OOIR: Observatory of International Research

Papers

(The H4-Index of Fuel is 94. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-05-01 to 2025-05-01.)

Article	Citations
The influence of the elemental and structural chemical composition on the ash fusibility of sugarcane bagasse and sugarcane straw	436
Nonlinear multispectral tomographic absorption deflection spectroscopy based on Bayesian estimation for spatially resolved multiparameter measurement in methane flame exhaust	321
Enhancement in anaerobic biogas conversion by visible light photocatalytic Pre-treatment of rice husk with indium vanadate decorated titanium dioxide nanocomposite	311
On the mechanism of single pellet smouldering combustion	293
Exploration of the bioenergy potential of Dactyloctenium aegyptium through pyrolysis, kinetics, and thermodynamic parameters to produce clean fuels and biochemicals	282
Tuning the porosity of sulfur-resistant Pd-Pt/MCM-41 bimetallic catalysts for partial hydrogenation of soybean oil-derived biodiesel	278
Highly selective upgrading alkane into light aromatics via a Low-Concentration O2 coupling reaction strategy	278
Effect of pore-throat structure on air-foam flooding performance in a low-permeability reservoir	259
Facile preparation and characterization of MXene@Platinum nanocomposite for energy conversion applications	203
Characteristics of coal dust deflagration under the atmosphere of methane and their inhibition by coal ash	203
Reaction kinetics for the hydrothermal carbonisation of cellulose in a two-phase pathway	200
Characterization of oil-in-water microemulsions based on ethoxylated surfactant for paraffinic deposits removal	196
Optical sensing for MILD Combustion monitoring	190
Effect of ash – ZnO heat carrier on sulfur migration behavior during pyrolysis of coal	189
Editorial Board	187
A novel technique for interface analysis: Behaviour of sophorolipids biosurfactant obtained from Meyerozyma spp. MF138126 during low-salinity heavy-crude experiments	176
Energy-efficient photothermal catalysis of rubber seed oil for the preparation of biofuel compounds	176
Accurate determination of homogeneous ignition of single solid fuel particles enabled by machine learning	175
Interfacial materials and naphthenic acids from Brazilian crude oils: Colloidal characterization and water-in-oil emulsions	172
Feasibility study on application of low-grade fuels (naphtha and ethanol) in blended-fuel- and convergence-combustion modes	171
Dimethyl ether low-temperature catalytic oxidation over Rh/Al2O3 in a stagnation-flow reactor	160
Editorial Board	159
Study on the effect and performance of lanthanum-modified hydrotalcite in inhibiting coal spontaneous combustion	158
Cost analysis of kerosene production from power-based syngas via the Fischer-Tropsch and methanol pathway	158
Modulating the acidity of bimetallic functionalized Zr-based metal–organic frameworks with hierarchical porosity through solvent-free approach to enhance butyl butyrate production	150

