OOIR: Observatory of International Research

Papers

(The TQCC of Journal of Aerosol Science is 9. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-09-01 to 2024-09-01.)

Article	Citations
Influence of wind and relative humidity on the social distancing effectiveness to prevent COVID-19 airborne transmission: A numerical study	293
Risk assessment of airborne transmission of COVID-19 by asymptomatic individuals under different practical settings	164
From low-cost sensors to high-quality data: A summary of challenges and best practices for effectively calibrating low-cost particulate matter mass sensors	149
Fundamental protective mechanisms of face masks against droplet infections	139
Modeling the formation and growth of atmospheric molecular clusters: A review	103
Evaluation of decontamination methods for commercial and alternative respirator and mask materials – view from filtration aspect	94
Breath-, air- and surface-borne SARS-CoV-2 in hospitals	86
Insights into the evaporation characteristics of saliva droplets and aerosols: Levitation experiments and numerical modeling	75
A review of contact force models between nanoparticles in agglomerates, aggregates, and films	74
Overview of measurements and current instrumentation for 1–10 nm aerosol particle number size distributions	63
Effects of aerosol type and simulated aging on performance of low-cost PM sensors	60
Evaluation of nine machine learning regression algorithms for calibration of low-cost PM2.5 sensor	51
Effects of renewable fuel and exhaust aftertreatment on primary and secondary emissions from a modern heavy-duty diesel engine	40
A review of liquid sheet breakup: Perspectives from agricultural sprays	38
Optimization of an air-liquid interface in vitro cell co-culture model to estimate the hazard of aerosol exposures	37
Tutorial: Guidelines for implementing low-cost sensor networks for aerosol monitoring	37
Atmospheric clusters to nanoparticles: Recent progress and challenges in closing the gap in chemical composition	37
SARS-CoV-2 in residential rooms of two self-isolating persons with COVID-19	36
Aerosol generation from different wind instruments	35
Tutorial: Understanding the transport, deposition, and translocation of particles in human respiratory systems using Computational Fluid-Particle Dynamics and Physiologically Based Toxicokinetic model	34
Advanced aerosol technologies towards structure and morphologically controlled next-generation catalytic materials	34
Long-term evaluation and calibration of three types of low-cost PM2.5 sensors at different air quality monitoring stations	30
Perspectives for regulating 10 nm particle number emissions based on novel measurement methodologies	30
Impact of outdoor air on indoor airborne microbiome under hazy air pollution: A case study in winter Beijing	29
Viable SARS-CoV-2 Delta variant detected in aerosols in a residential setting with a self-isolating college student with COVID-19	29

