Clay Minerals

Papers
(The median citation count of Clay Minerals is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)
ArticleCitations
Geopolymer mesoporosity investigated by intrinsic ionic conductivity using complex impedance spectroscopy25
Formulation and release kinetics of ibuprofen–bentonite tablets22
Effect of calcium solution on the mineralogy of the clay fraction and the swelling of clay soils20
Effective removal of hexavalent chromium with magnetically reduced graphene oxide bentonite14
Rare earth element adsorption experiments onto kaolinite in water, NaCl, Na 2 SO 4 and NaHCO 13
Efficient degradation of tetracycline via iron(II,III) oxide nanoparticle-activated hydrogen peroxide: mechanisms and performance11
An appreciation of Covadonga Brime (1950–2023)10
Application of supported Cu–Ru catalysts for the removal of trace olefins in aromatics10
Effects of clay activation and amine chain length on silica–palygorskite heterostructure properties10
Bruce Velde (1938–2024)9
The Clay Minerals Group (CMG): 1947–20228
Adsorption of gold nanoparticles on illite under high solid/liquid ratio and initial pH conditions8
Characterization of clays from the Fez area (northern Morocco) for potential uses in the ceramics industry8
Role of particle gradation of clay–sand mixtures on the interfacial adhesion performance of polymer coatings7
Optimized purification procedure for Iranian calcium bentonite for producing montmorillonite nanosheets7
Adsorption of lead by kaolinite, montmorillonite, goethite and ferrihydrite: performance and mechanisms based on quantitative analysis7
Microstructural observations of clay-hosted pores in black shales: implications for porosity preservation and petrophysical variability6
Changes in the basic structure and strength deterioration of clay minerals with different hydration degrees6
Natural and pretreated Gördes clinoptilolites for ammonia removal: effect of exchangeable cations (Na+, K+, Ca2+and Mg2+)5
Characterization of the clayey sediments in the exposed mudflats of the western Dead Sea shore5
The clayey deposit from Bomkoul (Douala, Cameroon): a case study of the geotechnical appraisal and assessment of the characteristics of firing bricks5
CLM volume 58 issue 1 Cover5
Comparison of the antimicrobial and antioxidant properties of halloysite nanotubes and organoclays as green source materials5
Synthesis and characterization of nano-silica from locally available laterite clay5
Thermophysical and viscoelastic properties of 3,4-dihydro-2H-pyran-containing, polymer-layered, clay-reinforced nanoarchitectures5
CLM volume 57 issue 3-4 Cover and Front matter5
Influence of the clay fractions from various horizons on the radiation shielding parameters of an Arenosol5
Production of lightweight expanded aggregates from smectite clay, palygorskite-rich sediment and phosphate sludge4
Coastal processes affecting the clayey sediments of the exposed mudflats on the receding western Dead Sea shore4
Identifying clay minerals and accessory phases by oxide composition using MinMatch4
Rare earth elements in phyllosilicates4
Study of the adsorption mechanisms of NH3, H2S and SO2 on sepiolite using molecular dynamics simulations4
High catalytic performance of Fe-rich palygorskite clay-supported Ni catalysts for steam reforming of toluene3
The Dispersion Stability of Bentonite in Water-in-oil Emulsions3
Influence of solid–liquid compositions and contact time during maturation on the properties of artificial peloids for use in pelotherapy3
Preparation of phase-change microcapsules with illite as a filler and their applications in foaming materials3
Dr Ian Wilson, 1943–20233
Iron mining waste as a sustainable material for producing bricks: microstructure, mechanical and thermal properties3
Hydration of alkali and alkaline-earth montmorillonites: an experimental comparative study from X-ray diffraction, water sorption isotherms and mid-infrared spectroscopy3
Molecular simulation of the adsorption of the hydration inhibitor N1,N1’-(ethane-1,2-diethyl)bis(N1-(2-aminoethyl)ethane-1,2-diamine onto montmorillonite3
Maria Pilar Mata Campo3
HotBENT experiment on quality control of bentonites used for granular bentonite material backfilling and block production3
