International Journal of Electronics

Papers
(The TQCC of International Journal of Electronics is 3. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)
ArticleCitations
A new Buck-Boost converter with capability of eliminating right-half-plane zeros45
Trapezium backed dual circularly polarised hepta-band monopole antenna32
An improved isolated DC–DC Buck converter with high step-down ratio22
Design of carbon allotrope FET-based folded cascode operational transconductance amplifiers (FC-OTA)21
Fault classification in Digital to Analog Converter using machine learning18
DC/RF performance and temperature sensitivity of ground-plane based JLTFET15
A 200 MHz 1.22 fJ/bit/search single-ended content addressable memory cell design in 45-nm CMOS technology15
A low-power, low-offset, and power-scalable comparator suitable for low-frequency applications15
Circuit fault detection model using multiclass support vector machine14
Dual-ground transformerless nine-level dynamic voltage boosting inverter topology14
Floating-capacitor based inverter for open-ended winding induction motor drive with fault-tolerance13
Design and implementation of low power multiplierless FIR filters on FPGA and ASIC13
A low-profile high gain U slotted wide band micro-strip antenna for 5G applications12
Hybrid high step-up DC-DC converter based on quadratic and switched capacitor cells with reduced voltage stress across the switches12
Miniaturized tri-band fractal antenna design for LTE, WLAN, WiMAX and C-band applications12
Linear phased meta-material incorporated patch antenna array at sub-6 GHz for 5G base stations11
Application of Lévy flight particle swarm optimisation in MPPT of photovoltaic system11
SiC MOSFET gate oxide degradation monitoring: a gate leakage current approach11
A performance assessment of nine-stage ternary DC source mli through various PWM topologies10
Design of double-integral sliding-mode controller for fourth-order double input DC - DC boost converter with a voltage multiplier cell9
Design and analysis of SRAM cell using swing restoration inverter for low power applications9
Speed sensorless control of a bearingless induction motor based on sliding mode observer with improved double power reaching law9
Parasitically loaded hexagonal-SRR mutually coupled wideband antenna for 5 G sub-6 GHz NR mid-bands9
On the ergodic capacity of MIMO-NOMA systems with JTRAS protocol under imperfect SIC and CSI9
A novel interleaved BIFRED-Zeta with intelligent MPPT for PV applications9
Efficient approximate multipliers with adjustable accuracy9
A highly efficient adaptive body bias CMOS rectifier with double-side feedback at a tone of 2.4 GHz8
A circularly polarised monopole antenna with switchable frequency, pattern and polarisation8
Enhancing the design of a two-stage CMOS operational amplifier utilising the Bat Algorithm8
Design and implementation of seven-level inverter for grid-tied photovoltaic systems8
Fractional order PID controller optimised by hybrid algorithm for instant torque control of IM motor8
High-gain transformerless voltage-lift switched-inductor converter8
Detailed analysis and modeling of an improved cascade buck converter7
Low-power ternary inverter using vertical tunnel field-effect transistor with pocket7
A low-SAR four-element antenna for ISM/NR78 band applications7
A 0.75V 10nm FinField-Effect Transistor Based Hybrid Self Controlled PreCharge Free Content Addressable Memory for Low Standby Power Applications7
Dual feedback radiation-tolerant SRAM for space application7
Design and analysis of sub-threshold level shifter for very high speed and ultra-low power applications7
Design and analysis of a dual input quasi SB-SC cell high gain converter7
An Area Efficient Approach to Realize Vedic Multiplier using 4–2 Compressor adder for Image processing Applications7
Design of a compact MOSFET model suitable for geometric programming7
Design and investigation of pocket shaped fractal antenna using circular ring elements for UWB technology with stub loaded DGS7
UDE-based robust nonlinear control of the buck-boost power converter7
Development of an ultrawide bandwidth and high gain millimeter wave antenna for 5G wireless networks6
Slotted meandered waveguide antenna for X-band radar applications6