Understanding vapor nucleation on the molecular level: A review	28
Evaluation of white-box versus black-box machine learning models in estimating ambient black carbon concentration	28
A systematic investigation on the effects of temperature and relative humidity on the performance of eight low-cost particle sensors and devices	27
The effects of meteorological conditions and long-range transport on PM2.5 levels in Hanoi revealed from multi-site measurement using compact sensors and machine learning approach	26
Size, concentration, and origin of human exhaled particles and their dependence on human factors with implications on infection transmission	26
Passive bioaerosol samplers: A complementary tool for bioaerosol research. A review	25
Calibration of optical particle size spectrometers against a primary standard: Counting efficiency profile of the TSI Model 3330 OPS and Grimm 11-D monitor in the particle size range from 300 nm to 10	25
Effects of dust particle sphericity and orientation on their gravitational settling in the earth’s atmosphere	24
An experimentally validated model of diffusion charging of arbitrary shaped aerosol particles	24
Atmospheric aging processes of bioaerosols under laboratory-controlled conditions: A review	24
Examination of the evolution of iron oxide nanoparticles in flame spray pyrolysis by tailored in situ particle sampling techniques	24
Outward and inward protection efficiencies of different mask designs for different respiratory activities	24
A parallelized tool to calculate the electrical mobility of charged aerosol nanoparticles and ions in the gas phase	24
Prediction of the carrier shape effect on particle transport, interaction and deposition in two dry powder inhalers and a mouth-to-G13 human respiratory system: A CFD-DEM study	24
High-efficiency dry powder aerosol delivery to children: Review and application of new technologies	23
The size-mobility relationship of ions, aerosols, and other charged particle matter.	23
The effectiveness of drones in measuring particulate matter	22
An improved numerical model for epidemic transmission and infection risks assessment in indoor environment	22
Modeling of the transport, hygroscopic growth, and deposition of multi-component droplets in a simplified airway with realistic thermal boundary conditions	22
Composite micro/nano fibrous air filter by simultaneous melt and solution electrospinning	22
Behavior of ultrafine particles in electro-hydrodynamic flow induced by corona discharge	21
A data-driven approach for characterizing community scale air pollution exposure disparities in inland Southern California	21
Efficient bi-directional coupling of 3D computational fluid-particle dynamics and 1D Multiple Path Particle Dosimetry lung models for multiscale modeling of aerosol dosimetry	21
On black carbon emission from automotive disc brakes	20
Particle emissions from mobile sources: Discussion of ultrafine particle emissions and definition	20
The effect of oral and nasal breathing on the deposition of inhaled particles in upper and tracheobronchial airways	20
The role of the driving dynamics beyond RDE limits and DPF regeneration events on pollutant emissions of a Euro 6d-temp passenger vehicle	20
Utilization of scattering and absorption-based particulate matter sensors in the environment impacted by residential wood combustion	20
New explicit correlations for the critical sticking velocity and restitution coefficient of small adhesive particles: A finite element study and validation	19
Efficacy of single pass UVC air treatment for the inactivation of coronavirus, MS2 coliphage and Staphylococcus aureus bioaerosols	18
Aerosol hazards in operating rooms: A review of numerical and experimental studies	18
Photochemistry of single optically trapped oleic acid droplets	18
Assessment of a regulatory measurement system for the determination of the non-volatile particulate matter emissions from commercial aircraft engines	18
Solid particle number emissions of 56 light-duty Euro 5 and Euro 6 vehicles	17
Technical note: Using k-means to identify soot aggregates in transmission electron microscopy images	17
Atmospheric-pressure particle mass spectrometer for investigating particle growth in spray flames	17
Risk assessment and mitigation of airborne disease transmission in orchestral wind instrument performance	17
Tutorial: Aerosol characterization with digital in-line holography	17
Computational investigation of prolonged airborne dispersion of novel coronavirus-laden droplets	17
Overview of methods to characterize the mass, size, and morphology of soot	17
Investigation on sub-23 nm particles and their volatile organic fraction (VOF) in PFI/DI spark ignition engine fueled with gasoline, ethanol and a 30 %v/v ethanol blend	17
Computational analysis of a 3D mucociliary clearance model predicting nasal drug uptake	17
Regional deposition of the allergens and micro-aerosols in the healthy human nasal airways	16
3D printer particle emissions: Translation to internal dose in adults and children	16
Investigating the effectiveness of condensation sink based on heterogeneous nucleation theory	16
Background PM10 atmosphere: In the seek of a multifractal characterization using complex networks	16
Simultaneous temporal, spatial and size-resolved measurements of aerosol particles in closed indoor environments applying mobile filters in various use-cases	16
Tutorial: The discrete-sectional method to simulate an evolving aerosol	16
Helical fluid-particle flow dynamics for controlling micron-particle deposition in a representative human upper lung-airway model	16
Orientation of non spherical prolate dust particles moving vertically in the Earth’s atmosphere	16