Compressed earthen blocks using alluvial clays from Mbam: performance comparison using statistical analysis of cement vs heat-stabilized blocks3
Molecular dynamics simulation of dodecyl dimethyl benzyl ammonium cation-intercalated montmorillonite3
Effects of the hydrophilic–lipophilic balance of inorganic nanoparticles on the properties of a non-aqueous drilling fluid with organo-palygorskite3
Residual and sedimentary clays from Santa Maria (Azores, Portugal): preliminary assessment as ceramic raw materials3
The implications of Fe speciation for the humic substance stability of ternary Fe(III)–montmorillonite–humic substance systems3
Theoretical analysis of the effect of doping with Na(I), K(I), Mg(II), Ca(II) and Fe(II) on the electronic and mechanical properties of pyrophyllite3
Characterization and drug release of benzalkonium chloride-loaded organo-palygorskite or organo-montmorillonite2
Synthesis of nano-metakaolin using mechanical activation: effects of various parameters on the activated material properties2
Chlorhexidine acetate adsorption onto halloysite nanotubes from liquid media and in vitro antimicrobial activity2
Prospecting and characterization of plastic clays from the state of São Paulo, Brazil, as raw materials for porcelain stoneware tile production2
Iron removal from kaolin by oxalic acid using a novel pre-agitating and high-pressure washing technique2
Dispersant-assisted rotating liquid film reactor separation strategy for low-grade palygorskite purification with improved dye absorption performance2
Origin and distribution of clay minerals in semi-arid Sahelian soils: case of Kori Ouallam watershed, south-western Niger2
Investigation of iron/bentonite interaction based on powdered mixtures2
Generalized relationships between the ionic radii of octahedral cations and the b crystallographic parameter of clays and related minerals2
CLM volume 57 issue 3-4 Cover and Back matter2
Rheological properties of magnesium bentonite and sepiolite suspensions after dynamic ageing at high temperatures2
Sustainable approach to raw clays for ceramic and refractory applications: insights from updated traditional ternary diagrams1
Eco-friendly hybrid materials made from Tunisian clay and natural flowers1
CLM volume 57 issue 2 Cover and Front matter1
Simple and efficient: performance of palladium-loaded sepiolite for electrocatalytic ethanol oxidation1
Characteristic changes of calcined clay minerals as heavy metal adsorbents1
Characterization of refractory bricks from selected Cameroonian kaolins1
Differential dissolution of interlayer, octahedral and tetrahedral cations of vermiculite in oxalic acid1
The effect of different exchangeable cations on the CO2 adsorption capacity of Laponite RD®1
Influence of zirconia on the sintering behaviour and mechanical properties of reaction-sintered mullite-based composite ceramics1
Micro-column testing of the dynamic adsorption of Pb by Fe-Mg clay–quartz beds1
Characteristics of the raw materials of glazed tile bodies in the southern area of the Bao'ensi site, Nanjing, China1
Robert Michael Sumner Perrin, 1921–20231
Magnetic sepiolite/iron(III) oxide composite for the adsorption of lead(II) ions from aqueous solutions1
Characterization and distribution of clay minerals in the soils of Fildes Peninsula and Ardley Island (King George Island, Maritime Antarctica)1
Geometry optimization of an electrochemical reactor for bleaching kaolin1
Molecular dynamics modelling of Na-montmorillonite subjected to uniaxial compression and unidirectional shearing1
Facile preparation of sepiolite-based composites and their antibacterial/rheological properties1
Transforming environmental waste into valuable resources: characterization of clayey sludge from aggregate quarries for sustainable traditional ceramics1
Photon-shielding properties of alkali- and acid-treated Philippine natural zeolite1
Formation of iron-rich phyllosilicates in the FeO–SiO2–H2O system during hydrothermal synthesis as a function of pH1
The beneficiation of the Pütürge pyrophyllite ore by flotation: mineralogical and chemical evaluation1
Ternary geopolymer with calcined halloysite: impact on mechanical properties and microstructure1
The kinetics and mechanisms of using cationic surfactants to reduce the dissolution of clay minerals1
0.10149812698364