Enhancing torque control in brushless dc motors with hybrid fractional order PID controller approach6
An improved gate-pulse rotation method for efficient voltage balancing in modular multilevel converters for railway applications6
High isolation multiport integrated antenna system for cognitive radio applications6
Design of 30 nm multi-finger gate GaN HEMT for high frequency device6
Compact metamaterial-inspired high isolation triple-band dual-polarised MIMO antenna for 3G-6G applications6
Development of adaptive cooperative jamming technique for pulse compression radar using hybrid meta-heuristic algorithm6
Design of a novel four-element Koch–Sierpinski fractal mmWave antenna for 5G applications6
Performance evaluation of a 15-level inverter using two DC sources with lower standing voltage6
Performance investigation of junctionless nanosheet FET with dual-k sidewall spacer using numerical simulations6
High-isolation coradiator-based UWB MIMO antenna for on-body IoT applications6
Grounded and floating memristor emulator employing ICCTA: decremental or incremental operation6
High gain step up converter with fault detection and fault-tolerant ability5
MBOA based PV array interconnection scheme for enlarging the harvested power under PS condition5
Super-twisting hysteresis controller for multi-rotor wind energy systems5
A 5-level T-type inverter fed six-phase induction motor drive for industrial applications5
Low RCS MIMO antenna with high isolation based on polarisation conversion surface5
Optimum Chebyshev filter with an equalised group delay response5
Design of Synchronous RF-DC Rectifier for Energy Harvesting System5
Synthesis of stacked HSC-T using improved mixed frequency PWM5
An optimised resource allocation scheme based on NOMA-SWIPT in cooperative network5
A 92.95%-efficiency high-voltage dual-mode buck converter using 0.5-µm HV CMOS process5
A Rotatable Frequency- and Pattern-Reconfigurable Antenna with a Wide Tunable Bandwidth5
Self-multiplexing textile antenna aided by SIW cavity for wearable applications5
Compact design of universal gates with non-aligned gate technology and assessment of its performance in a TCAD Environment5
Modelling and analysis of single-inductor dual-input and dual-output DC–DC converter for e-mobility5
Wireless power transfer with LCC-compensated transmitter and center-tapped receiver winding5
Optimised GRS coded cooperation: sliding relay selection design and improved joint decoding5
High-performance approximate Booth multiplier based on novel encoding scheme and 4–2 compressor5
Modulation signal identification and classification based on the OA algorithm model5
A compact quad-port slotted-spatula shaped ultra wide-band MIMO antenna for mm-Wave, 5G and beyond communications5
Improved performance of highly compact CP implantable antenna using slots4
Hybrid small-signal model parameter extraction for GaN HEMT based on QGA4
A bulk-driven quasi-floating gate regulated cascode current mirror and its application4
On-chip supply noise in multiprocessors: impact and clock gating inspired mitigation strategies4
Design and analysis of two-stage PVT-tolerant reset-free phase frequency detector for PLL frequency synthesiser in 45nm CMOS technology4
Sensorless control of an axial flux motor using square-wave injection for low switching frequencies4
Energy-Efficient approximate compressor design for error-resilient digital signal processing4
Dual-element MIMO wideband 5G radiator using metamaterials at 28GHz4
A comprehensive LPF-droop control based on virtual impedance and matching power command switching in DFIG4
Implementing comb-based FIR filters on actual FPGA boards4
A non-isolated MIC for PV application with wide input voltage range4
Design of a compact quad-port wideband printed MIMO antenna for vehicular communication environment4
Enhanced performance of full adder using advanced 9-T XOR-XNOR module4
Novel design of power-efficient quaternary logic gates using CNTFET4
Interleaved high gain modified SEPIC converter in DC microgrid systems4
Simultaneous compensation of distorted DC bus and AC side voltage using enhanced virtual synchronous generator in Islanded DC microgrid4
ANN-based design analysis of O-shaped slotted microstrip patch antenna for L band applications4
