OOIR: Observatory of International Research

Papers

(The TQCC of Anti-Corrosion Methods and Materials is 6. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-06-01 to 2026-06-01.)

Article	Citations
Corrosion behavior of Al/TiO₂/Y₂O₃hybrid nanocomposites manufactured using the vacuum-assisted stir casting route	40
Numerical simulation and validation of the topological deformation of the corrosion interface based on the conservative level set method	34
Effect of trace Mg addition on the in vitro degradation behavior and biocompatibility of biodegradable Zn-Mn alloys	30
Synthesis and characterization of quinoxalinone-based heterocycles for corrosion inhibition: electrochemical, spectroscopic, and microscopic studies with theoretical analysis	27
Corrosion monitoring method of 304 stainless steel in a simulated marine–industrial atmospheric environment: electrochemical noise method	23
Corrosion behavior of TiC/amorphous carbon coated stainless steel as bipolar plate for proton exchange membrane fuel cell	22
Local electrochemical corrosion performance of nano-SiC/MAO composite coating on 6061-Al alloy	21
Research on the corrosion resistance and the passive film growth of Ni-based superalloy surface treated by ultrasonic impact	20
Improvement of the anticorrosion ability of an inhibitor pigmented epoxy coating with hierarchical porous ZnO microspheres loaded with mimosa tannin	20
Effect of alloying element doping on hydrogen adsorption and corrosion behavior of Fe2O3 (001) via high throughput method	20
Investigation on the influence of corrosion inhibitor concentrations on top-of-the-line corrosion	20
Development and experimental verification of innovative corrosion protection epoxy coatings for steel	19
Effects of magnetic field on the anodic dissolution of alloy 690 in NaCl + Na₂S₂O₃ solution	19
The influence of rolling on the corrosion and wear resistance of the MAO coating on ZM5 alloy	19
Effects of agitation on the tribo-electrochemical behavior of AISI 304 stainless steel in sulfuric acid	19
Effect of Al11Ce3 phase on the mechanical and corrosion properties of Al-Ce-8Mg alloys	17
Study of citrate gold plating by different pulse modes with and without vibration	16
Corrosion mechanism of TA2/Q345B composite plate in marine solution	15
Influence of technological synthesis conditions on corrosion behaviour and mechanical properties for NiTi alloys	13
Corrosion resistance of MWCNTs-nanoZnO composite reinforced chromium-free Zn-Al coating	13
Model reduction method for the performance of the anticorrosion of zinc-rich epoxy coating based on optimization technique	12
Adenine-based ionic liquid as an inhibitor for 316L stainless steel corrosion in simulated industrial cooling water: experimental and theoretical investigations	12
Study on regional different erosion–corrosion behavior and mechanism of Ni1725–W x C laser clad coating under high temperature and pressure environment	12
Investigation on intergranular corrosion susceptibility of a nitrogen-containing austenitic stainless steel QN2109 by optimized DL-EPR tests	11
An epoxy resin-based superhydrophobic coating incorporating pH-responsive functional multiwall carbon nanotubes assembled L-proline for corrosion protection	11