Evaluation of the synergistic effect of platinum-supported graphene materials on methylcyclohexane decomposition via flow reactor experiments and reactive force-field molecular dynamics simulations	148
Exploring multimetal interactions between FeNi3 alloy and Lu3Ga5O12 metal oxide for improved water splitting performance	147
Editorial Board	147
Investigation into the effect of reduction treatment on the in-situ catalytic pyrolysis of distillers dried grains with solubles (DDGS) over nano-nickel-based catalyst Ni-Me/HZSM-5 (Me = La, Pd)	147
Pine-to-Bioenergy: Potential of pine sap as adhesive and pine flower biomass waste in the production of biobriquettes	141
Improving the robustness of tree-based prediction model of oil/water relative permeability through hyperparameter optimization and re-ensemble algorithm	141
Cross-method identification of hydrogenated species originating from dibenzyltoluene/(benzyl)benzyltoluene in a promising commercial LOHC product	140
Efficient hydrogen generation from ammonia borane hydrolysis over alkynyl-polyvinyl-alcohols decorated silica nanosphere supported ruthenium nanocatalyst	138
Experimental and computational investigation of guest encapsulation and structural transformation behaviors in C3H8 hydrate − CO2 replacement for energy recovery and CO2 sequestration	135
Characteristics of constant pressure dehydrogenation and construction of linear diffusion model for solid hydrogen storage materials: A case study of TiMn1.5 alloy	134
Mechanism evaluation of edge-water invasion mitigation by low temperature oxidation (LTO) coking in VHSD heavy oil reservoirs: A comparative study with traditional plugging techniques	133
Comparison between reaction products obtained from the pyrolysis of marine and lacustrine kerogens	132
Investigation into Thermal-Fluid interaction of ammonia turbulent swirling flames under various Non-Premixed burner conditions	131
A comparative study on soot and PAH formation of C10 naphthenic ring-containing species in laminar coflow diffusion flames	131
An investigation on the laminar flame propagation and auto-ignition characteristics of a coal-derived rocket kerosene-Part I: Experimental study	131
Coupling effects of heating pelleting and torrefaction on black pellets production from microalga Nannochloropsis Oceanica residues	130
Corrigendum to “Experimental and modeling study on energy flow of 250 kW alkaline water electrolysis system under steady state conditions and cold start process” [Fuel 350 (2023) 128799]	128
Preparation and demulsification performance of modified attapulgite nanoparticle demulsifier	128
Catalytic co-gasification optimization of biomass and polyethylene wastes in oxygen-rich environments	128
Laminar burning velocity of microalgae oil/RP-3 premixed flame at elevated initial temperature and pressure	127
Numerical simulation and analysis of oxygen blast furnace under different injection conditions	122
Engine performance, emission, and sustainability analysis with diesel fuel-based Shorea robusta methyl ester biodiesel blends	121
Using a fluidised bed to measure and investigate the thermal diffusivities and pyrolysis of some woods at temperatures of 200–600 °C	121
C2H2 semi-hydrogenation over Pdn/TiO2 and PdnCO/TiO2 catalysts: Probing into the roles of Pd cluster size and pre-adsorbed CO in tuning catalytic performance	120
The pyrolytic distillation of waste lubricants with waste oilfield scale into value-added fuel	120
Influences of asphaltene subfractions with different polarities on hydrate growth at water/oil interface	120
Migration behavior of two-component gases among CO2, N2 and O2 in coal particles during adsorption	119
A shortcut pressure swing adsorption analogue model to estimate Gas-in-Place and CO2 storage potential of gas shales	119
Experiments and simulations on factors affecting the stereoscopic fire flooding in heavy oil reservoirs	119
Methane hydrate dissociation from anti-agglomerants containing oil dominated dispersed systems	117
Mixing scenario of a vagarious oil in the Dongying Depression, Bohai Bay Basin	116
A Non-Equilibrium multiphysics model for coal seam gas extraction	115
Influence of porous walls on flame acceleration and flame front perturbations in methane-air and acetylene-air mixtures	115
Eco-friendly solid-state synthesis of Na-promoted Mn-Fe/ZrO2 catalyst for Fischer-Tropsch synthesis	112
High performance of K-supported Pr2Sn2O7 pyrochlore catalysts for soot oxidation	112
Artificial neural networks for speeding-up the experimental calibration of propulsion systems	112
The multi-parameter optimization of injections on double-layer diesel engines based on genetic algorithm	112
Probing the effect of distance between sediment microbial fuel cells and sediment storage on electricity generation and organic matter removal in open channels	111
Catalytic reforming of model biomass-derived producer gas	108
Mechanistic insight into the coke formation tendency during upgradation of crude oil in slurry phase batch reactor using MoS2 and its various oil soluble catalysts	108
On the composition of Sr2Fe1.5Mo0.5O6-δ – Sm0.2Ce0.8O2-δ composite as fuel electrodes for hydrogen reversible solid oxide cells	108
Numerical study on processes of oxy-fuel combustion of coal-water slurry in the furnace chamber	107
Upgrading biochar by co-pyrolysis of heavy bio-oil and apricot shell using response surface methodology	107
Understanding the promotional effect of Pt/CeO2 in cobalt-catalyzed Fischer-Tropsch synthesis using operando infrared spectroscopy at moderated pressures	106
Effect of structural evolution on the products distribution of cutinite concentrates from cutinitic liptobiolith	106
Deciphering the driving forces in low-sensitivity and high-energy materials by data mining: Insights into π-hole interactions	105
Skeletal mechanism for i-propanol-n-butanol-ethanol (IBE) and n-butanol combustion in diesel engine	105
Particulate matter emission during municipal solid waste combustion: Submicron particulates formation mechanism	105
Deep eutectic solvent assists H-β in aldol condensation of acetovanillone and p-hydroxybenzaldehyde to prepare a high density aviation oil precursor	102
Identification of slurry fuel components in a spray flow	101

Corrigendum to “Studies on individual pyrolysis and co-pyrolysis of peat–biomass blends: Thermal decomposition behavior, possible synergism, product characteristic evaluations and kinetics” [Fuel 310	100
Molecular characterization of petroleum acids from diverse geological origins via n-Butylsilane reduction	99
Corrigendum to “Gas-pressurized torrefaction of biomass wastes: The effect of varied pressure on pyrolysis kinetics and mechanism of torrefied biomass” [Fuel 276 (2020) 118132]	98
The influence of molecular structure on the oxidation reactivity of long-chain ethers: Experimental observation and theoretical analysis	98
Superhydrophobic biochars as catalysts for efficient hydrogen transfer in N-heterocycles and nitrobenzene reactions	98
Surface deposit formation of sulfur compounds in both air-saturated and oxygen-free aviation fuels	97
Understanding the reversal dilution effect of the species sampling in the negative temperature coefficient region	97
Impedance modeling and stability analysis of electrolysis system for hydrogen production under weak grid	97
A weakly nonlinear analytical model for the transversely forced flame describing function of a slit flame	96
Application assessment of UV–vis and NIR spectroscopy for the quantification of fuel dilution problems on used engine oils	96
Effect of purified dust from CaC2 production and bottom ashes/slags on slagging characteristic of Zhundong coal blend	95
Combustion mechanism of nanobubbled dodecane: A reactive molecular study	95
Hydrotreated vegetable oil as enabler for high-efficient and ultra-low emission vehicles in the view of 2030 targets	95
Chemical kinetics simulation on nitrogen migration characteristics during co-combustion of ammonia and coal under deeply fuel-air multistage conditions	95
Predominant performance of a nitrogen-doped carbon confined NiCo alloy catalyst fabricated by a natural resource encapsulation strategy for tandem catalytic nitroarenes with alcohols	95
Experimental investigation of heating values and chemical compositions of selected fuel woods as bio-fuel sources in developing countries	94
Experimental study of real-time temperature-dependent nonlinear deformation of sandstone	94
Morphological and hydrodynamic properties of hydrates during dissociation in sediment	94
Effects of torrefaction on ash-related issues during biomass combustion and co-combustion with coal. Part 2: Ash fouling behavior	94
Effects of non-premixed H2 injection on the stability, shape, and combustion/emissions characteristics of premixed CH4/air flames: An experimental study	94