Gain enhancement of antenna using tuned complementary FSS for wireless communication4
Optimisation of asymmetries in mm-wave single-element fractal antenna for gain-bandwidth enhancement4
Variation aware resilient flip-flop design for low-voltage applications4
Design of an adaptive finite impulse response filter using low error efficient approximate adder and two-stage operand trimming approximate logarithmic multiplier for WSN in IoT4
Dual input high gain step-up converter for DC grid applications: design, dynamic control and performance analysis4
Analysis and implementation of a single switch-based non-isolated high-gain DC−DC converter for renewable applications4
Pattern diversity enabled bandwidth reconfigurable MIMO antenna4
Design and analysis of quasi-resonant high-gain impedance source DC–DC converter for DC microgrid4
Multi-objective optimisation design of stator slot parameters for bearingless induction motors4
Differential RVCO with low power, low phase noise and wider tuning range for PLL application4
Ultrawideband low-RCS metasurface optimised by an improved PSO algorithm4
A tunable graphene-VO 2 metasurface for multiband absorption-reflection switching in 6 G communication3
A novel quaternary inward inverter gate based on MIN and MAX functions3
Novel double stator switched reluctance generation system with energy storage units3
A hybrid binary logical regression -gradient decent approach for dynamic cooperative spectrum sensing in CRN3
Wideband GaN HEMT Doherty power amplifier for 5G and satellite applications3
A low complexity and high modularity design for continuously variable bandwidth digital filters3
A reduced device symmetrical-asymmetrical multilevel inverter with self capacitor voltage balancing and reduced capacitor voltage ripple3
28/38 GHz compact rhombic-shaped antenna for future generations of mobile communications3
Light load analysis and topology morphing between full-/half-bridge DC-to-DC converter3
Direction of arrival estimation via DE based-optimised excitation amplitude and spacing3
Dual-band frequency selective surface with sharp band edges3
Analysis of bridge type and bridgeless cuk converter fed motor drives for improved power quality3
Design and optimization of broadband CPW rectenna for RF energy harvesting3
Design and implementation of novel multilevel inverter with full DC-utilization3
Design and implementation of single-phase modified bridgeless positive output CSC converter3
Low-power ternary full adder/subtractor design using GNRFET technology3
Behavioural modelling of Low-Noise amplifier using the NRBO-TCN-BiGRU algorithm3
A line loss detection method for three-phase unbalanced loads in low-voltage distribution stations based on IoT sensing and swarm intelligence3
Design and optimisation of an R-shaped microstrip patch antenna using CSO and curve fitting for mmWave 5G applications3
Voltage-controlled oscillators using CFOAs with correction terminal Z3
Adaptive clustering with continuous phase modulation in NOMA systems3
Wide voltage range and low current ripple bidirectional DC/DC converter3
DSTATCOM using model predictive control associated with LMS control3
A novel square‐shaped four‐port multiband MIMO antenna with enhanced characteristics for sub 1 GHz and sub 6 GHz 5G applications3
Electromagnetic band gap metamaterials printed hybrid reconfigurable patch antenna for 5 G and beyond applications3
Dual randomized discontinuous pulse width modulation for three-phase inverter3
Frequency control enhancement of an islanded microgrid using disturbance-observer-based approach3
Impact of source/drain lateral straggle on GIDL current of low SS NC-FinFET3
CMOS Synthesis of Multiple-Valued Multiple Threshold Functions– analysis and comparison3
Improved linear/nonlinear active disturbance rejection switching control for bearingless induction motor3
Simulation-based analysis of an L-patterned negative-capacitance dual tunnel VTFET3
AI-enhanced single-phase bridgeless buck-boost AC-DC converter for high-efficiency LED driver applications3
Composite chattering-free discrete-time sliding mode controller design for PMSM3
Efficient quantum-dot adder optimisation and analysis for future circuits3
A new dual input boost converter with coupled inductors3
0.17717790603638