Estimation of the deposition of ultrafine 3D printing particles in human tracheobronchial airways	15
Particulate emissions of heavy duty diesel engines measured from the tailpipe and the dilution tunnel	15
Evaluation of the polyhedral mesh style for predicting aerosol deposition in representative models of the conducting airways	15
Multispecies aerosol evolution and deposition in a human respiratory tract cast model	15
Impact of the competition between aggregation and surface growth on the morphology of soot particles formed in an ethylene laminar premixed flame	15
An experimental investigation on the settling velocity and drag coefficient of micrometer-sized natural, IG-110, NG-CT-10 and A3-3 graphite particles	15
Antibiotic resistance genes and antibiotic sensitivity in bacterial aerosols and their comparisons with known respiratory pathogens	14
The effect of incident angle on the rebound behavior of micro-particle impacts	14
Technical note: Understanding the effect of COVID-19 on particle pollution using a low-cost sensor network	14
A comprehensive review of particle loading models of fibrous air filters	14
Morphology of particulate deposits formed on a single filter fibre by exposure to mixed aerosol flow	14
Particle synthesis by rapid expansion of supercritical solutions (RESS): Current state, further perspectives and needs	14
Air quality during and after the Commonwealth Games 2018 in Australia: Multiple benefits of monitoring	13
A molecular dynamics study of collisional heat transfer to nanoclusters in the gas phase	13
Deposition features of inhaled viral droplets may lead to rapid secondary transmission of COVID-19	13
Exceeding a resolving power of 50 for virus size determination by differential mobility analysis	13
The effect of nasal airway obstruction on the dispersion and deposition of inhaled volatile droplets in the human nasal cavity: A numerical study	13
Coated soot particles with tunable, well-controlled properties generated in the laboratory with a miniCAST BC and a micro smog chamber	13
The role of the combined use of experimental and computational methods in revealing the differences between the micron-size particle deposition patterns in healthy and asthmatic subjects	13
Improvement of aerosol spray scavenging efficiency with water mist	13
From monomers to agglomerates: A generalized model for characterizing the morphology of fractal-like clusters	13
An effect of fibrous filters modification with MTMS aerogel structure on oil mist filtration dynamics	12
Simultaneous measurement of spatially resolved particle emissions in a pilot plant scale baghouse filter applying distributed low-cost particulate matter sensors	12
Influence of agglomerate morphology on micro cold spray of Ag nanopowders	12
Numerical simulation of the aerosol formation and spreading in an air-conditioned train compartment	12
Importance of cloud motion and two-way momentum coupling in the transport of pharmaceutical nasal sprays	12
Impact of washing cycles on the performances of face masks	12
A comparative study on effective density, shape factor, and volatile mixing of non-spherical particles using tandem aerodynamic diameter, mobility diameter, and mass measurements	12
Evidence of inter-particles collision effect in airflow resuspension of poly-dispersed non-spherical tungsten particles in monolayer deposits	12
Tutorial: Langevin Dynamics methods for aerosol particle trajectory simulations and collision rate constant modeling	12
Effect of the carrier gas on the structure and composition of Co–Ni bimetallic nanoparticles generated by spark ablation	12
Technical note: Impact of face covering on aerosol transport patterns during coughing and sneezing	12
Size-resolved chemical composition analysis of ions produced by a commercial soft X-ray aerosol neutralizer	12
Assessment of air quality in car cabin in and around Paris from on-board measurements and comparison with 2007 data	12
Effects of agglomerate characteristics on their collision kernels in the free molecular regime	11
Spray characteristics from nasal spray atomization	11
Effective density and metals content of particle emissions generated by a diesel engine operating under different marine fuels	11
On the reactive coagulation of incipient soot nanoparticles	11
Monodisperse droplets and particles by efficient neutralization of electrosprays	11
Aerosol analysis using quantum cascade laser infrared spectroscopy: Application to crystalline silica measurement	11
Aerosol dynamics simulations of the anatomical variability of e-cigarette particle and vapor deposition in a stochastic lung	11
Stochastic population balance methods for detailed modelling of flame-made aerosol particles	11
Towards a concentration closure of sub-6 nm aerosol particles and sub-3 nm atmospheric clusters	10
Significance of sources and size distribution on calibration of low-cost particle sensors: Evidence from a field sampling campaign	10
A hybrid in vitro in silico framework for albuterol delivery through an adult ventilator circuit to a patient-specific lung airway model	10
Tutorial: Dynamic organic growth modeling with a volatility basis set	10
Assessment of stochastic models for predicting particle transport and deposition in turbulent pipe flows	10
Size-resolved aerosol emissions from lignocellulosic biomass and biomass constituent pyrolysis under variable dilution temperatures	10
Detection of SARS-CoV-2 in the air in Indian hospitals and houses of COVID-19 patients	10
The standard operating procedure for Airmodus Particle Size Magnifier and nano-Condensation Nucleus Counter	10
A molecular dynamics survey study of impact-induced amorphization in yttria nanoparticles	10
Effect of flow geometry on the nanoparticle output of a spark discharge generator	10
The application of statistical shape modeling for lung morphology in aerosol inhalation dosimetry	10
Combining instrument inversions for sub-10 nm aerosol number size-distribution measurements	9
Influence of aerosol electrical charging state and time of use on the filtration performance of some commercial face masks for 10–150 nm particles	9
Generating an aerosol of homogeneous, non-spherical particles and measuring their bipolar charge distribution	9
On-line compositional measurements of AuAg aerosol nanoparticles generated by spark ablation using optical emission spectroscopy	9
The impact of moderately absorbing aerosol on surface sensible, latent, and net radiative fluxes during the summer of 2015 in Central Europe	9
Characterization of a Kanomax® fast condensation particle counter in the sub-10 nm range	9
Characterization techniques for heterogeneous nucleation from the gas phase	9
Characterization of mesoscale inhomogeneity in nonwovens and its relevance in the filtration of fine mists	9
Evaluation of viral RNA extraction methods to detect porcine reproductive and respiratory syndrome and influenza A viruses from used commercial HVAC air filters from swine farms	9
Low-pressure flame synthesis of carbon-stabilized TiO2-II (srilankite) nanoparticles	9
Using two-dimensional distributions to inform the mixing state of soot and salt particles produced in gas flares	9
Influence of alveolar mixing and multiple breaths of aerosol intake on particle deposition in the human lungs	9
Inter-species variabilities of droplet transport, size change, and deposition in human and rat respiratory systems: An in silico study	9