approach7
Scattering-Informed Microstructure Prediction during Lagrangian Evolution (SIMPLE)—a data-driven framework for modeling complex fluids in flow6
Experimental study on shear viscosity and rheopexy of Escherichia coli suspensions6
Data-driven constitutive model of complex fluids using recurrent neural networks6
Two-dimensional glass transition–like behavior of Janus particle–laden interface6
A two-fluid model for the formation of clusters close to a continuous or almost continuous transition6
A semi-analytical approach to model drilling fluid leakage into fractured formation6
Analysis of elongational flow of star polymers6
Effect of fiber orientation on spinning dynamics for liquid crystalline polymer solutions using mesoscopic theory6
Characterization and identification of gas invasion patterns in magnesium lithium phyllosilicate suspensions6
Effect of urea on the linear and nonlinear rheological properties of human serum albumin hydrogels6
Thermo-rheological probe of microstructural evolution and degradation pathway in the flame-retarded PP/EVA/NOR/clay nanocomposites6
Linear and nonlinear shear rheology of nearly unentangled H-polymer melts and solutions6
Modeling elongational viscosity and brittle fracture of 10 polystyrene Pom-Poms by the hierarchical molecular stress function model6
Effect of aromatic and non-aromatic solvents on the interfacial viscoelasticity and self-arrangement of asphaltenes6
Correction to: Linear and nonlinear shear rheology of nearly unentangled H-polymer melts and solutions5
Statistical analysis of identification of linear viscoelastic models5
Interfacial shear and elongational rheology of immiscible multi-micro-nanolayered polymers: contribution for probing the effect of highly mismatched viscoelastic properties and modeling interfacial te5
Nonlinear shear and extensional rheology of entangled polystyrene solutions with linear and star styrene oligomeric solvents5
Correction to: Analytical approximations for the inverse Langevin function via linearization, error approximation, and iteration5
Enhanced magnetorheological effect of suspensions based on carbonyl iron particles coated with poly(amidoamine) dendrons5
Macroscopic rheology of non-Brownian suspensions at high shear rates: the influence of solid volume fraction and non-Newtonian behaviour of the liquid phase5
Investigation of process parameters and albumin concentration as foaming agent on quality of marshmallow dough: production simulation with rheometer5
Temperature effects and temperature-dependent constitutive model of magnetorheological fluids5
Rheological response of soft flake-shaped carbonyl iron water-based MR fluid containing iron nanopowder with hydrophilic carbon shell4
Physiology-based parameterization of human blood steady shear rheology via machine learning: a hemostatistics contribution4
Medium amplitude parallel superposition (MAPS) rheology of a wormlike micellar solution4
Melt strain hardening of polymeric systems filled with solid particles: review and supplementary experimental results4
Dynamics and shear banding in stress-controlled start-up shear flow of a model aging soft materials: the role of inertia and thixotropy4
The combined effect of matrix molecular weight, filler concentration, and filler-matrix interactions on the dynamic viscoelasticity of polydimethylsiloxane/clay composites4
Investigation of the well-dispersed magnetorheological oil-based suspension with superparamagnetic nanoparticles using modified split Hopkinson pressure bar4
Controlling the rheo-electric properties of graphite/carbon black suspensions by ‘flow switching’4
Rheological behavior of gel polymer electrolytes: yield stress and viscoelasticity4
Rheological characterization of complex fluids through a table-top 3D printer4
Rheological properties and the intrinsic mechanisms of fly ash/silicon-based shear thickening fluid4
Effect of sonication and succinylation on rheological properties and secondary structures of date palm pollen protein concentrate4
Experiments and numerical modelling of secondary flows of blood and shear-thinning blood analogue fluids in rotating domains4
Rheological investigation and modeling of healing properties during extrusion-based 3D printing of poly(lactic-acid)4
Viscoelastic behaviour of highly filled polypropylene with solid and liquid Tin microparticles: influence of the stearic acid additive4
3D printing of void-free glass monoliths: rheological and geometric considerations4
A computational method to simulate mono- and poly-disperse two-dimensional foams flowing in obstructed channel4
A metamodel for confined yield stress flows and parameters’ estimation3
Anticipating gelation and vitrification with medium amplitude parallel superposition (MAPS) rheology and artificial neural networks3
Exploring the gelation of aqueous cellulose nanocrystals (CNCs)-hydroxyethyl cellulose (HEC) mixtures3
The complex rheological behavior of a simple yield stress fluid3
Coagulation of blood: influence of chemical reactions on rheological response3
Nonlinear viscoelastic characteristic investigations of waxy crude oils under stress-controlled large amplitude oscillatory shear (LAOStress)3
Extensional rheology of linear and branched polymer melts in fast converging flows3
Variable entanglement density constitutive rheological model for polymeric fluids3
Rheological properties of linear and short-chain branched polyethylene with nearly monodispersed molecular weight distribution3
Modeling the density relaxation of polystyrene3
Generalized second-grade fluid flow over a tilted plate with bump topography3
Characterization of industrial low-density polyethylene: a thermal, dynamic mechanical, and rheological investigation3
Rheokinetic modeling of N-A-S–H gel formation related to alkali-activated aluminosilicate materials3
Gelation of PU elastomers: rheological characterization for liquid additive manufacturing3
Understanding the rheological properties of deformable polymer particle suspension in the melt state3
Swimming in viscoplastic fluids3
Viscosity of aqueous suspensions of titanium dioxide (anatase) nano-particles3
Rheological characterization of flow inception of thixotropic yield stress fluids using vane and T-bar geometries3
Discrepancies in dynamic yield stress measurements of cement pastes3
0.04029107093811