OOIR: Observatory of International Research

Papers

(The H4-Index of International Journal of Solids and Structures is 33. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)

Article	Citations
Editorial Board	148
A chemo-mechanically coupled continuum damage-healing model for chemical reaction-based self-healing materials	107
Preface to the Special Issue on the Occasion of Professor Stelios Kyriakides’ 70th Birthday	78
The contact stress distribution in the receding contact of an elastic layer with a rigid base	61
Evolving structural tensor approach to model the damage induced anisotropy in viscoelastic solids	57
Buckling and yield strength estimation of architected materials under arbitrary loads	54
Bifurcation analysis of unbending and eversion of a bilayer	53
Dynamic digital image correlation method for rolling convective contact	49
A screw dislocation and an edge dislocation interacting with a locally rough bimaterial interface	49
Out-of-plane effect on the sharp V-notch tip fields in power-law creeping solids: A three-dimensional asymptotic analysis	48
Phase-field modelling of mechanical wave propagation in polycrystalline materials: Validation study	47
Strong C1	46
Tensile and shear interactions for graphene grown on sapphire	44
Local field statistics in linear elastic unidirectional fibrous composites	44
Insights into the viscohyperelastic response of soft magnetorheological elastomers: Competition of macrostructural versus microstructural players	42
Modeling the anisotropic behavior of highly orthotropic lithium-ion batteries polymer separators	41
Voltage-controlled non-axisymmetric vibrations of soft electro-active tubes with strain-stiffening effect	41
Sliding frictional and adhesive coupling contact analysis of FGPM layered half-space under an insulating indenter	41
In-situ measurements of contact evolution for fractal rough surfaces under normal compression	40
Investigation of unidirectional vibration isolation and nonreciprocal design of axial elastic waves based on topological pumping theory	39
Assessment of amplitude factors of asymptotic expansion at crack tip in flexoelectric solid under mode I and II loadings	38
The Valanis–Landel strain energy function Elasticity of incompressible and compressible rubber-like materials	38
Disk wrinkling under gravity	38
Data-driven probabilistic failure assessment curve based on similitude principle	38
Editorial Board	37

3D-printed highly stretchable curvy sandwich metamaterials with superior fracture resistance and energy absorption	37
Omnidirectional wave polarization manipulation in isotropic polar solids	36
Light-powered self-propelled trolley with a liquid crystal elastomer pendulum motor	35
A multiphysics framework for energy conversion from nonlinear electrostrictive dielectric elastomer generators	35
Fracture toughness and crack propagation in LX-17 and PBX 9502 insensitive high explosives	35
Effect of hydrogen on the rate-dependent deformation of superelastic NiTi shape memory alloy springs: Experimental observation and thermo-diffusional-mechanically coupled model	34
Thermoelastic behavior analysis of finite composites embedded in ellipsoidal inhomogeneities with inclusion-based boundary element method	34
Investigation of fracture patterns and effect on capacity in all-solid-state batteries based on peridynamic electro-chemo-mechanical model	34
A new path-independent interaction integral for dynamic stress intensity factors of cracked structures	33
Bond exchange reactions as a paradigm for mitigating residual stress in polymer matrix fiber composites	33
Inverse identification of plastic anisotropy through multiple non-conventional mechanical experiments	33