Mechanistic study of the atmospheric corrosion of BC550 weathering steel in simulated marine environments by in-situ electrochemical noise	11
Recent progress of self-healing polyaniline organic composite coatings: active agents, methods and protection mechanism	11
A hydrogen collecting and electrochemical synchronous measurement for studying galvanic corrosion behavior of AZ91D magnesium alloy	11
Probing the effect of microstructural difference of AZ91D magnesium alloys on the corrosion resistance of phosphate conversion coatings	11
A novel corrosion inhibitor based on a Schiff base for mild steel in 1M HCl: synthesis and anticorrosion study	11
Qualitative study on the corrosion behavior of Mg-Sn-Al-Zn alloys with different Sn contents by hot extrusion	11
Optimizing corrosion resistance of extruded Mg-Er alloys by regulating second phase and corrosion products	11
Construction of superhydrophobic film on the titanium alloy welded joint and its corrosion resistance study	10
The preparation and corrosion resistance of superhydrophobic coating on Cu plate via two-step electrodeposition	10
Corrosion of X80 steel in the co-existence of sulfate reducing bacteria and permeating hydrogen	10
Development of melon shell bio-waste particles reinforced 6063 aluminium alloy for lightweight automobile applications	10
The effect of resin curing type on the interfacial compatibility between coating and substrate	10
Crevice corrosion behavior and mechanism of laser additive manufacturing nickel-based alloy under wedge-shaped crevice by using wire beam electrode	10
The Failure Characteristics and Mechanical Interaction of YSZ TBC Fabricated via APS under Extreme Temperature Conditions	10
Study on the screening of marine beneficial bacteria and the inhibition of sulfate-reducing bacteria corrosion in marine oil field produced water	10
Response surface methodology and experimental evaluation of the inhibitory properties of corn leaf extract for aluminum corrosion in acid media	9
Self-healing and self-reporting behavior of epoxy coating with BTA+APhen@MSN on carbon steel	9
Study on the influence of temperature and water content on soil resistivity and the corrosion behavior of Q235 steel in Tibet	9
Structure and protective effect of aluminium coated Nd-Fe-B magnets before and after grain boundary diffusion	9
Welding image defect detection based on YOLO11	9
The preparation of a hydrochromic film and its application in the visualization of localized corrosion	9
Data-driven numerical simulation and evaluation methods for mechanical properties of corroded high-strength steel wire for bridge cable structure	9
Effect of glucose on corrosion fatigue behavior and crack propagation mechanism of Mg-xGa alloys in simulated body fluid	8
Photocathodic protection of oxide films formed on 304 stainless steel by high temperature oxidation	8
Effect of cerium content on passive film stability and pitting corrosion of super austenitic stainless steel in hypersaline seawater	8
Cold rolling and annealing-induced structural and corrosion modifications in (FeCoNi)75Cu10Cr15 high-entropy alloy	8
The effect of hydrogen fugacity on the hydrogen embrittlement sensitivity and hydrogen-induced cracking of X60 pipeline steel	8
Simulation calculation and experimental study of cathodic protection potential distribution in the tank farm	8
Surface inhomogeneity study of carbon steel with GO-doped epoxy coatings using integrated SEM-SVET-LEIS methodology	8
The microstructure and corrosion behavior of Cr-containing ferrite-pearlite steels in an acidic environment	8
Corrosion and protection of friction stir welding of magnesium alloy	8
Corrosion behavior of oil-grade nickel-based alloy 718 in H2S/CO2 environment: influence of H2S partial pressure	8
Research on the corrosion behavior of the 1050A aluminum alloy under various simulated atmospheric	8
Evaluation of the electrochemical properties of chitosan/SrCl2/MgO hydroxyapatite coating via electrophoretic deposition for improving corrosion resistance of stainless steel 316L in synthetic biologi	8
Corrosion behavior of aluminum alloys in harsh marine atmospheric environment	8
Influence of dysprosium addition on corrosion behavior of NdFeB magnets	8
An investigation on high temperature corrosion behavior of FeCr0.5NiCu0.5 high-entropy alloy in waste incineration environments	8
Synergistic effect study on Cl− and SO42− for 2Cr13 used in a low-pressure cylinder of steam turbines at peaking unit	7
Effect of electric-arc-induced ablation on corrosion behavior of pipeline steel under high-voltage direct current interference	7
Study on numerical calculation method of corrosion mechanism for Co-12 laser cladding layer	7
An improved method for a precise and rapid evaluation of intergranular corrosion susceptibility of 5083 aluminum alloy	7
A superior organic anticorrosion coating based on p-toluenesulfonate-doped polypyrrole to boost oxide film formation on aluminum substrates	7
Role of Ni in improving corrosion resistance by comparing the corrosion behavior of 316L and SUS430 in concentrated NaOH solution	7
Experimental studies on the corrosion inhibition of API 5L Gr B steel by four bis-DABCOnium salts in sulfuric acid solution	7
Research advances on superhydrophobic coating for metal surfaces via one-step electrodeposition	7
The study on corrosion behavior of X90 pipeline steel under marine alternating dry/wet environment	7
Influence of solution acidification on corrosion behavior of 316L SS in simulated crevice environment	7
A case study: anti-corrosion performances of plasma sprayed AT13 coatings on CrZrCu thin wall cylinder with adjusted parameters for controlling deformation	7
A comparative study on the corrosion behavior of Q235 steel in saturated acidic red and yellow soils	7
Effect of tempering time on the microstructure and corrosion resistance of carbon steel/stainless steel bimetallic composites	7

Photocathodic protection of ZnIn2S4/α-Fe2O3 film formed on carbon steel	6
Screening and performance study of corrosion inhibitors in Cu-Ag ions sterilization system of central air conditioning circulating cooling water	6
Load-induced instability in tribocorrosion: contrasting behaviors of passive and non-passive steels in artificial seawater	6
Investigations on classifiers for cathodically protected reinforced concrete structures	6
Analysis of inhibitory properties of neodymium tartrate and comparison with neodymium chloride for mild steel in neutral sodium chloride solution	6
Electrochemical optimization of soil corrosion map with machine learning	6
The corrosion analysis of X80 pipeline steel welded joint using wire beam electrode and numerical simulation methods	6
Corrosion behavior of carbon steel in formate-based completion fluids saturated with supercritical CO2	6
Effect of microstructure on hydrogen trapping behavior and hydrogen embrittlement sensitivity of medium manganese steel	6
New understanding on the critical factors determining stability of passive film on Fe-Cr alloy based on aberration-corrected TEM study	6
Barrier coating of super hydrophobically modified nano zirconia on copper: study of electrochemical anti-corrosion properties	6
Advanced superhydrophobic and wear-resistant coatings on carbon steel	6
Microstructure feature and wear mechanism of laser-clad TC4 and TC4-WC coating	6
Review of the application of digital holography in corrosion studies	6
Effect of Ti and C addition on oxidation resistance of FeCoCrNiMn high entropy alloys prepared by powder metallurgy	6
Aging-driven TiO2 oxide formation and its impact on the corrosion resistance of NiTi alloy developed by powder metallurgy	6